Field Controls SWG-4HD Manuel utilisateur
www.eldcontrols.com
Please retain these instructions after installation.
This device MUST be installed by a qualied agency in accordance with the manufacturer's installation instructions. The denition of
a qualied agency is: any individual, rm, corporation or company which either in person or through a representative is engaged
in, and is responsible for, the installation and operation of HVAC appliances, who is experienced in such work, familiar with all the
precautions required, and has complied with all the requirements of the authority having jurisdiction.
READ THESE INSTRUCTIONS CAREFULLY AND COMPLETELY BEFORE PROCEEDING WITH THE INSTALLATION.
Installation Date:
Installed By: Phone:
REPAIR MOTOR KIT
Model: SWG-4HD, SWGII-4HD, SWG-5,
SWGII-5, SWG-6, SWGII-6
This kit includes a replacement assembly for the SWG and SWGII series sidewall power
venter models listed above.
NOTE: Before working on power venter, shut o electrical power to control box.
ITEMS INCLUDED:
1- Replacement Motor and Blower Wheel on Mounting Bracket with Mounting Fasteners
1- 1⁄8" Hex wrench
1- Instruction Sheet
P/N 46252300 Rev I 12/21
page 2
Figure 1
ELECTRICAL BOX
WIRE NUTS
ELECTRICAL BOX COVER
Figure 2
IDENTIFY WHICH MODEL POWER VENTER YOU HAVE
CAUTION: Avoid applying excess pressure on the blower wheel when handling. This will cause an imbalance
of the blower wheel which will result in excessive vibration and premature motor failure.
REMOVAL
1. Remove motor cover. (See Figure 1)
2. Remove the electrical box cover and disconnect the conduit and wires. (See Figure 2) It is not necessary
to disconnect the wires from the Control Kit.
3. Remove the nuts securing the motor assembly, and pull the motor assembly straight o of the unit.
(See Figure 3)
4. Clean o any build-up inside the blower wheel housing.
P/N 46252300 Rev I 12/21
page 3
INSTALLATION
1. Align the holes in the circular cover plate with the holes in the motor mount bracket on the motor
assembly. (See Figure 3)
2. Slide the motor assembly onto the protruding threaded studs on the power venter body with the exhaust
chute pointing downward, and replace the nuts securely to the threaded studs. (See Figure 3)
3. Use the top knockout on the electrical box and reattach the exible conduit and wires to the motor using
the conduit connector and wire nuts. Secure the cover on the electrical box.
4. Seal around the edge of the motor mount bracket with high temperature silicone sealant. Install the motor
cover with the side louvers pointing downward. (See Figure 1)
Figure 3
P/N 46252300 Rev I 12/21
Phone: 252.522.3031 • Fax: 252.522.0214
www.fieldcontrols.com
© Field Controls, LLC P/N 46252300 Rev I 12/21
This manual may be downloaded and printed from the Field Controls website (www.eldcontrols.com)
This manual may be downloaded and printed from the Field Controls website (www.eldcontrols.com)
WARRANTY
WARRANTY
For warranty information about this or any Field Controls product, visit:
For warranty information about this or any Field Controls product, visit:
www.eldcontrols.com
www.eldcontrols.com
Field Controls Technical Support
Field Controls Technical Support
1.800.742.8368
1.800.742.8368
eldtec@eldcontrols.com
eldtec@eldcontrols.com
Autres manuels pour SWG-4HD
2
Ce manuel convient aux modèles suivants
5
Table des matières
Autres manuels Field Controls Moteur
