Garmin GPS-III+ Manuel d'utilisation et d'entretien

Garmin® GPS-III+ Backup Battery Replacement

If you receive a screen message that your backup battery has lost charge, it is time to

replace it. Here is how.

1. Tools and supplies

a. Japanese JIS Standard “Phillips” head screwdrivers. These drivers are cut

in a different manner and provide a good grip on the screws. You will

mess the screws up if you do not use JIS screwdrivers.

b. De-soldering gun, de-soldering braid or solder sucker.

c. Soldering station with a fine tip

d. Solder

e. Precision sidecutters

f. Battery. Panasonic VL1220-1VC. These are available from

www.mouser.com

1. Replacing the battery. If you do not have the equipment and ability to do fine

soldering do not attempt this project. Please note that removing the backup

battery will delete all waypoints and other stored information.

a. Remove six screws from the back of the case

b. Carefully open the case. There is a connector cable that you can damage

if it suddenly pops open.

c. Using a jeweler’s screwdriver, gently pry up the white cable connector

from the circuit board and set the back of the case aside.

d. Locate the battery. It is on edge next to a capacitor just to the left of the

white connector.

e. Using a jeweler’s screwdriver, pull the plastic clamp back on the brown

ribbon cable to the stops.

f. Remove the screw near the metal can on the antenna end of the board.

g. Gently tip the board up, hinging on the ribbon cable edge. The board will

stick and it will take some leverage to get it up. The ribbon cable will

slide out of the clamp.

h. Turn the board over and locate the battery pads on the back side of the

circuit board and remove the solder.

i. Remove the battery and clean the holes in the pad.

j. Insert the new battery, and check the polarity. The positive side of the

battery should be towards the metal can on the antenna end.

k. Solder the battery leads and trim them.

l. Replace the board in the chassis. Slide the ribbon cable into the clamp, set

the board in place, and install the screw.

m. Replace the white cable clamp

n. Making sure antenna wire is not pinched, reassemble the case and install

the screws.

o. You are done!

Table des matières

Autres manuels Garmin GPS

Garmin

Garmin Montana 700 Series Manuel utilisateur

Garmin

Garmin eTrexVista Manuel utilisateur

Garmin

Garmin GPSMAP 7400 Series Manuel utilisateur

Garmin

Garmin affordable car navigation Manuel utilisateur

Garmin

Garmin Cessna Caravan G1000 Manuel utilisateur

Garmin

Garmin aera 795 Manuel utilisateur

Garmin

Garmin GPSMAP 62 Manuel utilisateur

Garmin

Garmin eTrex Venture - Hiking GPS Receiver Manuel utilisateur

Garmin

Garmin GPS Receiver Manuel utilisateur

Garmin

Garmin GPSMAP 78 series Manuel d'instructions

Garmin

Garmin 400W Series Manuel utilisateur

Garmin

Garmin nuvi 500-Series Manuel utilisateur

Garmin

Garmin GMX 200 Manuel utilisateur

Garmin

Garmin StreetPilot 2820 Manuel utilisateur

Garmin

Garmin Approach G8 Manuel utilisateur

Garmin

Garmin APPROACH G30 Manuel utilisateur

Garmin

Garmin GMA 340 Manuel utilisateur

Garmin

Garmin APPROACH G80 Manuel utilisateur

Garmin

Garmin Astro 430 Manuel d'instructions

Garmin

Garmin niv 205 Manuel de service

Garmin

Garmin GPS 500 Manuel utilisateur

Garmin

Garmin GNS 430 Manuel utilisateur

Garmin

Garmin EDGE 520 PLUS Manuel utilisateur

Garmin

Garmin GPS 500 Manuel utilisateur

Manuels GPS populaires d'autres marques

Raven

Raven Cruizer II Manuel

Hama

Hama 53118 Manuel utilisateur

Jigabot

Jigabot EX Manuel utilisateur

Pointer

Pointer Cellocator CelloTrack XT LTE Guide d'installation

Queclink

Queclink GV55LITE Manuel utilisateur

Voxson

Voxson Voxtrack GPS500 Manuel d'instructions

Starcom Systems

Starcom Systems Kylos Compact Manuel utilisateur

Cobra

Cobra Marine MC 600Ci Manuel utilisateur

Cellocator

Cellocator CelloTrack T Manuel utilisateur

Enfora

Enfora Mini-MT GSM2228UG001 Manuel utilisateur

Magellan

Magellan eXplorist 100 Manuel utilisateur

LTE

LTE G50B Manuel utilisateur

SkyGolf

SkyGolf SkyCaddie SG1 Manuel utilisateur

Kenwood

Kenwood DNN9330BT Manuel utilisateur

Safelet

Safelet Indra Manuel utilisateur

Bushnell

Bushnell 360100 Manuel utilisateur

Geneq

Geneq SXBlue Manuel utilisateur

ORIGO

ORIGO ED308 Manuel utilisateur