Step IV
Step IV - Set the cellar fans speed
Genesis & Vintage
Nominal fan speed according to evaporators model
Seng the
speed evapora-
tor fan cellar
Even if the screen
is blank Press
for 6 seconds
Change the
screens with
OK
OK
confirm with
-
+
Change the value with
or
Access to
menu
Parameters Screens Manipulations
See below the value
set according to the
device
Login with
To exit the menu,
press
Remarks
* For EVG and EVI, the factory set speeds are adapted to obtain the nominal ow rate for air
pressure drops up to 20 Pa. If the pressure drop is higher (up to 100 Pa) you can increase the
speed increasing this speed with the remote control. To optimize the ow, read the step "opti-
mize the fan speed".
For EVXs, the speed is the nominal ow rate value of the standard wall unit. You can increase
this speed with the remote control as needed. For the value to be adjusted in this case follow
the indications in "optimize the fan speed" to obtain an optimal ow.
For EVA model, the fan speed has been chosen when the device blows freely up or down. The
cabinet’s conguration or the cellar where the device is installed can aect the air ow accor-
ding to the pressure losses . In this case, it’s necessary to increase the fan speed with the
remote controller. To optimize the air ow, read the step «optimization the fan speed».
7
No access to dFSe parameter.
Speed xed
30 48 82 122 170 230
EVPL
EVG, EVI
EVX
EVA
5* 8* - - - -
3* 4* 2* 4* - -
3* 3* 7* 7* 7* 7*
