FCI MagicRound ASD-0001 Manuel utilisateur
P a g e | 1
MagicRound Automatic Soap
Dispenser
ASD-0001
Installation Manual
Quality Guarantee
*Thank you for choosing the automatic wall mount soap dispenser. Please
read the instruction carefully before installation. This manual is for your
reference only.
P a g e | 2
Features
•Hands free sensor operation improves
hand washing hygiene.
•Easy installation and low-cost
maintenance
•Battery powered.
•Stainless steel finish
•Suitable for schools, offices,
supermarkets, hospitals, and other high-
volume facilities
Specifications
Power
Supplied 9V (6 x AA Alkaline
batteries)
Sensing Range
5 –15 cm
Soap Vol per
Drop
1 ml
Soap Bottle
Volume
650 ml
Ambient
Temperature
1 –45 oC
P a g e | 3
Before Installation
•Locate position of soap dispenser.
•Ensure that soap dispenser does not
interfere with anything above the
lavatory/counter or shining surface top
area. Must be installed 250 mm above the
counter.
•Pay special attention so that the sensor
surface is not flawed or scratched during
the installation process.
•Before installing on the wall, check that no
other piping and wiring is running behind
hole locations. Wall should be sufficiently
reinforced or risk failure due to soap case
unit falling.
•Do not place other devices that use an
inverter or infrared sensor near the faucet,
as this may cause the faucet to
malfunction.
P a g e | 4
Tools You will Need
•Power drill with 6 mm wall drill bit
•Flat head screwdriver
•Phillips screwdriver
•Ruler/tape
measure
P a g e | 5
Part List
P a g e | 6
Construction /
Installation Diagram
i. Using the supplied black plastic
key, open & remove the upper
cover.
ii. Disconnect the battery power and
remove the battery holder
iii. Using a Philips screw driver remove
the upper right-hand Phillips screw
and remove the steel wall mount
plate (wall build-up frame).
iv. Use the steel plate as a guide,
mark where holes need to be
drilled. Important: Make sure
bracket and case unit is mounted
level.
v. When installing onto a concrete
wall, drill holes 30 mm deep using a
6 mm masonry drill bit. Insert wall
anchors into the holes and mount
the plate using the screws.
vi. Slide & assemble the dispenser
onto the plate tongues, ensuring
the dispenser is secured by the two
tongues.
P a g e | 7
vii. Remove the white plastic cap & fill
the soap cartridge with soap. Do
not overfill the soap cartridge to the
top the cap.
viii. Assemble back the battery holder
and tighten the holder onto the
upper cover.
ix. Connect the battery power cable.
x. Place & close the upper cover onto
the dispenser.
xi. Remove the white sensor film from
underneath the sensor.
P a g e | 8
P a g e | 9
Operations
As the user’s hands enter below the beam’s
effective range (5 –15 cm), the beam is reflected
back into the sensor receiver and activates the
solenoid valve allowing a single soap application
to flow from the dispenser.
P a g e | 10
Soap Volume
Adjustment
No adjustments are required for most settings.
Factory default soap volume is 1 ml. The factory
setting should be satisfactory for most
installations.
To invoke the volume adjustment, press the
button below the dispenser and hold it until the
LED starts flashing slowly, about five seconds.
Press the button again and hold until the LED
flashes for approximately 5 seconds and flashing
continuously.
Place a medium target such as small card board
under the dispenser nozzle until the desired
volume has been reached. Remove the target to
complete setup.
Ce manuel convient aux modèles suivants
1
Table des matières
Autres manuels FCI Distributeur
