GENESIS INTERNATIONAL SHERLOCK Manuel utilisateur
SHERLOCK
FAIL-SAFE REMOTE ALARM AND STROBE
WITH PLUG IN TRANSFORMER
44-0359 SREMOTEALARM&STROBE 08-11-07
Kit Includes:
Remote Alarm and Strobe
9V DC, 500 mA Power Supply
(12 V DC from Sherlock Monitor can also be used)
OVERVIEW
The SHERLOCK FAIL SAFE REMOTE ALARM
WITH STROBE will alert the user to an alarm
condition. It is activated by opening up a self
looping dry contact signal. The unit has a built in
green “Pilot” light that is always lit to let the user
know the REMOTE ALARM WITH STROBE is
working properly. The remote alarm has a built-
in red LED and a 90 db buzzer to signal an alarm
condition. The unit is equipped with a test button
to insure the REMOTE ALARM WITH STROBE
is working properly and also a 30 minute alarm
silence button. After 30 minutes the buzzer will
be reactivated if the alarm condition still exists.
Ideal for of ce use. The REMOTE ALARM WITH
STROBE easily connects to any SHERLOCK
REFRIGERANT Monitor or any other normally
closed alarm contact.
The REMOTE ALARM WITH STROBE may be
placed up to 5000 feet from the signal source
using 18 Gauge twisted pair signal wire.
DIMENSIONS 5 1/8” x 5 3/8” x 5”
ENVIRONMENT NEMA 1 Indoor
10 to 120°F (-10 to 50° C)
POWER INPUT 9 VDC, 500mA
wall mounted transformer
SOUND OUTPUT 90db at 2 ft
FLASHING RATE 60 to 100 ashes/Min
BRIGHTNESS 60,000 Candle Power
LENS High Impact resistant, Acrylic
Blue Part # 88-0109
Red Part # 88-0532
Amber Part # 88-0535
TROUBLE SHOOTING GUIDE:
THE ALARM POWER LIGHT DOES NOT LIGHT
Check the power plug for 9V DC - 12V DC power and verify that the transformer has power. If the trans-
former has failed, Call Genesis Customer Service.
ALWAYS IN ALARM
Connect a wire across the input plug, the alarm should silence. If the alarm is silenced, the alarming circit is
open. If it does not silence when the circuit is closed, Call Genesis Customer Service.
WILL NOT ALARM
Disconnect the input plug, the alarm should activate because the alarm circuit is open. If the alarm does not
activate, Call Genesis Customer Service.
REMOTE ALARM WIRING DIAGRAM
44-0128 SREMOTEALARM 08-11-05
REMOTE ALARM
ALARM LOOP
9V - 12VDC
LINE OUT
LINE IN
SHERLOCK CONTACT NO
SHERLOCK CONTACT NC
REMOTE ALARM
ALARM LOOP
9V - 12VDC
LINE OUT
LINE IN
12VOLT POWER SUPPLY
+12V
0V (GND)
12VOLT POWER SUPPLY
+12V
0V (GND)
Table des matières
Autres manuels GENESIS INTERNATIONAL Système de sécurité
Manuels Système de sécurité populaires d'autres marques
EDM
EDM Solution 6+6 Wireless-AE Manuel utilisateur
Highway Safety Group
Highway Safety Group EA401 Manuel utilisateur
Siren
Siren LED GSM Manuel utilisateur
Detection Systems
Detection Systems 7090i Instructions de montage
Se-Kure Controls
Se-Kure Controls MicroMini SK-4841 Manuel utilisateur
Siemens
Siemens FDM273 Manuel utilisateur