GE 28301 Manuel utilisateur
Model 28301
2 in 1 - Internet Phone
Additional Handset
User’s Guide
2
Equipment Approval Information
Your telephone equipment is approved for connection to the Public Switched
Telephone Network and is in compliance with parts 15 and 68, FCC Rules and
Regulations and the Technical Requirements for Telephone Terminal Equipment
published by ACTA.
1 Notification to the Local Telephone Company
On the bottom of this equipment is a label indicating, among other
information, the US number and Ringer Equivalence Number (REN) for
the equipment. You must, upon request, provide this information to your
telephone company.
The REN is useful in determining the number of devices you may connect
to your telephone line and still have all of these devices ring when your
telephone number is called. In most (but not all) areas, the sum of the RENs
of all devices connected to one line should not exceed 5. To be certain of the
number of devices you may connect to your line as determined by the REN,
you should contact your local telephone company.
A plug and jack used to connect this equipment to the premises wiring
and telephone network must comply with the applicable FCC Part 68 rules
and requirements adopted by the ACTA. A compliant telephone cord and
modular plug is provided with this product. It is designed to be connected
to a compatible modular jack that is also compliant. See installation
instructions for details.
US Number is located on the cabinet bottom.
REN Number is located on the cabinet bottom.
Notes
• This equipment may not be used on coin service provided by the telephone
company.
• Party lines are subject to state tariffs, and therefore, you may not be able to
use your own telephone equipment if you are on a party line. Check with your
local telephone company.
• Notice must be given to the telephone company upon permanent
disconnection of your telephone from your line.
• If your home has specially wired alarm equipment connected to the
telephone line, ensure the installation of this product does not disable your
3
alarm equipment. If you have questions about what will disable alarm
equipment, consult your telephone company or a qualified installer.
2 Rights of the Telephone Company
Should your equipment cause trouble on your line which may harm the
telephone network, the telephone company shall, where practicable, notify
you that temporary discontinuance of service may be required. Where prior
notice is not practicable and the circumstances warrant such action, the
telephone company may temporarily discontinue service immediately. In
case of such temporary discontinuance, the telephone company must: (1)
promptly notify you of such temporary discontinuance; (2) afford you the
opportunity to correct the situation; and (3) inform you of your right to bring
a complaint to the Commission pursuant to procedures set forth in Subpart
E of Part 68, FCC Rules and Regulations.
The telephone company may make changes in its communications facilities,
equipment, operations or procedures where such action is required in
the operation of its business and not inconsistent with FCC Rules and
Regulations. If these changes are expected to affect the use or performance
of your telephone equipment, the telephone company must give you
adequate notice, in writing, to allow you to maintain uninterrupted service.
Interference Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference;
and (2) This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
Privacy of Communications may not be ensured when using this product.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
4
• Reorient or relocate the receiving antenna (that is, the antenna for radio or
television that is “receiving” the interference).
• Reorient or relocate and increase the separation between the
telecommunications equipment and receiving antenna.
• Connect the telecommunications equipment into an outlet on a circuit
different from that to which the receiving antenna is connected.
If these measures do not eliminate the interference, please consult your dealer
or an experienced radio/television technician for additional suggestions. Also, the
Federal Communications Commission has prepared a helpful booklet, “How To
Identify and Resolve Radio/TV Interference Problems.” This booklet is available
from the U.S. Government Printing Office, Washington, D.C. 20402. Please specify
stock number 004-000-00345-4 when ordering copies.
Notice: The changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
Hearing Aid Compatibility (HAC)
This telephone system meets FCC standards for Hearing Aid Compatibility.
Licensing
Licensed under US Patent 6,427,009.
FCC RF Radiation Exposure
Statement
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20 centimeters between the radiator and your
body. This transmitter must not be co-located or operated in conjunction with
any other antenna or transmitter.”
For body worn operation, this phone has been tested and meets the FCC RF
exposure guidelines when used with the belt clip supplied with this product.
Use of other accessories may not ensure compliance with FCC RF exposure
guidelines.
Information for DECT Product
This 28301 telephone is compliant with the DECT 6.0
standard which operates in the 1.92GHz to 1.93GHz
frequency range.
5
Table of Contents
EquipmEnt ApprovAl informAtion 2
intErfErEncE informAtion........... 3
HEAring Aid compAtibility (HAc)4
licEnsing ................................... 4
fcc rf rAdiAtion ExposurE
stAtEmEnt.......................... 4
informAtion for dEct product 4
tAblE of contEnts ..................... 5
introduction ............................. 6
bEforE you bEgin ...................... 6
Parts CheCklist ........................... 6
instAllAtion ............................... 7
Digital seCurity system ............. 7
imPortant installguiDelines...... 7
HAndsEt lAyout ......................... 8
instAlling tHE pHonE.................. 9
installing the hanDset Battery 9
hanDset Charge CraDle..........10
tElEpHonE opErAtion ............... 10
Power on/off oPeration.......10
registration ...............................10
Deregistration ...........................11
seleCt Base ................................12
Default setting .........................12
cHAnging tHE bAttEry .............. 13
bAttEry sAfEty prEcAutions ..... 13
troublEsHooting guidE............ 14
telePhone solutions ...........14
Caller iD solutions............16
skyPe solutions....................17
Battery solutions................18
gEnErAl product cArE ............ 18
cAusEs of poor rEcEption........ 19
sErvicE..................................... 19
limitEd WArrAnty.................... 20
indEx ....................................... 23
AccEssory informAtion ............ 24
SEE MARKING ON BOTTOM / BACK OF PRODUCT
RISKOFELECTRICSHOCK
DONOTOPEN
WARNING: TO
PREVENT FIRE OR
ELECTRICAL SHOCK
HAZARD, DO NOT
EXPOSETHIS
PRODUCT TO RAIN
OR MOISTURE.
THE LIGHTNING
FLASH AND ARROW
HEAD WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
“DANGEROUS
VOLTAGE” INSIDE
THE PRODUCT.
CAUTION: TO REDUCE THE
RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR
BACK). NO USER
SERVICEABLE PARTS INSIDE.
REFER SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
THE EXCLAMATION
POINT WITHIN THE
TRIANGLE IS A
WARNING SIGN
ALERTING YOU OF
IMPORTANT
INSTRUCTIONS
ACCOMPANYING
THE PRODUCT.
CAUTION:
6
Introduction
CAUTION: When using telephone equipment,
there are basic safety instructions that
should always be followed. Refer to the
IMPORTANT SAFETY INSTRUCTIONS provided
with this product and save them for future
reference.
IMPORTANT: Because cordless phones operate
on electricity, you should have at least one
phone in your home that isn’t cordless, in case
the power in your home goes out.
Before You Begin
Parts Checklist
Make sure your package includes the items shown here.
Handset
charge cradle
Handset
AC power
adaptor
2 AAA
Nickel-metal
Hydride batteries
Battery
compartment
cover Belt clip
7
Installation
Digital Security System
Your cordless phone uses a digital security system to protect
against false ringing, unauthorized access, and charges to your
phone line.
INSTALLATION NOTE: This product operates at a
frequency of 1.9GHz. to provide communication
with minimal interference from other electronic
devices. To further minimize the possibility of
interference, the base of the cordless telephone
should not be placed near or on top of a
TV, microwave oven, or VCR. If interference
continues, move the cordless telephone further
away from these appliances.
Important Installation Guidelines
• Avoid sources of noise and heat, such as motors, fluorescent
lighting, microwave ovens, heating appliances and direct
sunlight.
• Avoid areas of excessive dust, moisture and low
temperature.
• Avoid other cordless telephones.
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
• Never touch non-insulated telephone wires or terminals,
unless the telephone line has been disconnected at the
network interface.
• Use caution when installing or modifying telephone lines.
8
Handset Layout
Soft Key Left
(SKL/ | )
(button)
display
speaker
(button)
#/PAUSE/lock
(button)
INT
(intercom button)
END CALL
(button)
REDIAL/flash
(button)
*
(button)
5/6Navigational
(button)
Landline (button)
[traditional call]
earpiece
Skype (button)
[computer call]
Soft Key Right
(SKR/ | )
(button)
microphone
9
Installing the Phone
Installing the Handset Battery
NOTE: You must connect the handset battery
before using the cordless handset(s).
CAUTION: To reduce the risk of fire or
personal injury, use only the Thomson Inc.
approved model GP80AAAHC - NiMH 1.2V
800mAh rechargeable Nickel-metal Hydride
battery, which is compatible with this unit.
1. Locate batteries and battery door which are packaged
together inside a plastic bag and are separate from the
handset.
2. Locate the battery compartment on the back of the handset.
3. Insert the batteries.
4. Close the battery compartment by pushing the door up until
it snaps into place.
10
Handset Charge Cradle
1. Choose an area near an electrical outlet and place your
cordless telephone on a level surface.
2. Plug the AC power converter into the electrical outlet and the
DC connector into the jack on the back of the cradle.
3. Place the handset in the cradle. The CHARGE indicator turns
on, verifying the battery is charging.
Allow handset to charge for 16 hours prior to first use. If you
do not properly charge the handset, battery performance is
compromised.
CAUTION: Use only the model 5-2718 power
adaptor that came with this unit. Using other
power adaptors may damage the unit.
Telephone Operation
Power On/Off Operation
The handset is powered on by connecting the battery or if the
handset has been powered down, press and hold the END CALL
button for 2 seconds.
To power off the handset, press and hold the END CALL button
for 2 seconds.
Note: If the handset is on the cradle, only the
(speaker) and END CALL buttons are functional.
Registration
YOU MUST REGISTER THE HANDSET TO THE MAIN BASE
BEFORE USE! It is not recommended that handset be
registered again unless absolutely necessary.
Autres manuels pour 28301
1
Ce manuel convient aux modèles suivants
1
Table des matières
Langues :
Autres manuels GE Téléphone sans fil
GE
GE 28041EE3 Manuel utilisateur
GE
GE 25880 Manuel utilisateur
GE
GE 27851FE1 Manuel utilisateur
GE
GE 27939 Manuel utilisateur
GE
GE 25841GE3 Manuel utilisateur
GE
GE 2-9910 Manuel utilisateur
GE
GE 15433020 Manuel utilisateur
GE
GE 15620020 Manuel utilisateur
GE
GE 28128xx3 Manuel utilisateur
GE
GE 25952XX2 Manuel utilisateur
GE
GE 25899 Manuel utilisateur
GE
GE 27930 Manuel utilisateur
GE
GE 2-9751 Manuel utilisateur
GE
GE 900 MHz Manuel utilisateur
GE
GE 3191 Manuel utilisateur
GE
GE 29385 Manuel utilisateur
GE
GE 25898 Manuel utilisateur
GE
GE 4236 Manuel utilisateur
GE
GE 25922 Series Manuel utilisateur
GE
GE 25836EE1 Manuel utilisateur
