FBS C12 Manuel utilisateur

C ution:

Wire devices in accordance

with the NEC.

If you are not sure about ex-

isting conductor wires, color

coding, polarity and circuit

feed contact a licensed

electrician.

Wrning:

o be installed and/or used

in accordance with appro-

priate electrical codes and

regulations.

Wrning:

o avoid fire, electrical

shock and/or electrocution

turn power OFF at the cir-

cuit breaker before wiring.

IMPOR AN : Please read carefully the following instructions before beginning.

OLD WORK

Unscrew the four screws at the

bottom of the box to remove

leveling feet.

2 3

Wire devices in accordance with the NEC.

Attach faceplates to mounting panels.

C12 - Ins t ll tion I nstructions -

4 5 Once con-

crete has

cured, remove

temporary

cover. Locate

and pull wires.

Hand toweling near box edges is suggested once

concrete has been poured.

Attach conduits to the selected

knockouts.

Install temporary cover to pre-

vent debris from entering the

box during concrete pour. Duct

tape any cracks or seams

where concrete may enter.

Fix and secure box to the floor

using concrete mix.

Add concrete mixture below

and around box (if necessary)

to level the box in accordance

to the final floor level desired.

Install the desired floor covering material (ter-

razzo, tile, limestone,carpet, etc) on the floor.

Determine box location and

position in accordance to floor

plans.

Adjust the leveling screws until

the desired level is met.

FBS FLOOR BOX SYS EMS

25060 Hancock Ave

S E 103-125

Murrieta, CA 92562

1-800-216-8307

Questions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.com

9 10

Installation Complete.Secure the cover to the box using the

four supplied screws.

Before installing the cover, apply a gener-

ous amount of silicone caulk around the

opening of the floor box (where the flange

sits) . Verify that all the perimeter has

been properly sealed.

Leveling the Box

CORRECT

ile or

Carpet

When a floor covering thickness is known in advance

(tile, wood, carpet), estimating level to obtain a floor cov-

ering flushed with floor box is suggested (as shown on

the figure above) However it is not completely necessary

When concrete is flushed with box, the

cover can be applied.

When concrete is over poured, the cover

can still be applied. Avoid this situ tion

***INCORRECT***

Concrete

Floor Box

ile

Floor Box Cover

Non-Beveled Cover Inst ll tion

C12 - Ins t ll tion I nstructions -

1) Depending on the thickness of

the floor covering material, level the

box as necessary to obtain a flush

finish between the cover and the

final floor level as shown on the illus-

tration.

2) Before installing the cover, apply

a generous amount of silicone caulk

around the opening of the floor box.

Verify that all the perimeter has been

properly sealed.

3) Secure the cover to the box using

the four supplied screws.

FBS FLOOR BOX SYS EMS

25060 Hancock Ave

S E 103-125

Murrieta, CA 92562

1-800-216-8307

Questions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.comQuestions? 1.800.216.8307 www.FloorBoxSystems.com

Autres manuels FBS Décodeur

FBS

FBS C01 Manuel utilisateur

Manuels Décodeur populaires d'autres marques

peerless-AV

peerless-AV IBA2 Mode d’emploi

Extron electronics

Extron electronics Cable Cubby 1202 Manuel utilisateur

peerless-AV

peerless-AV IBA3AC Mode d’emploi

Channel Vision

Channel Vision AFFINITY P-0328 Manuel utilisateur

Minebea Intec

Minebea Intec IE11357 Manuel utilisateur

StarTech.com

StarTech.com BOX4CABLE Manuel utilisateur

Commercial Electric

Commercial Electric 5053-WH Manuel utilisateur

Motorola

Motorola DCT6412 DUAL-TUNER DVR AND HD SET-TOP - MICROSOFT... Instructions de montage

Renkforce

Renkforce 1395556 Manuel utilisateur

Huawei

Huawei FAT9102SD-32G Manuel utilisateur

VISSEM Electronics

VISSEM Electronics Opticube VSOF-OTB-E Manuel utilisateur

Beta

Beta 1844 15-H05/SCK Manuel utilisateur

FSR

FSR FL-1550 Manuel utilisateur

Renkforce

Renkforce 1674559 Manuel utilisateur

Minebea Intec

Minebea Intec PR 6130/64Sa Manuel utilisateur

KS Tools

KS Tools efuturo Wallbox Manuel utilisateur

Chatsworth Products

Chatsworth Products Evolution Manuel utilisateur

Minebea Intec

Minebea Intec Weighbridge PR 6021/68S Manuel utilisateur