Machine Initialization
1. Turn on the airline and power on the backside of the machine, and at the air hose line at the
wall. Make sure the PSI is reading 80.
2. On the main screen press the preheat button (a), then the green arrow, then select your desired
job/material profile. If a desired profile is not present, you will need to create one in the building
a profile menu (b).
a.
b.
3. Press Green arrow button
4. Machine will be fully heated once the protective grating above heating elements is
uncomfortable to touch, generally 15-20 minutes
Building Job Profile
1. Job Profiles: are built for specific molds, but
may be generalized for specific materials.
2. To enter the job profile page, click the profile
selection button (b).
3. From here you can build a profile that is specific
to your project or material properties.
4. Things to set
a. Name of your profile
b. Heat Zones – How large is your material, does the entire bed need to heat or only the
interior
c. Heat Intensity – Temperature of each heater in each zone, this will be dependent on
material, operation time, mold design
d. Heater Standby – How much the heaters can cool while the heater tray is in the rear
position
e. Auto Vacuum – Do you want the vacuum to automatically turn on when the table has
rise to its highest extents.
f. Auto Blower - This operation enables the beam sensor to provide automatic levelling of
the sheet level during heating. Compressed air is applied under the heated sheet when
the beam is broken.
g. Save Icon
