Fimap IMx Manuel utilisateur
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
GUIDE INCLUDES
Setting up for use
Using the machine
Cleaning after use
Care & maintenance
Instruction Manual for Fimap iMx
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
1. Choose your
Floor Pad
2. Unscrew the
Centre Cap
3. Attach the Floor
Pad
4. Tighten Centre
Cap
Red
Polished floors and
delicate areas
Blue
As red but slightly more
abrasive for heavier soiled
floors
Green
Heavy duty scrub for safety
flooring
Place the Drive Board on
the floor and unscrew the
centre cap
Remove the centre from
the floor pad and fit to
Drive Board, push to locate
with your thumbs.
Fit and tighten the centre
cap.
DO NOT OVER-TIGHTEN
Setting Up the Machine Before Use
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
5. Pull out the fill-
ing hose
6. Attach filling
hose to tap
7. Fill the tank 8. Add Chemical
Take machine to a tap
Start filling the tank with
cold water
Do not use hot water
Make sure the machine is
back on it’s rear wheels.
Watch the solution tube
and turn off tap when the
tank is full
Take out the chemical
filling container
(Next to the filling hose)
Add the chemical.
Add pour into the tank
Setting Up the Machine Before Use
Warning: Only use low foaming chemicals at the right dilution
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
9. Place Drive
Board on Floor
10.Place Machine
Over Drive Board
11. Switch the
Machine On
12. Engage Drive
Board
Place the drive board on
the floor in front of the
machine with the floor pad
face down as shown
Place the machine over the
drive board and push
handle up
Switch the machine on by
pressing the button above.
Ensure you use the I
setting at the top of the
switch.
Push the handle forward to
engage the drive board.
Squeeze and release the
start D handle three times
to engage
Setting Up the Machine Before Use
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
13. Switch on
vacuum
14. Lower the
Squeegee
15. Switch on
brush motor
16. Start Cleaning
Switch on the vacuum
switch
Lower the squeegee bar
onto the floor by pulling the
release lever on the back
of the machine out and
down
Squeeze the D handle to
start the brush motor
Start moving forward
Setting Up the Machine Before Use
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
Standard Cleaning Deep Cleaning
Part 1
Deep Cleaning
Part 2
For c
For deep cleaning, lift the
squeegee up, then switch
off the vacuum.
Scrub the floor allowing for
contact time for the
solution.
Then lower the squeegee,
switch the vacuum switch
on, switch off the solution
by switch the on switch to
the II setting.
Then move up and down to
pick up the solution.
Using the Machine
Move up and down in straight lines, overlapping
each pass
Always move forwards, do not go backwards with
the squeegee down.
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
1. Emptying Recovery Tank 2. Emptying the Solution
After every use, always empty the recovery
tank and rinse out with clean water
If you need to empty the solution tank, take the
machine to a suitable floor drain.
Unscrew the yellow tank bung in the side.
Allow the solution the drain out.
Clean the filter in the bung before refitting
Cleaning After Use
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
3. Remove and
clean Squeegee bar
4. Check hose 5. Clean bowl filter
cover
6. Check the floor
pad
Take the squeegee bar off
the machine by unscrewing
the two plastic nuts and
drawing the bar backwards
Disconnect the squeegee
hose.
Clean the squeegees
under running water
Refit squeegee bar
Check the squeegee hose.
If needed remove from
machine and flush through
with clean water.
Re-fit hose
Open the recovery tank
and remove the yellow
bowl filter cover and rinse
out.
Tip the machine back onto
the rear wheels.
With the machine switched
on, hold down the release
switch and then squeeze
the D handle once.
The Drive Board will
release
Cleaning After Use
© Copyright A+D Supplies 2017 A+D Supplies, Marsh House, Brunel Road, Newton Abbot, Devon, TQ12 4PB www.adswsupplies.com
1.Check the Battery
charge level
2. Charge Battery
When the batteries are
fully charged and the green
light is showing on the
charger, switch off the
charger and unplug from
the machine.
Re-plug in the machine
main cable connector
IMPORTANT!
ONCE THE BATTERY
HAS STARTED
CHARGING IT MUST
NEVER BE DISTRUPTED
UNTIL THE GREEN LIGHT
SHOWS ON THE
CHARGER
PERMENANT DAMAGE
TO THE BATTERY WILL
OCCUR IF CHARGING IS
DISRUPTED
Turn the machine on and
check the battery level
Try not to charge the
battery if the level is over
50%
To charge the battery
unplug in the main cable
here.
Fit the charger plug in it’s
place, switch on the
charger
Charging Battery and Storage
A+D Supplies
Marsh House
Brunel Road
Newton Abbot
TQ12 4PB
01626 355177
www.adswsupplies.com
Autres manuels pour IMx
1
Table des matières
Autres manuels Fimap Scrubber
Fimap
Fimap MINNY 20 Guide de l'utilisateur
Fimap
Fimap MxL Pro Series Manuel utilisateur
Fimap
Fimap BMg Series Manuel utilisateur
Fimap
Fimap MAGNA Manuel utilisateur
Fimap
Fimap MXR Manuel utilisateur
Fimap
Fimap MAGNA 65 Mode d'emploi
Fimap
Fimap MMg Series Manuel utilisateur
Fimap
Fimap MMX 43B Manuel utilisateur
Fimap
Fimap FS50 H Manuel utilisateur
Fimap
Fimap Maxima Base E Manuel utilisateur
Fimap
Fimap FSR7 PRO Feuille d'instructions
Fimap
Fimap BMg Series Manuel utilisateur
Fimap
Fimap FIMOP Manuel utilisateur
Fimap
Fimap SMG120 B Manuel utilisateur
Fimap
Fimap MAXIMA BASE BT 2017 Manuel utilisateur
Fimap
Fimap MY 16 B Manuel utilisateur
Fimap
Fimap MR65 B Manuel utilisateur
Fimap
Fimap FIMOP Manuel utilisateur
Fimap
Fimap BMg Manuel utilisateur
Fimap
Fimap MY50 Manuel utilisateur
