Genie WAHD324H Manuel utilisateur
Quick Start Guide
Please read these instructions carefully before operating the unit
and keep for further reference.
32 Channel 4-in-1 High
Definition DVR with 4HDD Bays
WAHD324H
ii
Intro Section
Please read this instruction carefully before operating the product and keep it for further
reference. All examples and pictures used here are for reference only.
The contents of this manual are subject to change without notice.
CAUTION:
• Please check the device and the accessories after getting the device. If there are any
damages, shortages or defects, please contact your dealer immediately.
Contents
iii
1.0 Introduction..........................................................................................................4
1.1 Product Features...........................................................................................4
1.2 Product Dimensions.....................................................................................4
1.3 Specification.................................................................................................5
2.0 HDD Installation...................................................................................................6
3.0 Rear Panel Instruction..........................................................................................7
4.0 Start Up and Shut Down......................................................................................8
5.0 Login ....................................................................................................................9
6.0 Configurations and Connections ........................................................................10
6.1 Ananlogue Camera Connection...................................................................10
6.2 Network Configuration & Adding IP Camera..............................................10
7.0 UPnP .....................................................................................................................12
8.0 NAT.......................................................................................................................13
9.0 Manual Recording and Playback .........................................................................14
9.1 Manual Recording.........................................................................................14
9.2 Playback.......................................................................................................14
4
The Genie WAHD324H is a 32 channel 1080p H.264 high definition DVR. The DVR supports
32 channel video input, 4 channel audio input and 16 channel simultaneous playback. It is
iPhone and Android compatible with an app (Super Live Plus) available with free Windows
/ MAC CMS software supplied.
1.1 Product Features
• 32 CH TVI / CVI / AHD video input
• 32 CH 1080p / 1080p Lite / 720p / WD1 recording
• H.264 high profile compression format for high quality video at much lower bit rate
• Intuitive and user friendly graphics user interface (GUI), window style operation by
• mouse
• Multi-mode recording: Manual / Timer / Motion
• Playback : 16 CH simultaneous playback
• Search: Time slice, Time, Event (Manual, Motion), Tag Search
• Express and flexible backup via USB, network etc.
• Pentaplex : Preview, Record, Playback, Backup and Remote Access
• DHCP, DDNS, PPPoE Network Protocol, IE browser and CMS supported
• Remote control via Web or CMS : Preview, Playback, Backup, PTZ and Configuration
• Dual stream technology for local storage with high definition, remote network
transmission and remote surveillance with mobile device
• Multi-user online simultaneously
• P2P ready for hassle free remote access
• Authorisation management, log review and device status review
• Supports HDMI 1080P output, true high resolution display
• Supports PTZ preset and auto cruise, up to 255 presets and 8 cruises
• Supports NAT function and QR code scanning by mobile phone and iPad
• Powerful smart phone & iPad surveillance with iOS and Android OS
1.2 Product Dimensions
1.0 Introduction
440mm
390mm
70mm
Quick Start Guide 32 Channel 4-in-1 High Definition DVR with 4HDD Bays
5
1.3 Specification
Model WAHD324H
System OS Embedded Linux
CPU Cortex A9
Video
Input BNC x32
Output
HDMI x 1 : 1920×1080,
VGA x 1 : 1920×1080,
BNC x 1 : CVBS (Used as the main or spot output)
Resolution TVI / CVI / AHD 1080p, 720p, WD1 real-time
Compression H.264 / H.265
Audio
Input RCA x 4
Output RCA x1
Two-Way Audio Yes
Mobile Device OS iOS, Android
Storage HDD HDD : SATA x 4, Max. 6TB per HDD
Playback
Playback 16 CH
Search Time Slice / Time / Event / Tag Search
Smart Search Highlighted colour to display the camera record in a certain period of time, different
colours refers to different record events.
Function Play, Pause, FF, FB, Digital Zoom, etc.
Alarm
Mode Manual, Motion, Exception
Input 4
Output 1
Triggering Record, Snap, Preset, E-mail etc.
Network Interface RJ45 10M / 100M / 1000Mbps x 1
Protocol TCP / IP, PPPoE, DHCP, DNS, DDNS, UPnP, NTP, SMTP
Record
Resolution 1080p, 1080p Lite, 720p, WD1
Frame Rate
1080P : 12fps (PAL) / 15fps (NTSC)
1080P Lite / 720p
WD1 : 25fps (PAL) / 30fps (NTSC)
Bit Rate 768Kbps ~ 8Mbps
Mode Manual, Timer, Motion, Sensor
Remote
Monitoring
Immix Compatible with Immix via RTSP only (2-way audio not supported)
Sentinel Yes, Firmware 1.1.0 or later
Backup Local Backup USB stick, USB mobile HDD
Network Backup Yes
Port
RS485 RS485 × 1, connect to PTZ or keyboard
USB USB 2.0 × 1 (In the front panel),
USB 3.0 × 1 (In the rear panel)
Remote Controller Optional
Others
Power Supply ATX250W
Consumption ≤ 20W (Without HDD)
Working Environment -10~50°C, 10%~90% (Humidity)
Dimensions 440 × 390 × 70 mm
6
This series of the product supports 4 SATA hard drives. Please make sure that the device is
powered off before the installation. The pictures of the installation are only for reference.
1. Loosen the screws to open the cover.
2. Screw two screws into the holes of HDD but not don’t tighten them.
3. Turn over the machine and place the HDD with two screws onto the bottom of the
case. Then lock the screws according to the order of the marks.
4. Install the other three HDDs according to above-mentioned method.
5. Connect the power and data cables.
6. Install the cover back and fix it.
Note: Please check the inside structure of the device and make sure that the cables are
connected well before installing the cover back. Please format the HDD before using.
2.0 HDD Installation
7
The interfaces of the rear panel are for reference only.
3.0 Rear Panel Instruction
Name Description
VGA Connect to monitor
HDMI Connect to high definition display device
LAN Network port
USB Connect to USB storage device or USB mouse
ALARM IN Alarm input for connecting sensor
ALARM OUT Relay output, connect to external alarm
GND Ground
P/Z Connect to speed dome. Y is TX+,Z is TX
K/B Connect to keyboard. A is TX+,B is TX
AUDIO OUT Audio output
AUDIO IN Audio input
e-SATA Connect to HDD with e-SATA interface
8
Startup
1. Connect the monitor and the power.
2. The device will boot and the power indicator will display blue.
3. A wizard window will pop up.
Shutdown
Go to “Main Menu” and then select “Shutdown” icon. This will bring up a shutdown
window. The device will shut down by clicking “OK” button. Then disconnect the power.
4.0 Start Up and Shut Down
9
The default username is admin and the default password is 123456. You must configure the
wizard if you start the DVR for the first time and you may change the password when you
configure the wizard for the first time. You can skip the settings wizard next time.
Click “Start” and select “Login”. This will take you to see a login box. Enter the default
username and password you set. Then you will see the live image.
5.0 Login
10
6.1 Ananlogue Camera Connection
First connect the camera to the DVR.
Then go to Start → Settings → Camera→ Manage Camera → Camera Signal to checkmark the
video mode. Theactual signals input shall correspond to the video mode. Please refer to
the User Manual for details.
6.2 Network Configuration & Adding IP Camera
After you finish adding IP cameras, you can see the live images through the monitor of the
DVR. The following will mainly introduce how to add the IP cameras via LAN/WAN.
LAN
1. Set the network of the DVR. Go to Start → Settings → Network → TCP/IP. Enter IP
address, subnet mask, gateway, etc. If using DHCP, please enable DHCP in both the
DVR and the router.
2. Go to Start → Settings → Network → Port. Enter HTTP port (the default value is 80),
server port (the default port is 6036).
3. Click “Apply” to save the settings.
4. Go to Start → Settings → Camera → Add Camera. The DVR will automatically refresh the
cameras searched. The IPC which supports the Onvif protocol may be added manually.
If the IPC searched is not in the same local network as the DVR, you should select the
device and click to modify the IP address.
6.0 Configurations and Connections
Table des matières
Autres manuels Genie DVR
Genie
Genie EDVR-4 Manuel utilisateur
Genie
Genie WNVR832P5AI Manuel utilisateur
Genie
Genie WNVR416P5AI Manuel utilisateur
Genie
Genie WNVRN216P5 Manuel utilisateur
Genie
Genie WNVR432P5OAI Manuel utilisateur
Genie
Genie WNVRN18P5 Manuel utilisateur
Genie
Genie EDVRH-4 Manuel utilisateur
Genie
Genie WAHDN281A Manuel utilisateur
Genie
Genie WAHD2161A Manuel utilisateur
Genie
Genie BDVRH Manuel utilisateur
Genie
Genie WAHDN241A Manuel utilisateur
Genie
Genie BDVR-8 Manuel utilisateur
Genie
Genie WNVR8645 Manuel utilisateur
Genie
Genie WAHD841 Manuel utilisateur
Genie
Genie GDVRH-616 Manuel utilisateur
Genie
Genie WAHDN2161A Manuel utilisateur
Genie
Genie WNVRN14P5 Manuel utilisateur
Genie
Genie WHDSDI16 Manuel utilisateur
Genie
Genie C41W Manuel utilisateur
Genie
Genie 4CH Manuel utilisateur
