SS1603-01 3G Audio Intercom (E1) 10
Enter Listener Monitoring Mode
1. Call the telephone number of the 3G audio intercom
2. This device will then verify your phone number with your predefined numbers.
3. You will hear a “Do” tone to enter listener monitoring mode by pressing【*13*1212＃】
where 1212 is the password.
4. You are now in the” listener monitoring mode”.(you can hear the live sound of the
intercom’s surrounding environment)
* Under this mode speaker is OFF.( 35＃: turn on speaker )
* You can still control the relay output when you are under listener monitoring mode but
speaker must be ON status.
EnterAccess Control Mode
1. Call the telephone number of the 3G audio intercom.
2. This device will then verify your phone number with your predefined numbers.
3. You will hear a “Do” tone to enter access control mode by pressing【*33*5678＃】where
5678 is the password.
4. The door will be opened after enter the correct password
*(To open the door by password, if the number is not stored in the access control section)
Enter Programming Mode
1. Call the telephone number of the 3G audio intercom
2. This device will then verify your phone number with your predefined numbers.
3. You will hear a “Do” tone to enter into programming mode by pressing【*12* 1234＃】where
1234 is the password.
4. You are now in the “programming mode”
Note: At the end of each command there can be one of the two indications:
Successful: a long “beep” tone, failed: three short “beep” tone.
5. To make changes on settings please refer to the user commands.
6. To end programming mode just hang up.
NOTE:
*To be successful in programming, originate a call from a land line and enter the digits slowly or using
programming by text message.
