Fleetnder GOLD
Command
Purpose Default setting Options Example SMS Response.
(Queried Via SMS).
PIN XXXX Pin number security, for the access
of the Fleetminder, Also used for
setting the primary identity. And
rmware upgrade password.
PIN 0000 (Used to set the
primary identity and rmware
upgrade password.)
PIN XXXX (used to change the
primary identity, as long as the PIN
number is correct)
PIN 1234 will check the pin number
in the unit, and if void, will ignore
the message, but if correct, it will
change the primary identity to the
phone number where the message
was sent from.
CFG:PIN XXXX (where XXXX is the
pin number for the device)
NEWPIN Used to change the pin number
from the default setting
No default NEWPIN XXXX where XXXX is the
new 4 digit pin number
NEWPIN 1234 will change the pin
number from the unit, as long as the
message is sent from the primary
identity.
CFG:NEWPIN XX(where XX is the
new pin number)
PH2 XX Sets the secondary number for
event reporting.
No default PH2 XX where XX is the second-
ary phone number, note. PH2
without the number, will disable
this feature.
PH2 0412345678 will set the sec-
ondary number to 0412345678
CFG:PH2 XX (where x is the sec-
ondary number)
INPUTS To set input parameters
LABELIN N X (admin only) Renames the label heading for
an input
No default Up to 16 characters for all 3 inputs.
LABELIN N X where N is the
number of the input (1-3), and X is
the name for the input
LABELIN 1 Starter will set the label
of input 1 to "Starter"
CFG:LABELIN N X (where n is the
input number and x is the input
name)
QUERYINLABEL N Queries the Label settings for the
Inputs.
No default QUERYINLABEL N where N is the
input number (input 1 to 3)
QUERYINLABEL 1 will request the
LABEL heading for Input 1
CFG:QUERYINLABEL N X (where
n is the number of the input, and x
is the label that is ser for the input
queried)
DELAYIN N T To set a delay timer on an input
trigger.
No default Used to set a delay for input trig-
gering, where N is the number of
the input (1 -3) only, and T is the
delay time in seconds.
DELAYIN 2 20 will set the input 2
delay time for 20 seconds, before
sending an alert,
CFG:DELAYIN N T (where N is the
input number, and T is the Time in
seconds)
GPISMS N X (SMS Only) To enable SMS alerting for a dened
input.
No default This feature is used to enable or
disable SMS alerting for a particular
input.
GPISMS 2 ON will enable sms alert-
ing for Input 2.
CFG:GPISMS N X (where N is the
number of the input and X is the
status of the input(ON or OFF))
OUTPUTS To set/enable the outputs
SETGPO N L Sets the outputs N for Latch SETGPO 1 L - Will set output 1
for Latch
SETGPO 1 L - Will set output 1
for Latch
CFG:SETGPO N L (where N is the
number of the input and L is the
Latch setting)
9.5 COMMAND LIST
P14
