Foc.us Emifocus Manuel utilisateur

Tested by OMNI-Test Laboratories, Inc. and approved to

UL 737-2011 and ULC S627-00

US EPA exempt

Report Number : 0304WF008S

This document was packed with the appliance.

KEEP THESE INSTRUCTIONS FOR FUTURE USE

EMIFOCUS

____

DESIGN INSTALLATION &

OPERATING MANUAL

Introduction

Table

of contents

Please read this entire manual before you install and use

your focus fireplace. Failure to follow instruction may result

in property damage, bodily injury or even death. When this

room heater is not properly installed, a house fire may result.

To reduce the risk of fire, follow the installation instructions.

Contact local building or fire officials about restrictions and

installation inspection requirements in your area.

This fireplace is approved for use as a wood burning

fireplace or for use with a vented gas log listed to

ANSI Z21.60 standard having an input rate of 65,000

Btu or less.

KEEP THIS MANUAL HANDY FOR EASY REFERRAL.

All WARNING and CAUTION statements will appear in bold

font and upper case letters: THEY SHOULD BE STRICTLY

OBSERVED.

Thank you for choosing focus fireplaces.

Appliance designation: émifocus d.v.

Manufacturer:

Focus - Atelier Dominique Imbert

Le fort – 34380 Viols le fort – France.

Introduction

Specifications

CHARACTERISTICS

ROOF OUTLET REQUIREMENT

CHIMNEY REQUIREMENT

STRUCTURAL REQUIREMENT

CONNECTOR

FRESH AIR INTAKE

CLEARANCES TO COMBUSTIBLES

A. CLEARANCES TO FLOOR AND CEILING

B. CLEARANCES TO SIDE WALLS

Installation

INCLUDED PARTS, MATERIALS AND REQUIRED TOOLS

FOR INSTALLATION

OPTIONS

ASSEMBLY DETAILS

A. SIDE CUT PLATE DETAIL

B. WALL MOUNTING INSTALLATION

C. FLUE PIPE INSTALLATION

D. INSULATED CHIMNEY CONNECTION TO FOCUS FLUE

Operating instructions

STORAGE / USE OF FLAMMABLE LIQUIDS

GRATE

ASHES

FUEL

FIRE SCREEN

BEFORE LIGHTING YOUR FIRST FIRE

BUILDING, STARTING AND MAINTAINING THE FIRE

PROTECTIVE GLOVE

Maintenance

TAKING OUT THE ASHES

CREOSOTE FORMATION AND NEED FOR REMOVAL

SWEEPING YOUR CHIMNEY

SURFACES

REPLACEMENT PARTS

Warranty

Annex

HOW TO DETERMINE IF ALTERNATE FLOOR PROTECTION

MATERIALS ARE ACCEPTABLE

Specifications

CAUTION

NOT FOR MOBILE HOME INSTALLATION!

DO NOT CONNECT TO ANY AIR DISTRIBUTION DUCT OR SYSTEM!

NOT TO INSTALL WITH MASONRY CHIMNEY SYSTEM.

DO NOT INSTALL IN SLEEPING ROOM.

•The authority having jurisdiction (such as municipal building department, fire department, fire prevention

bureau, etc.) Should be consulted before installation to determine the need to obtain a permit.

•Using make-shift compromises during installation can cause damage. Such installation is not covered under

focus limited warranty.

•When this room heater is not properly installed, a house fire may result. To reduce the risk of fire, follow the

installation instructions. Contact local building or fire officials about restrictions and installation inspection

requirements in your area.

CHARACTERISTICS

• Hearth weight: 115 lbs

(52 kg)

• Flue diameter: 8-5/8-inch

(219mm) ;

length custom-made

• Flue weight: 11 lbs per foot

(16 kg per meter)

• Wall anchor plate weight:

approx. 22 lbs (10 kg)

• 1/8-inch (3 & 2.5 mm) thick

steel

• High heat resistant paint

• Guarranteed efficiency

with a minimum flue lenght

(interior and exterior) of 10

feet (3.00m)

• Fire screen

EMIFOCUS

Scale 1 : 20

Note : imperial are rounded from metric

floor

(sol)

8’’ adaptor

Ø 27 9/16"

(Ø 700 mm)

30 1/2"

(775 mm)

24"

(610 mm)

65 9/16"

(1.665 mm)

5 11/16"

(145 mm)

11 7/16"

(290 mm)

Ø 8 5/8" id

(Ø 219 mm)

Ø 8 1/16" id

(Ø 205 mm)

42 1/2"

(1.080 mm)

20"

(500 mm)

16 9/16"

(420 mm)

Specifications

ROOF OUTLET REQUIREMENT

CHIMNEY REQUIREMENT

Do not connect this unit to a chimney flue serving another appliance!

Émifocus requirement: the total length of flue (inside + outside) must be 10 feet minimum (13 feet for an installation less than

3 miles from the ocean or if a 30° elbow is necessary).

The émifocus must be connected to a chimney complying with the requirements for Type HT chimneys in the standard for

Chimneys, Factorybuilt, Residential Type and Building Heating Appliance, UL 103. For example, a class A insulated stainless

steel flue chimney system with an 8-inch minimum inside diameter.

Specifications

STRUCTURAL REQUIREMENT

CAUTION

THE FRAMING SUPPORTING THE ANCHOR PLATE (WALL STRUCTURE, PARTITION, ETC.) MUST BE SIZED IN

CONGRUENCE WITH THE FIREPLACE STATIC AND DYNAMIC CHARGES. THE SIZE CALCULATION FOR THE

SUPPORT IS NOT THE RESPONSIBILITY OF FOCUS OR ITS AFFILIATES. IT IS YOUR RESPONSIBILITY TO

CONSULT WITH AN ENGINEER OR ARCHITECT FOR YOUR PROJECT.

CONNECTOR

Connectors are all non-insulated chimney parts including focus flue, focus 8’’ universal adaptor and the chimney manufacturer

finishing collar with adapter.

To avoid heat traps the chimney connector shall not pass through an attic or roof space, closet or similar concealed space, or

a floor, or ceiling.

Passage through an attic, roof frame floor, or ceiling must be done using an insulated chimney respecting all chimney

manufacturer clearances.

CAUTION

PASSAGE THROUGH A WALL OR PARTITION OF COMBUSTIBLE CONSTRUCTION IS NOT AN APPROPRIATE

INSTALLATION FOR THIS FOCUS FIREPLACE.

FRESH AIR INTAKE

For optimum functioning, focus requires a fresh air intake in the room (ideally at the back of the fire). We recommend deflect-O

A0684 semi rigid aluminium duct. The wall plate is supplied with a fresh air control.

Minimum fresh air intake size:

fresh air intake

This fresh air intake is compulsory

when operating venting appliances

such as kitchen hoods, permanent

air extractors or any appliances

creating an air depression in the

habitation.

IMPORTANT

CLEARANCES TO COMBUSTIBLES

A. CLEARANCES TO FLOOR AND CEILING

minimum 8’-6’’

minimum 2.60 m

IMPORTANT

no radiant floor heating tubing under the fireplace !

pas de chauffage au sol !

non combustible surface R ≥ 1.2

surface non combustible R ≥ 1.2

combustible sub floor

sol combustible

20’’

50 cm

8’’

200 mm

8’’

200 mm

16’’ / 40 cm (US)

18’’ / 45 cm (Canada)

wall

mur

wall

mur

non combustible surface R ≥ 1.2

surface non combustible R ≥ 1.2

Specifications

B. CLEARANCES TO SIDE WALLS

1/2’’cement board

(Durarock)

13 mm panneau de ciment

(Durarock)

1’’ rockwool insilation

(Roxul) attached to

backside of cement board.

25 mm isolant laine de roche (Roxul)

positionné juste derrière le panneau de ciment.

2x6’’ metal studs supporting

wall mounting plate.

montants métal 2x150 mm

supportant la platine murale

combustible wall

mur combustible

2’’

50 mm

1/2’’

12 mm

26’’

660 mm

36’’

915 mm

combustible wall

mur combustible

4’

1220 mm

CAUTION

THE DISTANCE TO A COMBUSTIBLE WALL MUST BE MAINTAINED AT 26 INCHES. PROPERTY DAMAGE OR

DEATH CAN OCCUR IF THIS DISTANCE IS NOT MAINTAINED. DRYWALL PRODUCTS LINED WITH PAPER

SUCH AS SHEETROCK ARE COMBUSTIBLE. CLEARANCES AS INDICATED FURTHER APPLY.

Manufacturer specifications:

• Corner configuration: this configuration necessit that you build an additional wall in the corner of the room. When placed

close to a noncombustible wall leave a minimum of 4 inches (from hearth which has a 27-9/16” diameter) for proper

ventilation. To avoid premature aging of your painted walls, only use mineral paint. With other paints, 38” clearances apply.

• Fire clearance to glass (from hearth): 31-1/2”.

• Fire clearance to vinyl windows: refer to window technical specifications..

IMPORTANT

Clearances may only be reduced by means approved by the regulatory authority.

Specifications

Installation

INCLUDED PARTS, MATERIALS AND REQUIRED TOOLS FOR INSTALLATION

• Appliance and designated parts are the hearth, grate, wall mounting anchor plate, black steel flue pipe, focus kit

(protective glove, mounting gloves, can of touch-up paint).

• Required tools: drill, M8 allen key, level, screwdrivers, M12 key, scaffolding, refractory compound.

• 2 persons minimum are required for installation.

OPTIONS

• Custom ceiling cover disc (steel disc) + cover disc screw kit

• Focus steel flue extension

ASSEMBLY DETAILS

A. SIDE CUT PLATE DETAIL

metal studs frame

structure métalliques

1’’ rock wool

25 mm laine de roche

coupe de côté du émifocus

ambient air

air ambiant 1/2’’

12 mm

cement board

panneaux de ciment

fresh air intake

arrivé d’air frais

Installation

B. WALL MOUNTING INSTALLATION

24-13/16’’

630 mm

7 - 7/8’’

200 mm

6’’ diameter

Ø150 mm

b: fresh air intake

arrivé d’air frais

Installation

C. FLUE PIPE INSTALLATION

6-7/32’’ ≥ X ≥ 6-1/2’’

160 mm ≥ X ≥ 165 mm

6’’ diameter

Ø150 mm

damper

clé de tirage

fresh air

intake adjustement

ajustement de

l’arrivé d’air frais

7-7/8’’

200 mm

24-13/16’’

630 mm

Table des matières

Autres manuels foc.us Cheminée intérieure

foc.us

foc.us nemofocus Manuel utilisateur

foc.us

foc.us Meijifocus Manuel utilisateur

foc.us

foc.us agorafocus 850 suspendu Manuel utilisateur

foc.us

foc.us Edofocus 631 DV Manuel utilisateur

foc.us

foc.us emifocus hublot da Manuel utilisateur

foc.us

foc.us PICTOFOCUS Guide de l'utilisateur

foc.us

foc.us Grappus Manuel utilisateur

foc.us

foc.us édofocus 630 d.a. Manuel utilisateur

foc.us

foc.us omegafocus Manuel utilisateur

foc.us

foc.us Slimfocus mural Manuel utilisateur

foc.us

foc.us Filiofocus 1600 central Manuel utilisateur

foc.us

foc.us ERGOFOCUS Manuel utilisateur

foc.us

foc.us Drumfocus M-B-C Manuel

foc.us

foc.us Gyrofocus Instructions d'utilisation d'origine

foc.us

foc.us MAGMAFOCUS Guide de l'utilisateur

foc.us

foc.us néofocus Manuel utilisateur

foc.us

foc.us Hubfocus Manuel utilisateur

foc.us

foc.us édofocus 630 dv Manuel utilisateur

foc.us

foc.us Gyrofocus Manuel utilisateur

foc.us

foc.us Bathyscafocus a hublot Manuel utilisateur

foc.us

foc.us emifocus hublot dv Manuel utilisateur

foc.us

foc.us agorafocus 630 suspendu Manuel utilisateur

foc.us

foc.us Gigafocus 1500 Manuel utilisateur

foc.us

foc.us pictofocus 860 Manuel utilisateur

Manuels Cheminée intérieure populaires d'autres marques

Brigantia

Brigantia 35-DVRS31N-2 Manuel du propriétaire

Nordpeis

Nordpeis Bergen Manuel utilisateur

Superior

Superior BCT2536TMN Manuel utilisateur

Quadra-Fire

Quadra-Fire 5100I-GD-B Manuel utilisateur

Renaissance

Renaissance RUMFORD 1000 Manuel utilisateur

Lacunza

Lacunza IV-800 Manuel utilisateur

Baxi

Baxi 940 Instructions d'utilisation

Dru

Dru Maestro 60/2 Tall RCH Manuel utilisateur

Diamond Fireglass

Diamond Fireglass SS-O22 Manuel utilisateur

HearthStone

HearthStone Windsor Bay 8830 Manuel de programmation

Napoleon

Napoleon ASCENT B42 Manuel utilisateur

Enviro

Enviro E33GI Manuel utilisateur

Smeg

Smeg L30 FABE Instructions de montage

KEDDY

KEDDY K700 Manuel utilisateur

Godin

Godin 3451 Manuel utilisateur

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Manuel utilisateur

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 Manuel utilisateur

Desa

Desa CCFPDFT Manuel d'utilisation

foc.us Emifocus Manuel utilisateur

Manuels Cheminée intérieure populaires d'autres marques