Garrison 2477821 Manuel utilisateur
Thank you for purchasing our Portable Air Conditioner.
Portable Air Conditioner
(Local Air Conditioner)
Instruction Manual
Before using your air conditioner, please read this instruction manual carefully and keep it for future reference.
READ AND SAVE THESE INSTRUCTIONS!
Contents
1
Preparation
Safety Precautions
Cautions
Installation
Operation
Maintenance
Faults Diagnosis
Design and Compliance Notes
Sociable Remark
2
4
5
6
10
12
13
14
15
----------------------
------------------------
----------------------
------------------------
---------------------
------------------
------------------
----------------
-------
Preparation
RearFront
Control panel
Remote signal receptor
Handle
(both sides)
Horizontal louver control
lever(adjust manually)
NOTE: PHA cannot be
adjusted.
NOTE: PHA cannot be
adjusted.
Vertical louver control
lever(adjust manually)
Panel
Caster
Bottom tray
drain outlet
Air filter
(behind the grille)
Upper air intake
Air outlet
Lower air intake
Drain outlet
2
Preparation
NOTE: The unit you purchased may look like one of the following:
3
Safety Precautions
Please read these instructions before you start the installation
process. Improper installation can damage the unit and, your
personal property, and also poses a personal safety hazard.
-Installation must be performed according to the installation
instructions. Improper installation can cause water leakage,
electric shock, or fire.
-Use only the included accessories, parts, and specified
tools for the installation. Using non-standard parts can cause
water leakage, electric shock, fire, and injury or property
damage.
-Make sure that the outlet you are using is grounded and has
the appropriate voltage. The power cord is equipped with a
three-prong grounding plug to protect against shock. Voltage
information can be found on the side of the unit, behind the
grille.
-Install the unit on a flat, sturdy surface. Failure to do so
could result in damage or excessive noise and vibration.
-The unit must be kept free from obstruction to ensure proper
function and to mitigate safety hazards.
-DO NOT modify the length of the power cord or use an
extension cord to power the unit. DO NOT share a single
outlet with other electrical appliances. Improper power supply
can cause fire or electrical shock.
-DO NOT install your air conditioner in a wet room, such as
a bathroom or laundry room. Too much exposure to water
can cause electrical components to short circuit.
-DO NOT install the unit in a location that may be exposed
to combustible gas, as this could cause fire.
-The unit has wheels to facilitate moving. Make sure not to
use the wheels on thick carpet or to roll over objects, as
these could cause tipping.
-DO NOT operate a unit that has been dropped or damaged.
-Only use the included accessories and specified parts for
installation. Using non-standard parts can cause water
leakage, electric shock, fire, and injury or property damage.
-The unit must be kept free from obstruction to ensure proper
function.
-DO NOT allow children to play with the air conditioner.
Children must be supervised around the unit at all times.
- If the air conditioner is knocked over during use, turn off the
unit and unplug it from the main power supply immediately.
Visually inspect the unit to ensure there is no damage. If you
suspect the unit has been damaged, contact a technician or
customer service for assistance.
In a thunderstorm, the power must be cut off to avoid damage
to the machine due to lightning.
4
Cautions
-This appliance can be used by children ages 8 years or older and persons with reduced physical,
sensory, and/or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
(applicable for European countries)
-This appliance is not intended for use by persons (including childern) with reduced physical, sensory , and/or mental
capabilities or lack of experience and knowledge unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. (applicable for other countries
except those in Europe)
-Children should be supervised to ensure that they do not play with the appliance.
-If the supply cord is damaged, it must be replaced by the manufacturer,its service agent, or similarly qualified
persons in order to avoid a hazard.
-Prior to cleaning or other maintenance, the appliance must be disconnected from the supply mains.
-Do not install the appliance in a location that may be exposed to combustible gas.
-If combustible gas accumulates around the unit, it may cause fire.
-Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
-Do not operate unit with a damaged cord or plug. Discard unit or return to an authorized service facility for
examination and/or repair.
-To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
-The appliance shall be installed in accordance with national wiring regulations.
-Contact the authorized service technician for repair or maintenance of this unit.
-
Contact the authorized installer for installation of this unit.
-When there are wide differences between "USER' S MANUAL" and "Remote controller instruction" on function
description, the description on "USER' S MANUAL " shall prevail.
-Do not operate your air conditioner in a wet room, such as a bathroom or laundry room.
5
Installation
Choosing the Right Location
Your installation location should meet the following requirements:
-Make sure that you install your unit on an even surface to minimize
noise and vibration.
-The unit must be installed near a grounded plug, and the Collection
Tray Drain (found on the back of the unit) must be accessible.
-The unit should be located at least 30cm (12”) from the nearest wall
to ensure proper air conditioning.
-DO NOT cover the intakes, outlets, or remote signal receptor of the
unit, as this could cause damage to the unit.
Note About Fluorinated Gasses
-This air-conditioning unit is a hermetically
sealed unit that contains fluorinated gasses.
For specific information on the types of gasses and
the amount, please refer to the relevant label
on the unit.
-Installation, service, maintenance, and repair of
this unit must be performed by a certified
technician.
-Product uninstallation and recycling must be
performed by a certified technician.
-If the system has a leak-detection system
installed, it must be checked for leaks at least
every 12 months.
-When the unit is checked for leaks, proper
recordkeeping of all checks is strongly
recommended.
NOTE:
All the illustrations in the manual are for explanatory
purposes only. Your machine may be slightly different.
The actual shape shall prevail.
The unit can be controlled by the unit control panel alone or
with the remote controller. This manual does not include
Remote Controller Operations. See the <<Remote Controller
Instruction>> packed with the unit for details.
6
Installation
Tools Needed
-Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors;
-Saw (optional, to shorten window adapter for narrow windows)
Accessories
Your Window Installation Kit fits windows 67.5-123cm(26.5-48”) and can
be shortened for smaller windows.
Window Installation Kit
7
Part Description
1 pc
1 pc
1 pc
1 pc
1 pc
1 pc
1 pc
1 pc
2 pc
2 pc
1 set
1 set
Unit Adapter
Window Slider Adapter
Window Slider A
Window Slider B
Exhaust Hose
Bolt
Foam Seal A (Adhesive)
Foam Seal B (Adhesive)
Foam Seal C (Non-adhesive)
Security Bracket and 2 Screws
Drain Hose
Quantity
Remote Controller and Battery
(For remote control models only)
Press the exhaust hose into the window slider adapter and unit adapter,
then clamp automatically by elastic buckles of the adaptors.
Push the Exhaust hose into the air outlet opening of the unit along the
arrow direction.
Unit adapter Window slider
adapter
Exhaust hose Exhaust hose
assembly
Step One: Preparing the Exhaust Hose assembly
Step Two: Install the Exhaust hose assembly to the unit
Step Three: Preparing the Adjustable Window Slider
1. Depending on the size of your window, adjust the size of the
window slider.
2. If the length of the window requires two window sliders, use the bolt
to fasten the window sliders once they are adjusted to the proper
length.
Window slider A Window slider B
Bolt
Installation
Note: Once the Exhaust Hose assembly and Adjustable Window Slider
are prepared, choose one of the following two installation methods.
Cut the adhesive foam seal A
and B strips to the proper
lengths, then attach them to
the window sash and frame
as shown.
Cut the adhesive foam seal A
and B strips to the proper
lengths, then attach them to
the window sash and frame
as shown.
Cut the non-adhesive foam
seal C strip to match the width
of the window. Insert the seal
between the glass and the
window frame to prevent air
and insects from getting into
the room.
If desired, install the security
bracket with 2 screws as shown.
Insert the window slider adapter
into the hole of the window slider.
Insert the window slider
assembly into the window
opening.
Insert the window slider
assembly into the window
opening.
Type 1: Hung Window Installation
Foam seal B
(Adhesive type-shorter)
2 Screws
Security Bracket
Foam seal A
(Adhesive type)
Window slider A
Window slider B
(if required)
8
Type 2: Sliding Window Installation
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
Window slider A
Window slider B
(if required)
Foam seal C
(Non-adhesive type)
Installation
9
Cut the non-adhesive foam
seal C strip to match the
window height. Insert the foam
seal between the glass and the
window frame to prevent air
and insects from getting into
the room.
If desired, install the security
bracket with 2 screws as shown.
Insert the window slider adapter
into the hole of the window slider.
Foam seal C
(Non-adhesive type)
2 Screws
Security
Bracket
Note: To ensure proper function, DO NOT overextend or bend the hose.
Make sure that there is no obstacle around the air outlet of the exhaust
hose (in the range of 500mm) in order to ensure the exhaust system works
properly. All the illustrations in this manual are for explanatory purposes
only. Your air conditioner may be slightly different. The actual shape
shall prevail.
Table des matières
Autres manuels Garrison Climatiseur
Garrison
Garrison 043-5486-2 Manuel utilisateur
Garrison
Garrison 311438113 Manuel utilisateur
Garrison
Garrison 043-5494-2 Manuel utilisateur
Garrison
Garrison 043-6127-2 Manuel utilisateur
Garrison
Garrison 5440 Manuel utilisateur
Garrison
Garrison 1028303 Manuel utilisateur
Garrison
Garrison 311410571 Manuel utilisateur
Garrison
Garrison 043-5488-8 Manuel utilisateur
Garrison
Garrison 3554190 Manuel utilisateur
