Febo Flame 16IN-32-E Manuel utilisateur
PAGE 1 OF 17
User Manual
STOCK# 384-15A-20-33B
MODEL# 16IN-32-E
EASY TOP (HK) ENTERPRISES LIMITED
524 South Main St, Joplin, MO 64801
TOLL FREE: 1-866-949-3838 EMAIL: [email protected]
!
!
PLEASE READ THIS MANUAL CAREFULLY FOR ELECTRIC FIREPLACE INSERT BEFORE INSTALL AND USE.
PLEASE DO NOT RETURN ANY PRODUCT TO STORE. FOR ANY MISSING PARTS, HARDWARE OR ASSEMBLY
PROBLEMS, PLEASE CONTACT WITH OUR CUSTOMER SERVICE CENTER.
ELECTRIC FIREPLACE INSERT USER MANUAL
PAGE 2 OF 17
WARNING: Any use of this appliance other than that recommended by the manufacturer in this owners manual
may cause fire, burns, electric shock and/or other serious injuries or death.
SAVE THESE INSTRUCTIONS
When using electrical appliance, basic precautions should always be followed to avoid the risk of fire, electric
shock and injury to persons including the following:
1 . Read all instructions before using this appliance.
2. This appliance is hot when in use. To avoid burns, do not let bare skin touch hot surface. If provided, use
handles when moving this appliance. Keep combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains, etc. at least 3 feet (0.9 meter) away from the front of the appliance. Keep all
items away from the sides and rear.
3. Extreme caution is necessary when the appliance is used by or near children or invalids and whenever the
appliance is left operating and unattended.
4. Always unplug appliance when not in use. This unit should be operate under supervision and should
not be left on without supervision.
5. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, has been
dropped or damaged in any manner. Return appliance to authorized service facility for examination,
electrical or mechanical adjustment or repair.
6. Do not use outdoors.
7. This appliance is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate
appliance where it may fall into a bathtub or other water container.
8. Do not run cord under carpeting. Do not cover the power cord with throw rugs, runners, or similar floor
coverings. Arrange cord away from traffic area and where it will not be tripped over.
9. To disconnect the appliance, turn all controls “OFF”, then remove the plug from the electrical outlet.
10. Connect to properly grounded outlets only.
11. Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause an
electric shock or fire, or damage the appliance.
12. To prevent a possible fire, do not block air intakes or exhausts in any manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
13. All electrical appliances have hot and arching or sparking parts inside. Do not use in areas where gasoline,
paint, or flammable liquids are used or stored.
14. Use this appliance only as described in this manual. Any other use which is not recommended by the
manufacturer may cause fire, electric shock, or injury to persons.
1 5 . It is strongly recommended that to use the entire 15 amp outlet for the electric fireplace only. Sharing
the outlet with another electronic item could create overload and damage the outlet and electric items in the
long term.
16. Avoid using an extension cord because the extension cords may overheat and cause a risk of fire. However,
If an extension cord MUST be used, the cord must be No. 14AWG minimum size and rated not less than
1875 Watts. The extension cord must be a 3-prong cord with grounding type plug and cord connection and
should not exceed 20’ (6m) in length.
17. When transporting or storing the appliance, keep both the unit and power cord / plug dry, free from excessive
vibration and away from heat sources to avoid causing fire, electric shock, or injury to persons.
18. Do not attempt to burn wood or other materials in this appliance.
19. This appliance, when installed must be electrically grounded in accordance with the current.
Canada: CSA C22.1, Canadian Electrical Code
U.S.A.: ANSI/NFPA NO. 70, National Electrical Code
IMPORTANT SAFETY INSTRUCTION
PAGE 3 OF 17
INSERT OPERATING INSTRUCTIONS
Read all instructions and warning prior to
operating the appliance.
1. Ensure that all controls are in the “OFF” status
before plugging the appliance into a properly
grounded electrical outlet.
This appliance is for use on 120 Volts. The
appliance has a 3-prong grounded plug. If your
electrical outlet has only 2 slots, you will have to
use an adapter to convert from the 3-prong power
cord to a 2-slot receptacle. The green grounding
plug extending from the adapter must be securely
connected to a permanent ground such as a
properly grounded outlet box. The adapter should
only be used if a proper 3-slot receptacle is not
available.
NOTE: Adapters are not allowed for use in
Canada.
!
Figure 1
2. A 15 AMP circuit is required to operate this
appliance. If the breaker trips when the appliance
is running, you may need to move the appliance to
another location or unplug other appliances that
are on the same circuit.
The fireplace control functions can be accessed in
two ways:
- Using the button control panel,
located in the upper right-hand
corner of the fireplace
- Using the multifunction remote
control
The main control panel is located at the top right
corner on the front (see Figure 2).
Insert Control Panel
Figure 2
1
2
Display
Screen
Bluetooth: SOUND SYSTEM
WiFi: ELECTRIC FIREPLACE
PAGE 4 OF 17
INSERT OPERATING INSTRUCTIONS
3. If you press any button (except POWER) on the
control panel or on the remote control, the display
screen will flip down and display all the functions of
the electric insert within 3 seconds. Without further
operation, the display screen will automatically flip
back up after 20 seconds.
Figure 3
Figure 4
3
4
4. Power: Push button to turn on or turn off. If
OFF, Heather will be restored at the next power
ON.
Note: Unplugging the unit will reset all
functions.
PAGE 5 OF 17
INSERT OPERATING INSTRUCTIONS
5. Flame: Press to activate the flame function. This
button controls the brightness of flame and ember
effect. When the fireplace is first turned on, the
flame will come in at the highest setting; press
DOWN or UP button to adjust the brightness of
flame. There are 6 levels you can cycle through,
including the OFF setting (the ember remains on.)
When adjusting the flame brightness with UP and
DOWN button, the number of the flam level bars
corresponds to the 5 brightness levels. When this
feature is on, display screen FLAME icon is on
also.
Figure 5
Figure 6
5
6
6. Heater: Press to activate the heater function.
The system will start the temperature setting at
95F. There are 7adjustable heat levels, ranging
from 65F to 95F. Press the DOWM or UP button to
adjust the levels, noting each level increases or
decreases the temperature by 5F. When this
feature is on, display screen HEATHER icon also.
And when this feature is off, the inner blower will
continue to run for additional 1 minutes to cool
down the unit order to protect the heating elements
before the unit completely shuts off.
Note: You can switch the temperature display
from Fahrenheit to Celsius by pressing and
holding the HEATER button control panel for
approximately 6 seconds, the display screen
will show the room temperature.
PAGE 6 OF 17
INSERT OPERATING INSTRUCTIONS
7. Timer: Press once to activate. Press UP and
DOWN button to adjust the timer. The choices are
between 0.5H to 8H interval. Once the timer is on
an the desired setting is reached, the system will
shut down.
Figure 7
Figure 8
7
8
8. Child Lock: Press and hold the button for 6
seconds to activate the function. When the CHILD
LOCK is on, all the other features are disabled.
Press and hold the button again for 6 seconds to
unlock the functions.
PAGE 7 OF 17
INSERT OPERATING INSTRUCTIONS
9. Down: Use to turn down the heat, brightness of
flame or timer. When FLAME / HEATER / TIMER is
not activated, this button will not work.
Figure 9
Figure 10
9
8
10. Up: Use to turn up the heat, brightness of flame
or timer. When FLAME / HEATER / TIMER is not
activated, this button will not work.
PAGE 8 OF 17
SOUND SYSTEM OPERATING INSTRUCTIONS
11. Connect the electric insert to the sound system
amplifier module with connection cable #1.
Figure 11
11
12
12. Connect the cable #2 and plug into the wall
outlet.
Figure 12
PAGE 9 OF 17
SOUND SYSTEM OPERATING INSTRUCTIONS
13. Turn the sound system amplifier moduleʼs
switch on.
Figure 13
13
14
14. The sound system amplifier module has a RCA
line-in for TV to connect to. The RCA cable is not
included and this is an optional setup.
Figure 14
PAGE 10 OF 17
SOUND SYSTEM OPERATING INSTRUCTIONS
15. A 15 AMP circuit is required to operate this
appliance. If the breaker trips when the appliance
is running, you may need to move the appliance to
another location or unplug other appliances that
are on the same circuit.
The sound system control functions can be
accessed in two ways:
- Using the button control panel,
located in the upper left-hand
corner of the fireplace
- Using the multifunction remote
control
The sound system control panel is located at the
top left corner on the front (see Figure 16).
Plug the electric insert to the outlet before
operating the sound system. Figure 15
Figure 16
15
16
16. Power: Press button to turn on or turn off.
When the sound system is first turned on, the
ember is blue.
If OFF, sound system will be restored at the next
power ON.
Note: Unplugging the unit will reset all
functions.
Sound System Control Panel
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels Febo Flame Cheminée intérieure
Febo Flame
Febo Flame F16-I-006-089 Manuel utilisateur
Febo Flame
Febo Flame CYFPINS01 Manuel utilisateur
Febo Flame
Febo Flame ZHS-32-D Manuel utilisateur
Febo Flame
Febo Flame ZHS-32-F Manuel utilisateur
Febo Flame
Febo Flame F18-I-008-018C Manuel utilisateur
Febo Flame
Febo Flame 18IN-23-130 Manuel utilisateur
Febo Flame
Febo Flame F19-C-041-138 Manuel utilisateur
Febo Flame
Febo Flame 17IN-42-118 Manuel utilisateur
