Instruction manualHT119www.foehrenbach.be
Date: August2007Documentrev. : 4Page :5/15/
2. OPERATION
2.1Operating Procedures
WARNING
To preventhand injury,keepfingersfrombetweentheupperandlowertooling andfrom
betweentheleverandhandlewhenclosinghandtool.
1.Holdthe hand toolsothattheleverisonthe left.Withyourindexfinger,pushand holdthe
terminalholderinitsforwardposition(seeFigure2).
NOTE
Wheninsertingaterminalintotheterminalholderyouwillnoticeaslightdrag(interference)on
theterminal.The dragiscaused bythespring ballplunger(seeFigure13itemno.21)
applyingdownwardpressureonthe pinendofthe terminal.
Thisdownwardpressurehelpstoorientandholdtheterminalintheterminalholderuntil
crimped.
2.Insertthepinendofthe terminal,with“U” shaped barrels
up,intotheterminalholderandagainstthepinshoulder.
Whileholdingtheterminalagainsttheshoulder,release
theterminalholder. Thisensuresthat theterminalremains
inthe properposition whilemovingovertheanvil.
3.Whilegraspingthelever and thehandleportion ofthe
frame,insertawiresothattheendofthe insulation is
centered betweenthe wirebarrelandtheinsulationbarrel
oftheterminal(see Figure3).Analternatemethodisto
position theend oftheinsulation againstthetonker(see
Figure13,itemno.2)whichprotrudesfrombetween the
crimpers(3&4).Then closethehand toollever
completely.Thiswill crimpthe terminaltothe wire(s).
Figure2. PositioningTerminalfor
Crimping
