INSTALLING THE CAMERA
In most instances, the camera is best mounted above the vehicles license plate as shown here.
!
!
!
!
INSTALLATION.!!
1. Connect the RED wire of the Cameras Power Harness to the wire that supplies power to
the reversing light globe (the wire that is energised only when the car is put into reverse).
Before making the electrical connection, temporarily disconnect the camera from the power
plug whilst making the connection to the back up light. Use a suitable splicing/crimp
connector (Scotch lock type) or strip connector. This connection can also be soldered,
making sure to insulate the joint with electrical insulation when done. The camera has only
one wire to connect (positive (+). There is no need to hook up a ground wire as the
camera gets its earth through the RCA lead. Hooking up the earth may cause a ground
loop. In this case Horizontal lines will appear in the image.
2. After you have insulated the join you can connect the power harness to the camera.
NOTE: Some cars that Run LED or Computer controlled lighting systems and may not
deliver enough voltage to run the camera. If the voltage at the reversing wire light is less
than +12 volts it may be necessary to use a relay to supply power to the transmitter
harness from the wiring in the front of the car. In this case the reversing light only needs to
trigger the relay. Make sure that you do not drill holes in the panels that have an opposite
face that is visible outside the car for example guard panels. In fact, whenever drilling holes
in the bodywork of a vehicle, always see what is on the other side.
3. Connect one end of the Supplied RCA Video lead to the RCA lead coming from the camera
then run the RCA lead to the front under side of the driver side dash board (This is were the
monitors loom will be located). To do this you will need to remove the rear seat to pass the
cable into the cabin area and you will need to remove the door scuff plates to run the wire
along the side of the vehicle. The RCA cable will be hidden when you replace the scuff
plates. When the cable is at the front of the vehicle the RCA cable needs to be run from the
scuff plate area to the under side of the dash behind the kick trim (Remove to run cable).
4. The monitor has two power wires to be connected. Connect the Red wire (Accessories
+12V) to a wire that is energised when the accessories position on the key is active (When
the radio is on) and the black wire to a ground wire or you can connect the back wire to the
body of the car using the steel of the cars body behind the kick trim as an earth. In this case
drill a small 1/8th hole and connect the wire using a suitable O-ring terminal. Scrape off the
cars paint around the hole to ensure a good earth.
5. Connect the RCA lead to the RCA Connector from the Monitors loom.
!
