Name of App ColorEasy3 Plus
PWM frequency 8000 Hz (8KHz)
RF Remote Yes
RF Remote Frequency 433.92MHz
Working Voltage 6-24VDC
Bluetooth Control Distance >10m in open area
Rated Output Current 3x5A
IP Grade IP68
Auto Circuit Protecon Overload/Overheat/
Short Circuit/Overcurrent
2. Bluetooth Auto Reconnecng
The default seng of the receiver enables an
auto-reconnecng feature. The controller will
automacally connect to the latest paired
smartphone when in range. However, if auto-re-
connect is not desired, it can be disabled in the
app’s setup page when the controller is connected
to the smartphone. When the auto-reconnecng
feature is set to off, the user can sll manually
connect to the controller at any me by tapping
the controller bluetooth device name on the
smartphone’s bluetooth seng page when the
controller is powered on.
3. Using the Included External RF Remote
The hand held remote (FF-JUN-HAND) and the
wall switch type (FF-JUN-WALL) RF wireless
remote control are included with the Juno™ Series
LED controllers. These RF remote controls can be
used to turn the LED controller on/off and switch
between the previously saved scenes in the app.
The RF remote controls need to be paired to the
main unit before use with the following steps:
1. Ensure the remote control funcon is
enabled on the app seng page while the LED
controller is paired to the smartphone.
2. Power off the LED controller for more than 5
seconds and power on again.
3. Within 5 seconds of LED controller powering
Flexfire LEDs, Inc.
www.FlexfireLEDs.com
1-844-FLEXFIRE
QR Links to Download App
on, press on/off key and downward key togeth-
er on the remote controller.
4. The indicator on the LED controller will flash
white 3 mes to show the remote control is
recognized. A maximum of five remote controls
can be paired to one LED controller and can be
used at the same me.
The preset color scenes or dynamic mode sets
saved within the smartphone app can be selected
by pressing the up/down key on the remote
control. These preset scenes can be customized
within the smartphone app. The RF remotes offer
simplified control of the RGB lights. For full
funconality, the app must be used.
Other Features
These controllers have full protecon against
output short circuits, overloads, and overheang.
The indicator flashes red due to overload or
electrical short circuit, and flashes yellow if
overheang. The controller will automacally
recover when the fault is corrected. Please ensure
the LED loads are within the rated voltage range,
not shorted and protected against overheang.
Automac Circuit Breakers
Voltage Range
This controller can work on 6-24VDC. Be sure the
input signal, power supply and LED load are all
using the same voltage. The controller cannot
work with different voltage input and output. Also,
the wrong voltage may damage the LEDs. e.g. Do
not use 12V LEDs with a 24V power supply.
Environmental Protecon
This waterproof version is designed with the IP68
standard and can be used underwater up to a
depth of 100 (30 meters). When installing under
water, make sure the cable connecons are
waterproof.
Note: The bluetooth connecon and RF remote
control sensivity is decreased when the LED
controller is installed in a wet environment or
under water.
Specificaons
Model FF-JUN-APP-RGB-COMBO
Dynamic Mode 42 modes
Stac Color 16 vivid colors
Connecon Method Bluetooth V2.1/4.0 Class 2
Smartphone OS iOS or Android V.2018.09.17
