GE GFDS170EH Manuel

GFDS170EH/175EH

GE®Series 7.5 Cu. Ft. Capacity Front Load Electric Dryer with Steam and Stainless Steel Drum

Specification Revised 10/15

For answers to your Monogram, GE Profile™ Series

or GE®Series appliance questions, visit our website

at geappliances.com or call GE Answer Center®

service, 800.626.2000.

Dimensions anD installation information (in inches)

exhaust options: 4-way via rear, right,

left and bottom.

circuit requirements: An individual,

properly grounded branch circuit, protected by

a 30-amp circuit breaker or a time-delay fuse,

is required.

note: Dryer wall outlet must be located within 36"

of service cord entry and accessible when dryer is

mounted in position.

installation information: For complete

information, see installation instructions packed

with your dryer.

27 33

39-3/8

4-3/8

5-3/8

electric Dryer rating

120V/240V 5600W, 24A, 60Hz

120V/208V 4400W, 22A, 60Hz

Listed by

Underwriters

Laboratories

GFDS170EH/175EH

GE®Series 7.5 Cu. Ft. Capacity Front Load Electric Dryer with Steam and Stainless Steel Drum

Specification Revised 10/15

For answers to your Monogram, GE Profile™ Series

or GE®Series appliance questions, visit our website

at geappliances.com or call GE Answer Center®

service, 800.626.2000.

3-1/2

24-7/8

50-5/8

39-3/8

special installation requirements:

stackeD installation:

Brackets for stacking dryer over washer are not included with

the dryer. Order part no. GEFLSTACK or part no. WE25X10018.

alcove or closet installation:

If your dryer is approved for installation in an alcove or closet, it will be

stated on a label on the dryer back.

The dryer MUST be exhausted to the outside.

Minimum clearances between dryer cabinet and adjacent walls or other

surfaces are: 0" either side, 3" front and rear.

Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52".

Closet doors must be louvered or otherwise ventilated and must contain a

minimum of 60 sq. in. of open area equally distributed. If this closet contains

both a washer and a dryer, doors must contain a minimum of 120 sq. in. of

open area equally distributed.

No other fuel-burning appliance shall be installed in the same closet with

a gas dryer.

Bathroom or BeDroom installation:

The dryer MUST be exhausted to the outdoors.

The installation must conform with the local codes, or in the absence of

local codes, with the National Electric Code and National Fuel Gas Code,

ANSI Z223 for gas dryers.

minimum clearance other than alcove or closet

installations:

Minimum clearances to combustible surfaces 0" both sides, 3" rear.

for more information on venting kits anD accessories,

please call 1-800-ge-cares.

Listed by

Underwriters

Laboratories

stackeD Dimensions

(in inches)

28-3/4

peDestal Dimensions

(in inches)

sBsD137hWW - White

This optional 13" pedestal raises

the door opening and height of

the washer or dryer. Feet on 13"

pedestal allow it to adjust to

13-3/8" height.

GFDS170EH/175EH

GE®Series 7.5 Cu. Ft. Capacity Front Load Electric Dryer with Steam and Stainless Steel Drum

Specification Revised 10/15

Dryer exhausting information –metal Duct only

For complete information, see installation instructions packed with your dryer.

Ducting materials: For best performance, this dryer should be vented with 4" diameter

all rigid metal exhaust duct. If rigid metal duct cannot be used, then UL-listed flexible metal

(semi-rigid) ducting can be used (Kit WX08X10077). In special installations, it may be necessary

to connect the dryer to the house vent using a flexible metal (foil-type) duct. A UL-listed flexible

metal (foil-type) duct may be used ONLY in installations where rigid metal or flexible metal (semi-

rigid) ducting cannot be used AND where a 4" diameter can be maintained throughout the entire

length of the transition duct. Please see installation instruction packed with your dryer for complete

instructions when using flexible metal (foil type) ducting.

exhaust length calculation:

1. Determine the number of 90° turns needed for your installation. If you exhaust

to the side or bottom of dryer, add one turn.

2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated

is shown in the table.

A turn of 45° or less may be ignored. Two 45° turns within the duct length

should be treated as a 90° elbow.

A turn over 45° should be treated as a 90° elbow.

Dryers must be exhausted to the outside.

caution: For personal safety do not terminate exhaust into a chimney, under any enclosed house

floor (crawl space), or into an attic, since the accumulated lint could create a fire hazard or moisture

could cause damage. Never terminate the exhaust into a common duct or plenum with a kitchen

exhaust, since the combination of lint and grease could create a fire hazard.

Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird nesting, etc.

The wall cap must also be located at least 12" above the ground or any other obstruction with the

opening pointed down.

for more information on venting kits anD accessories,

please call 1-800-ge-cares.

Listed by

Underwriters

Laboratories

Best performance

Domestic

dryer models

Maximum length of 4"

dia. rigid metal duct

Number

90°

turns

Exhaust hood type

opening

2-1/2"

opening

7.5 cu. ft.

capacity models

electric dryers

90 ft.

60 ft.

45 ft.

35 ft.

25 ft.

60 ft.

45 ft.

35 ft.

25 ft.

15 ft.

2-1/2

1-3/4

3-1/2

Electrical

Connection

Gas Pipe

Connection

GFDS170EH/175EH

GE®Series 7.5 Cu. Ft. Capacity Front Load Electric Dryer with Steam and Stainless Steel Drum

Specification Revised 10/15

features anD Benefits

Steam Refresh – Rejuvenate lightly worn clothes by getting rid of wrinkles and odors with this

convenient setting using the power of steam

Steam Dewrinkle – Stored or wrinkled clothes come out wrinkle-free with this helpful setting

that uses steam to refresh and dry a load of any size

HE Sensor Dry – Keep your clothes looking and feeling their best. Dual thermistors continually

monitor temperature with a sensor bar that measures moisture to prevent over-drying

Quick Dry – Quickly dries items and small loads for families on the go

Damp Dry – Allows you set an alert to remove select items for hang-drying or damp ironing

Stainless steel drum – Resists rust and helps protect clothes

Delay start – Set the dryer to begin cycles whenever it’s convenient for you

Bulky Bedding cycle – Dries larger items, such as comforters, blankets and jackets

Model GFDS170EHWW – White

Model GFDS175EHDG – Diamond Gray

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels GE Séchoir

Manuels Séchoir populaires d'autres marques

Bosch

Bosch WTA79200GB Manuel utilisateur

Amana

Amana W10233410A Manuel utilisateur

Miele

Miele TWH 780 WP Manuel utilisateur

Asko

Asko T760 Manuel utilisateur

Alliance Laundry Systems

Alliance Laundry Systems 25 Series Manuel utilisateur

Bosch

Bosch Logixx 10 WTB76556GB Fiche technique

STIEBEL ELTRON

STIEBEL ELTRON Ultronic S Mode d’emploi

Electrolux

Electrolux EW2H328R2 Manuel utilisateur

Beko

Beko DS8433RX1M Manuel utilisateur

Dawlance

Dawlance Spinner DS 6000 C Manuel utilisateur

Electrolux

Electrolux TP5080TW Manuel utilisateur

AEG

AEG TR838P4OB Manuel utilisateur

Indesit

Indesit IDV 75 Manuel utilisateur

Infiniton

Infiniton SD-DG85C Manuel utilisateur

BOMANN

BOMANN WT 5019 Manuel utilisateur

Alliance Laundry Systems

Alliance Laundry Systems TMB795C Manuel utilisateur

Asko

Asko T793C Manuel utilisateur

Kenmore

Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manuel utilisateur