FRISKA Stockholm Micro Desk Manuel utilisateur
Stockholm Micro Desk Assembly
SWITCH
H
I
G
D
D
A
AC
B
B
E
2
Basic control switch
Optional - Packed
with desktop
Memory control switch
'F'
( x 5)
3
8x 8x 16x 16x 8x 4x
FIXING
COMPONENT LI T
L M N P* R S
*P - These screws must only be used for frame only configuration
or when using a desktop without metal screw inserts.
A- Desk Legs
B- Under-desk Support Arm
C- Cross Beam
D- Feet
E- Power supply lead
F- Control switch (Basic or Memory)
G- Power supply lead
H- Self Adhesive Cable Clips
I- Cable Port Cover (Optional)
REQUIRED TOOLS
HEX
4mm
HEX
5mm
(supplied) (Not supplied)
4
1.
A
A
2.
C
F
CAUTION
Components are heavy – take care when handling
!
‘L’ x4
Insert screws but
do not tighten.
Gap needed for
frame and brackets
in steps 4and 5.
Feed leg motor cables
through centre hole
5
3.
4.
‘L’ x4
Fully
tighten
screws.
Do not tighten: Keep loose for step 5.
6
5.
B
B
Fully
tighten
screws.
x4
It may be necessary to use asoft headed mallet to fit
tight fitting support arm onto the leg / frame.
7
6.
‘M’x8
D
D
Fully
tighten
screws.
8
7.
8.
‘S’ x4
NOTE Check desktop for any delivery
damage before commencing this stage.
!
!NOTE Carefully unpack the desktop leaving it face
down on the packaging supplied so as to protect the
work surface.
Hand tighten
fully into foot.
Basic control switch
Memory control switch
9
9.
CAUTION
Frame is heavy – take care when positioning it.
!
‘SWITCH’
NOTE Insert switch into
aperture by applying firm, even
pressure. Ensure correct
orientation of switch within the
aperture. Basic control has ‘UP’
stamped on the rear, position
this furthest from the front
edge.
Carefully lower the frame onto
the underside of the desktop.
10
10.
!NOTE Use P x16 only if using desktop
without metal screw inserts
‘P’x16 ‘N’x16
‘N’x14 when
Cable Tray Used
Fully
tighten
screws.
Fully
tighten
screws.
Omit screws if
fitting cable tray
Table des matières
Autres manuels FRISKA Ordinateur de bureau
