Fimer PVS-100-TL B2 Manuel utilisateur

Solar Inverter

PVS-100/120-TL “B2 Version”

Quick Installation Guide

In addition to what is explained in this quick installation guide, the safety and installation information provided in the product manual must be read and

followed. The technical documentation for the product is available at the website.

The device must be used in the manner described in the manual. If this is not the case the safety devices guaranteed by the inverter might be

ineffective.

ATTENTION –AIMPORTANT SAFETY INSTRUCTIONS

This document contains important safety instructions that must be followed during the installation and maintenance of the equipment.

ATTENTION –ASAVE THESE INSTRUCTIONS

Keep this document in a safe place near the inverter for easy access during installation, operation and maintenance.

ATTENTION –AThe installer must read this document in its entirety before installing or commissioning this equipment. In addition to

what is explained below, the safety and installation information provided in the product manual must be read and followed. For more

detailed information regarding proper installation and use of this product, refer to the product manual located at www.fimer.com.

ATTENTION –AThe product must be used in the manner described in the document. If this is not the case the safety devices

guaranteed by the inverter might be ineffective.

ATTENTION –AAll pictures and illustrations shown in this document are indicatives and must be intended as support for installation

instruction only. Actual product may vary due to product enhancement. Specifications subject to change without notice. The latest

version of this document is available on the FIMER website.

Table of Content

1. Reference number index 5

1.1 Inverter external view 6

1.2 PVS-100/120-TL ; B2 7

1.3 PVS-100/120-TL ; B2 ; S2 8

1.4 PVS-100/120-TL ; B2 ; S(X or Y) 9

1.5 PVS-100/120-TL ; B2 ; S(X or Y)2 10

1.6 Communication board 11

2. Labels and Symbols 12

3. Models and range of equipment 14

3.1 Bracket model 14

3.2 Power Module models (B2 version) 14

3.3 Wiring box models (B2 version) 14

4. Lifting and transport 16

4.1 Transport and handling 16

4.2 Unpacking and checking 16

4.3 Lifting 16

5. List of supplied components 19

6. Choice of installation location 20

6.1 General recommendation on installation position 20

6.2 Tilting admittance 20

6.3 Distances 20

6.4 Installation of multiple units 21

6.5 Wireless signal environmental checks 22

7. Mounting Instructions 23

7.1 Bracket assembly 23

7.2 Assembly the Inverter to the bracket 24

7.3 Opening the power module box cover 25

7.4 Final fastening operations 25

7.5 Interface cables connection 26

8. Routing the cable to the inverter 27

9. Grid output connection (AC side) 28

9.1 Characteristics and sizing of the protective grounding cable 28

9.2 Load protection breaker (AC disconnect switch) and differential protection

downstream of the inverter 28

9.3 Characteristics and sizing of the line cable 29

9.4 AC output cables connection 29

10. Input connection (DC) 32

10.1 Input connection on standard and S2 models (single/double MPPT) 32

10.1.1 Operations preliminary to the connection of the PV generator 32

10.1.2 Independent or parallel input channels configuration 32

10.1.3 Connection of inputs 34

10.2 Input connection on -S(X or Y) and

S(X or Y)2 models 35

11. Connection of the communication and control signals 39

11.1 Communication and control board (28) references 39

11.2 Connections to the communication and control board 40

11.3 Ethernet connection 40

11.4 Serial communication connection (RS485) 41

11.4.1 Slave mode 41

11.4.2 Master mode 41

11.5 Remote control connection 41

11.6 Multifunction Relay connection (ALARM and AUX) 42

11.7 Demand Response Mode 0 (AS/NZS 4777.2) 42

12. Description of LED panel 43

13. Commissioning 45

13.1 Commissioning via FIMER Installer for Solar Inverters mobile APP 45

13.2 Commissioning via Web User Interface 46

14. Technical data 47

14.1 Technical data table PVS-100-TL 47

14.2 Technical data table PVS-100-TL (SX, SX2, SY, SY2 Models) 49

14.3 Technical data table PVS-120-TL 51

14.4 Technical data table PVS-120-TL (SX, SX2, SY, SY2 Models) 53

14.5 Tightening torques 55

14.6 Cable gland clamping range 55

Inverter external view

01 Power module

02 Wiring box

03 Mounting bracket

04 Handles

05 Cover quarter cam locks

07 Wiring box front cover

08 LEDs panel

09 AC disconnect switch

10 Protective earth point (ext.)

11 Single-core AC panel (default)

12 Signals cable glands

13 Rear pins for bracket assembly

14 Cover support brackets

15 DC disconnect switches

17 DC input connection busbar

18 DC input cable glands

19 Positive string fuses and SPD board

20 Negative string fuses board

21 AC connection busbar

22 AC overvoltage SPD

23 PE cable gland

24 Side latches

25 Protective earth point (int.)

27 AC protective shield

28 Communication board

30 Interface signal cables

31 Parallel MPPT connection points

32 Junction screws

Inverter external view

33 Multifunction relay connector (ALARM)

34 RS-485 120Ohm resistance switch (service only)

35 RS-485 120Ohm resistance switch

36 RS-485 connector (RJ45) (Service only)

37 Remote ON/OFF terminal block

38 RS-485 line terminal block

39 Ethernet connector 2 (RJ45)

40 Ethernet connector 1 (RJ45)

41 USB connector

42 SD card slot

43 CR2032 coin battery

50 DC interface cables

51 AC interface cables

52 Removable rear panels

53 DC overvoltage surge arresters (board)

54 Power module front cover

55 Fan tray

56 Multi-core AC panel (opt.)

57 RS-485&Rem.ON/OFF connector (Service only)

58 AC interconnection board

59 DC interconnection board

60 DC protective shield

61 Internal fan

62 Single core AC cable gland

63 Multi-core AC cable gland

64 PE interconnection point

65 Interface signal connectors

1. Reference number index

1.1 Inverter external view

1.2 PVS-100/120-TL ; B2

PVS-100_120-TL_B2

Power module PVS-100/120-TL ; B2

PVS-100_120-TL_B2_S2

64 65

Wiring box with internal cover PVS-100/120-TL ; B2

PVS-100_120-TL_B2

Wiring box without internal cover PVS-100/120-TL ; B2

PVS-100_120-TL_B2_S2

31 28

1.3 PVS-100/120-TL ; B2 ; S2

PVS-100_120-TL_B2_S2

Power module PVS-100/120-TL ; B2 ; S2

PVS-100_120-TL_B2_S2

64 65

Wiring box with internal cover PVS-100/120-TL ; B2 ; S2

PVS-100_120-TL_B2

Wiring box without internal cover PVS-100/120-TL ; B2 ; S2

PVS-100_120-TL_B2_S2

31 28

1.4 PVS-100/120-TL ; B2 ; S(X or Y)

PVS-100_120-TL_B2_S(X-Y)

PVS-100_120-TL_B2

Power module PVS-100/120-TL ; B2 ; S(X or Y)

PVS-100_120-TL_B2_S(X-Y)

64 65

Wiring box with internal cover PVS-100/120-TL ; B2 ; S(X or Y)

PVS-100_120-TL_B2_S(X-Y)

Wiring box without internal cover PVS-100/120-TL ; B2 ; S(X or Y)

PVS-100_120-TL_B2_S(X-Y)

19 28

1.5 PVS-100/120-TL ; B2 ; S(X or Y)2

PVS-100_120-TL_B2_S(X-Y)2

PVS-100_120-TL_B2

Power module PVS-100/120-TL ; B2 ; S(X or Y)2

PVS-100_120-TL_B2_S(X-Y)2

64 65

Wiring box with internal cover PVS-100/120-TL ; B2 ; S(X or Y)2

PVS-100_120-TL_B2_S(X-Y)2

Wiring box without internal cover PVS-100/120-TL ; B2 ; S(X or Y)2

PVS-100_120-TL_B2_S(X-Y)2

Autres manuels pour PVS-100-TL B2

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Fimer Onduleur

Fimer

Fimer PVS-175-TL Manuel utilisateur

Fimer

Fimer UNO-DM-4.0-TL-PLUS-Q Manuel utilisateur

Fimer

Fimer UNO-DM-6.0-TL-PLUS-US-Q Manuel utilisateur

Fimer

Fimer Series R25-R55 Manuel utilisateur

Fimer

Fimer TRIO-5.8-TL-OUTD Manuel utilisateur

Fimer

Fimer PVS-12.5-TL Manuel utilisateur

Fimer

Fimer UNO-DM-1.2 Manuel utilisateur

Fimer

Fimer PVS-175-TL Manuel utilisateur

Fimer

Fimer T 422 Manuel utilisateur

Fimer

Fimer VSN300 Manuel utilisateur

Fimer

Fimer PVS-50.0 Manuel utilisateur

Fimer

Fimer UNO-DM-6.0-TL-PLUS-US-Q Manuel utilisateur

Fimer

Fimer TRIO-20.0-27.6-TL-OUTD-US Manuel utilisateur

Fimer

Fimer REACT2-BATT Manuel utilisateur

Fimer

Fimer UNO-DM 1.2-TL-PLUS-Q Manuel utilisateur

Fimer

Fimer UNO-DM-COM KIT Manuel utilisateur

Fimer

Fimer PVS-166-TL-US Manuel utilisateur

Fimer

Fimer PVS-30-TL Manuel utilisateur

Fimer

Fimer PVS-20-TL-SY Manuel utilisateur

Fimer

Fimer PVS-10-TL Manuel utilisateur

Fimer

Fimer TRIO-20.0-TL-OUTD Manuel utilisateur

Fimer

Fimer UNO-DM-3.3-TL-PLUS-US-Q Manuel utilisateur

Fimer

Fimer PVI-10.0-TL-OUTD Manuel utilisateur

Fimer

Fimer PVS-20-TL Manuel utilisateur

Manuels Onduleur populaires d'autres marques

Fourgroup

Fourgroup Easy Manuel utilisateur

Velleman

Velleman PI300M Manuel utilisateur

Sungrow

Sungrow SG350HX-US Manuel utilisateur

WilTec

WilTec 61897 Manuel utilisateur

SMA

SMA SUNNY BOY STORAGE 2.5 Manuel utilisateur

Simplicity

Simplicity LANDLORD 316 Manuel utilisateur

Santak

Santak SMAX 3000 Manuel utilisateur

ATON

ATON RA.Store-3 Manuel utilisateur

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Manuel utilisateur

Tektronix

Tektronix CFG250 Manuel utilisateur

Champion

Champion 200989 Manuel utilisateur

Vanner

Vanner 20-500 Series Manuel utilisateur

GE GEP Manuel utilisateur

Astrel Group

Astrel Group Power Reducer Guide rapide

MULTIQUIP

MULTIQUIP GDP-5H Mode d’emploi

GoWISE

GoWISE PS1007 Manuel utilisateur

Promate

Promate PM13500D ES Manuel utilisateur

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Manuel utilisateur