Ferimex Wireless 802.11g Multi-mode AP Manuel utilisateur

User’s Manual

Version: 1.1

Wireless 802.11g Multi-mode AP

Trademarks

Contents are subject to change without notice.

All trademarks belong to their respective proprietors.

THIS DOCUMENT CONTAINS OF PROPRIETARY TECHNICAL INFORMATION THAT IS THE PROPERTY OF

THIS COMPANY. AND NO PART OF THIS DOCUMENTATION MAY BE REPRODUCED, STORED IN A RETRIEVAL

SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRICAL OR MECHANICAL, BY

PHOTOCOPYING, RECORDING, OR OTHERWISE, WITHOUT THE PRIOR WRITTEN CONSENT OF THIS

COMPANY.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference

that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance 20cm between the radiator & your body.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

Table of Contents

REVISION HISTORY .....................................................................................................................I

TERMINOLOGY...........................................................................................................................II

1INTRODUCTION.................................................................................................................... 1

1.1 PACKAGE CONTENTS ............................................................................................................ 1

1.2 PRODUCT SPECIFICATIONS ................................................................................................... 1

1.3 PRODUCT FEATURES ............................................................................................................ 2

1.4 UPPER PANEL DESCRIPTION ................................................................................................. 3

1.5 REAR PANEL DESCRIPTION................................................................................................... 4

2INSTALLATION ..................................................................................................................... 5

2.1 HARDWARE INSTALLATION .................................................................................................. 5

2.2 SOFTWARE INSTALLATION.................................................................................................... 5

3SOFTWARE CONFIGURATION ......................................................................................... 6

3.1 PREPARE YOUR PC TO CONFIGURE THE WLANACCESS POINT............................................ 6

3.2 CONNECT TO THE WLANACCESS POINT............................................................................. 8

3.3 MANAGEMENT AND CONFIGURATION ON THE WLANACCESS POINT .................................. 8

3.3.1 Status.......................................................................................................................... 8

3.3.2 Setup Wizard.............................................................................................................. 9

I LAN Interface Setup.................................................................................................... 10

II Wireless Basic Settings................................................................................................ 11

III Wireless Security Setup ........................................................................................... 12

3.3.3 Wireless - Basic Settings.......................................................................................... 12

3.3.4 Wireless - Advanced Settings .................................................................................. 14

3.3.5 Wireless - Security Setup......................................................................................... 15

I WEP Key Setup ........................................................................................................... 17

3.3.6 Wireless - Access Control........................................................................................ 18

3.3.7 WDS Settings........................................................................................................... 20

I WDS Security Setup.................................................................................................... 21

II WDS AP Table............................................................................................................. 21

3.3.8 Site Survey............................................................................................................... 22

3.3.9 TCP/IP Settings........................................................................................................ 23

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

3.3.10 Log........................................................................................................................... 25

3.3.11 Statistics................................................................................................................... 26

3.3.12 Upgrade Firmware................................................................................................... 27

3.3.13 Save/ Reload Settings .............................................................................................. 27

3.3.14 Password Setup........................................................................................................ 28

3.3.15 Logout...................................................................................................................... 29

4FREQUENTLYASKED QUESTIONS (FAQ).................................................................... 30

4.1 WHAT AND HOW TO FIND MY PC’S IPAND MACADDRESS?............................................... 30

4.2 WHAT IS WIRELESS LAN? ................................................................................................. 30

4.3 WHATARE ISM BANDS? .................................................................................................... 30

4.4 HOW DOES WIRELESS NETWORKING WORK?....................................................................... 30

4.5 WHAT IS BSSID?............................................................................................................... 31

4.6 WHAT IS ESSID? ............................................................................................................... 31

4.7 WHATARE POTENTIAL FACTORS THAT MAY CAUSES INTERFERENCE? ................................. 32

4.8 WHATARE THE OPEN SYSTEM AND SHARED KEYAUTHENTICATIONS? .............................. 32

4.9 WHAT IS WEP?.................................................................................................................. 32

4.10 WHAT IS FRAGMENT THRESHOLD?..................................................................................... 32

4.11 WHAT IS RTS (REQUEST TO SEND)THRESHOLD?.............................................................. 33

4.12 WHAT IS BEACON INTERVAL?............................................................................................. 33

4.13 WHAT IS PREAMBLE TYPE?................................................................................................ 34

4.14 WHAT IS SSID BROADCAST? ............................................................................................. 34

4.15 WHAT IS WI-FI PROTECTED ACCESS (WPA)? .................................................................... 34

4.16 WHAT IS WPA2?................................................................................................................ 35

4.17 WHAT IS 802.1X AUTHENTICATION? .................................................................................. 35

4.18 WHAT IS TEMPORAL KEY INTEGRITY PROTOCOL (TKIP)? ................................................. 35

4.19 WHAT IS ADVANCED ENCRYPTION STANDARD (AES)? ...................................................... 35

4.20 WHAT IS INTER-ACCESS POINT PROTOCOL (IAPP)?........................................................... 35

4.21 WHAT IS WIRELESS DISTRIBUTION SYSTEM (WDS)?......................................................... 36

4.22 WHAT IS CLONE MACADDRESS?...................................................................................... 36

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

Revision History

ATE R

EVISION OF USER’S MANUAL FIRMWARE

2006/5/19 First release (Version 1.0) a1.4.0

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

Terminology

AES Advanced Encryption Standard

ANSI American National Standards Institute

AP Access Point

CCK Complementary Code Keying

CSMA/CA Carrier Sense Multiple Access/ Collision Avoidance

CSMA/CD Carrier Sense Multiple Access/ Collision Detection

DHCP Dynamic Host Configuration Protocol

DSSS Direct Sequence Spread Spectrum

EAP Extensible Authentication Protocol

ESP Encapsulating Security Payload

FCC Federal Communications Commission

IEEE Institute of Electrical and Electronic Engineers

IP Internet Protocol

ISM Industrial, Scientific and Medical

LAN Local Area Network

MAC Media Access Control

NT Network Termination

PSD Power Spectral Density

RF Radio Frequency

SNR Signal to Noise Ratio

SSID Service Set Identification

TCP Transmission Control Protocol

TFTP Trivial File Transfer Protocol

TKIP Temporal Key Integrity Protocol

WDS Wireless Distribution System

WEP Wired Equivalent Privacy

WLAN Wireless Local Area Network

WPA Wi-Fi Protected Access

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

1Introduction

The Wireless LAN Access Point is an affordable IEEE 802.11b/g wireless LAN Access Point

solution; setting SOHO and enterprise standard for high performance, secure, manageable and

reliable WLAN.

This document describes the steps required for the initial IP address assign and other WLAN

router configuration. The description includes the implementation of the above steps.

1.1Package contents

The package of the WLAN Access Point includes the following items,

9The WLAN Access Point

9The AC to DC power adapter

9The Documentation CD

1.2Product Specifications

Product Name Wireless 802.11g Multi-modeAP

Standard 802.11b/g(Wireless), 802.3(10BaseT), 802.3u(100BaseT)

Data Transfer Rate 54Mbps(Wireless), 100Mbps(Ethernet)

Modulation Method CCK(802.11b), OFDM(802.11g)

Frequency Band 2.4GHz – 2.497GJz ISM Band, DSSS

RF Output Power CCK< 17 dBm, OFDM< 13.5 dBm

Receiver Sensitivity 802.11b -80 dBm@8%, 802.11g -68 dBm@5%

Operation Range 30 to 280 meters (depend on surrounding)

Antenna External Antenna

LED Power, Active (WLAN/Ethernet)

Security 64 bit/ 128 bit WEP, WPA, WPA2

LAN interface One 10/100BaseT with RJ45 connector

Power Consumption 7.5V DC Power Adapter

Operating Temperature 0 ~ 50oC ambient temperature

Storage Temperature -20 ~ 70oC ambient temperature

Humidity 5 to 90 % maximum (non-condensing)

Dimension 118 x 75 x 25 mm

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

1.3Product Features

¾Complies with IEEE 802.11b/g standard for 2.4GHz Wireless LAN.

¾Supports AP/Client/WDS/AP+WDS modes on wireless interfaces.

¾Supports 64-bit and 128-bit WEP, WPA, WPA2 encryption/decryption function to

protect the wireless data transmission.

¾Supports IEEE 802.1x Authentication.

¾Support Wi-Fi Protected Access Authentication with Radius and Pre-Shared Key

mode.

¾Supports Inter-Access Point Protocol (IAPP).

¾Supports Wireless Distribution System (WDS).

¾Supports IEEE 802.3x full duplex flow control on 10/100M Ethernet interface.

¾Supports DHCP server to provide clients auto IP addresses assignment.

¾Supports DHCP client auto IP address assignment from ISP.

¾Supports clone MAC address function.

¾Supports WEB based management and configuration.

¾Supports Log table and remote Log service.

¾Support Setup Wizard mode.

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

1.4Upper Panel Description

Figure 1 –WLAN Access Point Upper Panel

LED Indicator State Description

1. Power LED On The WLAN Access Point is powered on.

Off The WLAN Access Point is powered off.

2. WLAN LED Flashing Data is transmitting or receiving on the

antenna.

Off No data is transmitting or receiving on the

antenna.

3. LAN LED

ACT Flashing Data is transmitting or receiving on the LAN

interface.

On Port linked.

Off No link.

Power LED

WLAN LED

LAN LED

USER’S MANUAL OFWLAN ACCESS POINT Version: 1.1

1.5Rear Panel Description

Figure 2 – WLANAccess Point Rear Panel

Interfaces Description

1. Antenna

(Fixed / SMA)

The Wireless LAN Antenna.

2. Power The power jack allows an external DC +7.5 V power supply

connection.

The external AC to DC adaptor provide adaptive power

requirement to the WLAN Access Point.

3. LAN The RJ-45 sockets allow LAN connection through Category 5

cables. Support auto-sensing on 10/100M speed and half/ full

duplex; comply with IEEE 802.3/ 802.3u respectively.

4. Reset Push continually the reset button 5 ~ 10 seconds to reset the

configuration parameters to factory defaults.

LAN

Powe

Antenna

Reset

Table des matières

Autres manuels Ferimex Point d'accès sans fil

Ferimex

Ferimex FX-551 5Ghz Manuel utilisateur

Manuels Point d'accès sans fil populaires d'autres marques

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Manuel utilisateur

Ubiquiti

Ubiquiti NanoStation NSM2 Manuel utilisateur

Cisco

Cisco Aironet 1550 Series Manuel utilisateur

Aruba

Aruba IAP-335 Manuel utilisateur

Advantek Networks

Advantek Networks AWN-AP-54MR Manuel utilisateur

IP-COM

IP-COM AP355 Manuel utilisateur

Buffalo

Buffalo AirStation WLA-L11G Manuel utilisateur

EnGenius

EnGenius EnStationACv2 Manuel utilisateur

D-Link

D-Link DAP-3662 Manuel utilisateur

xG Technology

xG Technology xMax CN1300 Manuel utilisateur

Widelink

Widelink ezWave WAP-1100 Series Manuel utilisateur

Edimax

Edimax CAP1200 Manuel utilisateur

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Manuel utilisateur

Aruba

Aruba AP-203R Manuel utilisateur

LuXout Shades

LuXout Shades LUXSHADE MOTION Manuel utilisateur

CreatComm

CreatComm TB5F Manuel utilisateur

SineDigital

SineDigital MW-1500AP(H) Manuel utilisateur

TP-Link

TP-Link AP9650 V1 Manuel utilisateur