GE DBVH512GF Manuel
DBVH512GF
GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer
Dimensions and Installation Information (in inches)
Gas Dryer Rating
120V 60Hz, 6A
Exhaust Options: B-way via rear,left, and bottom.
Circuit Requirements: An individual, properly grounded
branch circuit, protected by a 30-amp circuit breaker or
a time-delay fuse, is required.
Note: Dryer wall outlet must be located within 36"
of service cord entry and accessible when dryer is
mounted in position.
Installation Information: Forcomplete information, see
installation instructions packed with your dryer.
, 27
°:!!
31-1/8 1-5/8
t
41-1/2
For answers to your Monogram,®GE ProfileTM or
GE® appliance questions, visit our website at
ge.com or call GEAnswer Center ®service,
800.626.2000.
_ imagination atwork
Listedby
Underwriters
Laboratories
Specification Revised 3/06 360456
DBVH512GF
GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer
Special Installation Requirements:
Stacked Installation:
• Brackets for stacking dryer over washer are included with the washer.
Alcove or Closet Installation:
• If your dryer is approved for installation in an alcove orcloset, it will be
stated on a label on the dryer back.
• The dryer MUSTbe exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other
surfaces are: 0" either side,3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings,etc. is 52".
• Closetdoors must be Iouvered or otherwise ventilated and must contain a
minimum of 60 sq. in.of open area equally distributed. If this closet contains
both a washer and a dryer, doors must contain a minimum of 120 sq. in.of
open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with
a gas dryer.
Bathroom or Bedroom Installation:
• The dryer MUSTbe exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of
local codes,with the National FuelGas Code,ANSIZ223.
Minimum Clearance other than Alcove or Closet Installations:
• Minimum clearances to combustible surfaces 0" both sides,3" rear,
For more information on venting kits and accessories,
please call 1-800-GE-CARES.
For answers to your ivionogram2 GEProfild" or
GE® appliance questions, visit our website at
ge.com or call GEAnswer Center ®service,
800.626,2000.
Stacked Dimensions (in inches)
Pedestal Dimensions (in inches)
SBSD227FWW- white
SBSD227FGG- granite
This optional 13-3/8" pedestal
raisesthe door opening and
height of the washer or dryer.
13-3/8
_1_28.3/4 /
imagination at work
Listedby
Underwriters
Laboratories
Specification Revised 3106 360456
DBVH512GF
GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer
Drger Exhausting Information - Metal Duct Onlg
Forcomplete information, seeinstallation instructions packed with Four drFen
Ducting Materials: For best performance, this dryer should be vented with 4" diameter all
rigid metal exhaust duct. If "all rigid metal" duct cannot be used, then "flexible all metal"
venting can be used,but it will reduce the maximum recommended duct length.
Exhaust Length Calculation:
1 Determine the number of 90° turns needed for gour installation. If gou exhaust to the
sideor bottom of drger, add one turn.
2. The maximum length of 4' rigid (aluminum or galvanized) duct which can be tolerated is
shown in the table. Themaximum length for flexible ducts are lessthan for rigid duct.
Aturn of 45° or lessmag be ignored. Two 45° turns within the duct length should be
treated as a 90°elbow.
Aturn over 45°should be treated asa 90° elbow.
Exhausting the drger to the outside isstronglg recommended to prevent largeamounts
of moisture and lint from being blown into the room, Gasdrgers or any drger located in a
closet must be exhausted to the outside.
Caution: Forpersonal safety do not terminate exhaust into a chimney, under ang enclosed
house floor (crawl space),or into an attic, since the accumulated lint could create a fire
hazard or moisture could cause damage. Neverterminate the exhaust into a common duct
or plenum with a kitchen exhaust, since the combination of lint and grease could create a
fire hazard.
Exhaust ducts should be terminated in a dampered wall cap to prevent back drafts, bird
nesting, etc.The wall cap must also be located at least 12" above the ground or ang other
obstruction with the opening pointed Down.
Other terminations, such as Iouvered wall boxes,are acceptable provided theg are
equivalent to a 4" opening dampered wall cap.
For more information on venting kits and accessories, please call 1-800-GE-CARES.
Front Loading
Dryers
Number
of
90°
Turns
o
1
2
3
Best Performance
Maximum Length
of 4" Dia.
Rigid Metal Duct
Exhaust Hood Type
B
A 2-1/2"
4" Opening Opening
90 ft. 60 ft.
60 ft. 45 ft.
45 ft. 35 ft.
35 ft. 25 ft.
Haximum Length
of 4" Dia.
Flexible Metal Duct
Exhaust Hood Tgpe
B
A 2-i/2"
4" Opening Opening
55 ft. 45 ft.
40 ft. 30 ft.
30 ft. 20 ft.
20 ft. 15 ft.
imagination atwork
Listedby
Underwriters
Laboratories
Specification Revised 3106 360456
DBVH512GF
GE®7.0Cu. Ft.Super Capacity Frontload Gas Dryer
Features and Benefits
• 7.0 cu, ft, king-size capacity - Large enough to handle anything the washer
sends its way
• Sensor Dry Plus - Continually monitors moisture levels to help clothes look
better longer
• Dewrinkle Cycle - Tumbles clothes without heat to help reduce creasing and wrinkling
• 5 heat selections - Offer enhanced drying performance and fabric care
• Rotary electronic controls with LEDindicators - Hake it simple to select and monitor
wash cycles
• Deluxe dryer rack - Allows tumble-free drying of items like sneakers
and stuffed animals
• Custom cycles - Saves your favorite dry settings for one-touch recall
• Adjustable end-of-cycle signal - Alerts you when cycle is done, saving time
between loads
• q)uietDrum TM design - Additional sound-dampening materials minimize tumbling noise
• Removable lint filter with reminder light - Reminds you to clean the easy-to-reach
upfront filter
• Speed Dry - Delivers ready-to-go results in minutes
• Hultiple dry cycles - Deliver optimal drying results
• Dual thermistors - Combined with sensor bars, these help maintain consistent
heat and ensure the right level of dryness is reached
• Hodel DBVH512GFWW - White on white
• Model DBVHB12GFGG- Granite gray
(_ imagination at work Specification Revised 3106 360456
Autres manuels pour DBVH512GF
1
Ce manuel convient aux modèles suivants
2
Autres manuels GE Séchoir
GE
GE DPXQ473ET Manuel utilisateur
GE
GE DBLR333ET Manuel utilisateur
GE
GE Appliances GFDN120 Manuel utilisateur
GE
GE DWSR483GG Manuel
GE
GE Profile DPVH890EJ Manuel de service
GE
GE GFDS150EDWW Manuel utilisateur
GE
GE GTD72GBMNWS Manuel utilisateur
GE
GE DBSR463EG Manuel
GE
GE DCVH680GJBB - 27-in Gas Dryer Manuel
GE
GE DBVH520EJ Manuel utilisateur
GE
GE GFD45 Manuel utilisateur
GE
GE GTX65GBSJWS Manuel
GE
GE DLSR483EG Manuel
GE
GE DBVH512GF Manuel
GE
GE Profile DPVH890GJ Manuel
GE
GE Profile DPSB620 Manuel utilisateur
GE
GE DWXR483GG Manuel
GE
GE DPSE592GA1AA Manuel utilisateur
GE
GE GFDR480 Instructions originales
GE
GE Spacemaker DSXH47 Instructions originales
Manuels Séchoir populaires d'autres marques
Indesit
Indesit IDV 75 Manuel utilisateur
Infiniton
Infiniton SD-DG85C Manuel utilisateur
BOMANN
BOMANN WT 5019 Manuel utilisateur
Alliance Laundry Systems
Alliance Laundry Systems TMB795C Manuel utilisateur
Asko
Asko T793C Manuel utilisateur
Kenmore
Kenmore 8041 - 5.8 cu. Ft. Capacity Electric Dryer Manuel utilisateur