Fortstrong FS-1200DLPB Manuel utilisateur
These instructions are designed to work with the
following models
FS-1200DLPB, FS-1200DLPS
PRIVACY DOOR HANDLE
INSTRUCTIONS
Before You Start, You Will Need
Pencil Cordless Drill Wood Chisel
2 1/8 hole cutter 1 inch wood drill bit Philips Screwdriver
Tape Measure Safety Glasses Sticky Tape
Caution: Incorrect installation may lead to personal injury or
property damage. Always follow instructions carefully.
fortstronghardware.com or email info@fortstronghardware.com
CONTENTS
STEP 1
template to the corner edge of the door. The center of the template should be placed
Mark Out All Measurements
Mark Thickness
STEP 2 Drill All Holes
Firstly drill a larger 2 1/8” hole through the face of the door using the 2 1/8” hole cutter.
door face hole. You can use a 1” hole cutter or 1” wood drill bit.
Drill 2 1/8” hole
Drill 1” hole
STEP 3 Chisel The Door & Install Latch Plate
To Install The Latch Plate
rectangular latch using your pencil.
Insert the latch plate and screw in using the screws provided and a Philips screwdriver.
The bevel should be facing the door jamb.
(Note: If you have selected a 2 ¾” backset – skip to Step 6 to adjust the latch backset
before screwing in latch plate)
Chisel shallow groove
for latch plate
Screw in
latch plate
STEP 4 Chisel The Door Jamb & Install Striker Plate
previously drawn.
Mark around the edge of the striker plate and inside the screw holes.
inside the door jamb.
– this will indicate the position of the striker plate.
the door frame.
not over-tighten screws.
Position the lever facing away from the door latch into the 2 1/8” hole. You should use the
STEP 5 Install The Door Lever
Position the second lever onto the connection bar and line up into position.
Align the unit as required and use screws provided to lock the handle into place.
5.1 5.2
Ce manuel convient aux modèles suivants
1
