GE 28301 Manuel utilisateur

Model 28301

2 in 1 - Internet Phone

Additional Handset

User’s Guide

Important Information

NOTICE: This product meets the applicable Industry Canada technical

speciﬁcations.

Operation is subject to the following two conditions: (1) This device may not

cause interference, and (2) This device must accept any interference, including

interference that may cause undesired operation of the device.

The equipment must be installed using an acceptable method of connection.

The customer should be aware that compliance with the above conditions may

not prevent degradation of service in some situations.

Repairs to certiﬁed equipment should be made by an authorized Canadian

maintenance facility designated by the supplier. Any repairs or alterations

made by the user to this equipment, or equipment malfunctions, may give the

telecommunications company cause to request the user to disconnect the

equipment.

Users should ensure for their own protection that the electrical ground

connections of the power utility, telephone lines and internal metallic water

pipe systems, if present, are connected together. This precaution may be

particularly important in rural areas.

CAUTION: Users should not attempt to make such connections themselves, but

should contact the appropriate electric inspection authority, or electrician, as

appropriate.

NOTES: This equipment may not be used on coin service provided by the

telephone company.

Interference Information

This equipment generates and uses radio frequency energy which may

interfere with residential radio and television reception if not properly

installed and used in accordance with instructions contained in this

manual. Reasonable protection against such interference is ensured,

although there is no guarantee this will not occur in a given installation. If

interference is suspected and veriﬁed by switching this equipment on and

off, the user is encouraged to try to correct the interference by one or more

of the following measures: Reorient the radio/television receiver’s antenna,

relocate the equipment with respect to the receiver, plug the equipment

and receiver into separate circuit outlets. The user may also wish to

consult a qualiﬁed radio/television technician for additional suggestions.

This equipment has been fully tested and complies with all limits for Class

B computing devices pursuant to part 15 FCC Rules and Regulations.

Telephone Network Information

Should your equipment cause trouble on your line which may harm the

telephone network, the telephone company, where practicable, may notify you

that temporary discontinuance of service may be required. Where prior notice

is not practicable and the circumstances warrant such action, the telephone

company may temporarily discontinue service immediately.

The telephone company may make changes in its communications facilities,

equipment, operations or procedures where such action is required in the

operation of its business. If these changes are expected to affect the use or

performance of your telephone equipment, the telephone company will likely

give you adequate notice to allow you to maintain uninterrupted service.

Notice must be given to the telephone company upon termination of your

telephone from your line.

REN Number

On the bottom of this equipment is a label indicating, among other information,

the Ringer Equivalence Number (REN) for the equipment.

The REN is useful in determining the number of devices you may connect to

your telephone line and still have all of these devices ring when your telephone

number is called. In most (but not all) areas, the sum of the RENs of all devices

connected to one line should not exceed 5. To be certain of the number of

devices you may connect to your line as determined by the REN, you should

contact your local telephone company.

REN Number is located on the cabinet bottom.

Hearing Aid Compatibility (HAC)

This telephone system meets FCC standards for Hearing Aid Compatibility.

Licensing

Licensed under US Patent 6,427,009.

FCC RF Radiation Exposure

Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated

with a minimum distance of 20 centimeters between the radiator and your

body. This transmitter must not be co-located or operated in conjunction with

any other antenna or transmitter.”

For body worn operation, this phone has been tested and meets the FCC RF

exposure guidelines when used with the belt clip supplied with this product.

Use of other accessories may not ensure compliance with FCC RF exposure

guidelines.

Information for DECT Product

This 28301 telephone is compliant with the DECT 6.0

standard which operates in the 1.92GHz to 1.93GHz

frequency range.

Table of Contents

Important InformatIon............... 2

Interference InformatIon........... 3

telephone network InformatIon 3

ren number ............................. 4

hearIng aId compatIbIlIty (hac)4

lIcensIng ................................... 4

fcc rf radIatIon exposure

statement.......................... 4

InformatIon for dect product 4

table of contents ..................... 5

IntroductIon ............................. 6

before you begIn ...................... 6

Parts CheCklist ........................... 6

InstallatIon ............................... 7

Digital seCurity system ............. 7

imPortant installguiDelines...... 7

handset layout ......................... 8

InstallIng the phone.................. 9

installing the hanDset Battery 9

hanDset Charge CraDle..........10

telephone operatIon ............... 10

Power on/off oPeration.......10

registration ...............................10

Deregistration ...........................11

seleCt Base ................................12

Default setting .........................12

changIng the battery .............. 13

battery safety precautIons ..... 13

troubleshootIng guIde............ 14

telePhone solutions ...........14

Caller iD solutions............16

skyPe solutions....................17

Battery solutions................18

general product care ............ 18

causes of poor receptIon........ 19

servIce..................................... 19

lImIted warranty.................... 20

Index ....................................... 23

SEE MARKING ON BOTTOM / BACK OF PRODUCT

RISKOFELECTRICSHOCK

DONOTOPEN

WARNING: TO

PREVENT FIRE OR

ELECTRICAL SHOCK

HAZARD, DO NOT

EXPOSETHIS

PRODUCT TO RAIN

OR MOISTURE.

THE LIGHTNING

FLASH AND ARROW

HEAD WITHIN THE

TRIANGLE IS A

WARNING SIGN

ALERTING YOU OF

“DANGEROUS

VOLTAGE” INSIDE

THE PRODUCT.

CAUTION: TO REDUCE THE

RISK OF ELECTRIC SHOCK, DO

NOT REMOVE COVER (OR

BACK). NO USER

SERVICEABLE PARTS INSIDE.

REFER SERVICING TO

QUALIFIED SERVICE

PERSONNEL.

THE EXCLAMATION

POINT WITHIN THE

TRIANGLE IS A

WARNING SIGN

ALERTING YOU OF

IMPORTANT

INSTRUCTIONS

ACCOMPANYING

THE PRODUCT.

CAUTION:

Introduction

CAUTION: When using telephone equipment,

there are basic safety instructions that

should always be followed. Refer to the

IMPORTANT SAFETY INSTRUCTIONS provided

with this product and save them for future

reference.

IMPORTANT: Because cordless phones operate

on electricity, you should have at least one

phone in your home that isn’t cordless, in case

the power in your home goes out.

Before You Begin

Parts Checklist

Make sure your package includes the items shown here.

Handset

charge cradle

Handset

AC power

adaptor

2 AAA

Nickel-metal

Hydride batteries

Battery

compartment

cover Belt clip

Installation

Digital Security System

Your cordless phone uses a digital security system to protect

against false ringing, unauthorized access, and charges to your

phone line.

INSTALLATION NOTE: This product operates at a

frequency of 1.9GHz. to provide communication

with minimal interference from other electronic

devices. To further minimize the possibility of

interference, the base of the cordless telephone

should not be placed near or on top of a

TV, microwave oven, or VCR. If interference

continues, move the cordless telephone further

away from these appliances.

Important Installation Guidelines

• Avoid sources of noise and heat, such as motors, ﬂuorescent

lighting, microwave ovens, heating appliances and direct

sunlight.

• Avoid areas of excessive dust, moisture and low

temperature.

• Avoid other cordless telephones.

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack

is speciﬁcally designed for wet locations.

• Never touch non-insulated telephone wires or terminals,

unless the telephone line has been disconnected at the

network interface.

• Use caution when installing or modifying telephone lines.

Handset Layout

Soft Key Left

(SKL/ | )

(button)

display

speaker

(button)

#/PAUSE/lock

(button)

INT

(intercom button)

END CALL

(button)

REDIAL/ﬂash

(button)

5/6Navigational

(button)

Landline (button)

[traditional call]

earpiece

Skype (button)

[computer call]

Soft Key Right

(SKR/ | )

(button)

microphone

Installing the Phone

Installing the Handset Battery

NOTE: You must connect the handset battery

before using the cordless handset(s).

CAUTION: To reduce the risk of ﬁre or

personal injury, use only the Thomson Inc.

approved model GP80AAAHC - NiMH 1.2V

800mAh rechargeable Nickel-metal Hydride

battery, which is compatible with this unit.

1. Locate batteries and battery door which are packaged

together inside a plastic bag and are separate from the

handset.

2. Locate the battery compartment on the back of the handset.

3. Insert the batteries.

4. Close the battery compartment by pushing the door up until

it snaps into place.

Handset Charge Cradle

1. Choose an area near an electrical outlet and place your

cordless telephone on a level surface.

2. Plug the AC power converter into the electrical outlet and the

DC connector into the jack on the back of the cradle.

3. Place the handset in the cradle. The CHARGE indicator turns

on, verifying the battery is charging.

Allow handset to charge for 16 hours prior to ﬁrst use. If you

do not properly charge the handset, battery performance is

compromised.

CAUTION: Use only the model 5-2718 power

adaptor that came with this unit. Using other

power adaptors may damage the unit.

Telephone Operation

Power On/Off Operation

The handset is powered on by connecting the battery or if the

handset has been powered down, press and hold the END CALL

button for 2 seconds.

To power off the handset, press and hold the END CALL button

for 2 seconds.

Note: If the handset is on the cradle, only the

(speaker) and END CALL buttons are functional.

Registration

YOU MUST REGISTER THE HANDSET TO THE MAIN BASE

BEFORE USE! It is not recommended that handset be

registered again unless absolutely necessary.

Autres manuels pour 28301

Ce manuel convient aux modèles suivants

Table des matières

Langues :

Manuels Téléphone sans fil populaires d'autres marques

3Com

3Com NBX Manuel utilisateur

Panasonic

Panasonic KX-TGK210HK Manuel utilisateur

Panasonic

Panasonic KX-TCA181EX Manuel utilisateur

BT FREESTYLE 3200 Manuel utilisateur

AT&T

AT&T CL84102 Manuel utilisateur

BREZZICNI

BREZZICNI CL-3622 Manuel utilisateur

Panasonic

Panasonic KX-TG1831NZ Manuel utilisateur

Panasonic

Panasonic KX-TG7301E Manuel utilisateur

Furuno

Furuno FM-4721 Manuel utilisateur

Sanyo

Sanyo CLT-J70 Manuel utilisateur

Amplicomms

Amplicomms BigTel 201 Manuel utilisateur

AT&T

AT&T E1812B Manuel utilisateur

Sanyo

Sanyo CLT-670 Manuel utilisateur

Curtis

Curtis TC595 Manuel utilisateur

Gigaset

Gigaset Gigaset 3000 Micro Manuel utilisateur

Poly

Poly VVX D230 Guide de configuration

AT&T

AT&T 7625 Manuel utilisateur

Panasonic

Panasonic KX-TGP700 Manuel utilisateur