Fri-Jado GO Combi Guide de l'utilisateur
Mounting instruction
Changing oven door opening direction
EN (Original Instruction) Revision 03/2023, SW: 0.5.9
GO Combi
2
GO Combi
3
GO Combi
GO Combi mounting instruction, revision 03/2023, SW: 0.5.9
General information 4
Target group....................................................................................... 4
Technical changes............................................................................... 4
More documentation.......................................................................... 4
Warranty ............................................................................................ 4
Permissions......................................................................................... 4
Safety information 5
Before replacement 6
Tools ............................................................................................. 6
Spare parts ......................................................................................... 6
Estimated working time...................................................................... 6
Oven overview 7
Changing the door opening direction 8
Dismounting the oven door ................................................................ 8
Mounting the oven door................................................................... 12
Calibrating the oven door................................................................. 17
Change the oven light ...................................................................... 19
Testing the oven ............................................................................... 19
Table of contents
4
GO Combi
General information
Target group
This document is aimed at service technicians who have been trained in installing and servicing the
oven. The oven must only be installed and serviced by qualified service technicians.
Technical changes
This document is subject to changes without notice.
More documentation
You find more documentation about the oven at our website.
Warranty
You find more information about warranty at our website.
Permissions
Log in as “Technician” (576021) to have the necessary rights to be able to change the oven setup,
use the test functions, update software, etc.
GO Combi mounting instruction, revision 03/2023, SW: 0.5.9 5
GO Combi
Safety information
Read this document before using, installing or servicing the product.
Installation and operation must comply with local regulations and accepted
codes of good practice.
Read the safety instructions in the user manual, installation manual and
service manual before you perform any work on the oven.
All maintenance and repair must be carried out by qualified installation and
service technicians only. Installation and/or service by others than qualified
service technicians may result in injury to the operator and/or damage to the
oven.
6
GO Combi
Before replacement
• Make sure the required tools are available.
• Unpack the spare parts and check if all parts are available.
• Make sure the working area is tidied up, clean and safe to prevent personal injury and damage
to the equipment.
• It is not possible to change oven door opening direction on roll-in ovens.
Tools
• Single-head wrench, 8 mm
• Straight slotted screwdriver
• Heaxagon socket spanner, size 4
• Socket screwdriver, 10 mm
• Pozi drive screwdriver, PZ2
• Loctite AS-43 WM
• Cable ties
Spare parts
None
Estimated working time
The estimated working time is two hours.
GO Combi mounting instruction, revision 03/2023, SW: 0.5.9 7
GO Combi
Oven overview
Oven door with door mounted on the left-hand side
Oven door with door mounted on the right-hand side
8
GO Combi
Changing the door opening
direction
IMPORTANT! All screws must be fastened with Loctite AS-43 WM.
Dismounting the oven door
1. Remove the cover from the upper and lower door hinge.
2. Open the oven door and loosen the inner and middle glass.
3. Loosen the two screws in the oven door frame.
1
1
3
GO Combi mounting instruction, revision 03/2023, SW: 0.5.9 9
GO Combi
4. Remove the wires from the upper rail on the oven door.
5. Press on the connector to loosen the wires using a small flat slotted screwdriver.
6. Pull out the wires.
7. Fasten the inner and middle glass on the oven door.
8. Remove the two screws, the bracket and the drain of the drip tray.
10
GO Combi
9. Remove the two screws and the drip tray
10. Loosen the wires for the LED fixture.
11. Remove the screws from the upper door hinge.
IMPORTANT! Be careful as the door is no longer fastened and might be heavy.
12. Remove the oven door.
Autres manuels pour GO Combi
5
Table des matières
Autres manuels Fri-Jado Équipement alimentaire commercial
Fri-Jado
Fri-Jado GO Combi Two-GO Guide de l'utilisateur
Fri-Jado
Fri-Jado MDD Manuel utilisateur
Fri-Jado
Fri-Jado MCC-60 H Manuel utilisateur
Fri-Jado
Fri-Jado MDD-24-3 Manuel utilisateur
Fri-Jado
Fri-Jado BS3i Manuel utilisateur
Fri-Jado
Fri-Jado CSD 180 Manuel utilisateur
Fri-Jado
Fri-Jado 9124725 Manuel d'utilisation original
Fri-Jado
Fri-Jado TDR P eco Series Manuel utilisateur
Fri-Jado
Fri-Jado 9124709 Manuel utilisateur
Fri-Jado
Fri-Jado Bakery Multisserie Manuel utilisateur
Fri-Jado
Fri-Jado HD 3 Manuel utilisateur
Fri-Jado
Fri-Jado LDR 8 s Auto Clean GAS Manuel utilisateur
Fri-Jado
Fri-Jado MD 60 Hot Manuel utilisateur
Fri-Jado
Fri-Jado LDR 8 s AC Manuel utilisateur
Fri-Jado
Fri-Jado HCT 100 Manuel utilisateur
Fri-Jado
Fri-Jado GO Combi Guide de l'utilisateur
Fri-Jado
Fri-Jado Multi Deck 25 Hot Manuel utilisateur
Fri-Jado
Fri-Jado STG 5-I Manuel utilisateur
Fri-Jado
Fri-Jado STG Manuel utilisateur
Fri-Jado
Fri-Jado MULTI DECK 60 HOT MERCHANDISER Manuel utilisateur
