The remaining strip can likewise be fitted with a new mains lead (153.851UK) to power up as a separate strip and
couplers are also available (153.857UK) to allow strips to be joined together (up to a maximum of 50m). The mains lead
or coupler is connected to the strip via 2-pin connector. This will only make the strip operate if the “+”and “-”are
connected the correct way round. Insert the rounded pins into the mains lead and the pointed pins into the cut end of
the strip.
Before sealing with glue, check the strip operation by plugging the mains plug into a 230V socket. If the strip does not
light, disconnect the strip from the mains and swap the “+”and “-”connections around to check if they were the wrong
way around. When connection is successful, squeeze silicone glue into the joint to ensure a secure and waterproof
connection. Again, shrink tubing can offer additional safety and weatherproofing to the joint.
Joining 2 lengths of strip together is performed in exactly the same way and should again be sealed both sides with
silicone glue. Any open end will need to be sealed with an end-cap and silicone glue. When fixing the strip to a surface, it
is important to not penetrate or damage the containment. Do not pierce with nails, screws or staples. Installation clips
are available for convenient fixing to most surfaces (153.855UK).
Specifications
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
Errors and omissions excepted.
Copyright© 2016. AVSL Group Ltd.
