Fantech HV-150CAP Manuel utilisateur

Part No INST-HVCAP 7/07/2008

1 of 3

HV Stylvent Weather Cap

Instructions Installation

Contents:

Check that your HV-Weather Cap contains

• Weather Cap (1).

• Weather Cap Mounting Screws (3 for HV-150CAP and HV-230CAP), (4 for HV-300CAP).

• M4 Nuts and Washers (3 for HV-150CAP and HV-230CAP), (4 for HV-300CAP).

• White mounting tabs (3 for HV-150CAP and HV-230CAP), (4 for HV-300CAP).

Inspection:

Before installing check both your HV Stylvent fan and Weather Cap for any transit damage.

Installation:

• Cut a hole following the dimensions in Fig. A.

(mm) HV-150 HV-230 HV-300

∅D

Min 187 259 327

∅D

Max 190 262 330

• Preparing The HV-Fan:

1. Remove the cover (a) by unscrewing the retaining screw (b) found on the bottom of the fan. Then

press the tabs (c) and lift off the cover.

2. To remove the external grille (e) from the fan backing plate (f) unscrew the plastic fasteners (d). Note

the HV-150 and HV-230 have 3 fasteners whereas the HV-300 has 4.

Part No INST-HVCAP 7/07/2008

2 of 3

• Preparing The Weather Cap:

1. Remove the rubber moulded grommets (g) from the grille fastening screws (h). Keep the grommets as

they are required for installing the Weather Cap. Discard the external grille (e) with its screws (h)

which will now be replaced by the Weather Cap.

2. Put the

Weather Cap Mounting Screws

(p), into the holes within the collar section of the Weather Cap

from the inside so the screws point out toward you. Slide on the rubber grommets (g) with the flat side

up, then the white tabs (n), the washers (o) and hold them in place with the nuts (r) leave the nuts

loose for now.

• Installing The Weather Cap and Fan:

1. Make sure the rubber grommets and tabs are turned inward as shown (below).

2. From the outside put the cap over the hole in the window/panel. Make sure you mount the cap the

correct way up, the label located on the collar of the Weather Cap indicates the top of the cap.

o p

Data

Label

Part No INST-HVCAP 7/07/2008

3 of 3

3. From the inside rotate the rubber grommets (g) and white tabs (n) outward over the window or panel.

Tighten the nuts (r) so the cap is held firmly in place. Caution Do Not Over Tighten Nuts, a small

amount of movement in the rubber grommet is needed so the screws can be lined up when attaching

the fan.

4. Mount the fan backing plate (f) to the

Weather Cap Mounting Screws

(p) and tighten the fasteners (d).

Note the orientation of the fasteners will depend on the thickness of the installation.

- For Window or Panel 3-14mm Thick refer to (d) circled in Fig. B.

- For Wall Mounting 14-25mm Thick refer to (d) circled in Fig. C.

3. For wiring instructions see your HV-Fan instruction leaflet

4. Mount the internal cover (a) by slotting the rectangular openings (l) on top of the cover into the

receivers (m) of the fan mounting plate until the two tabs (c) are correctly positioned. Then replace the

locking screw (b)

HV Weather Caps Are Distributed By Fantech Pty Ltd.

Ph:(03)8545 2345 Fax:(03)8545 2333 e-mail [email protected]

Window Or Panel

n g

fig. B fig. C

c b

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Fantech Ventilateur

Fantech

Fantech VHR150 Manuel utilisateur

Fantech

Fantech 150H-EC Manuel utilisateur

Fantech

Fantech Ezifit Thru Wall EWE152 Manuel utilisateur

Fantech

Fantech FX Series Manuel utilisateur

Fantech

Fantech RIL-100 Instructions d'installation et d'utilisation

Fantech

Fantech Fit 120H Manuel utilisateur

Fantech

Fantech SER 1504N Manuel utilisateur

Fantech

Fantech RE(C) 54 Manuel utilisateur

Fantech

Fantech PBH4 Manuel utilisateur

Fantech

Fantech FR Series Manuel utilisateur

Fantech

Fantech SHR 1504 Manuel utilisateur

Fantech

Fantech Serenity Series Manuel utilisateur

Fantech

Fantech Ezifit Thru Roof ERV200 Manuel utilisateur

Fantech

Fantech VHR 704 Manuel utilisateur

Fantech

Fantech PB Series Manuel utilisateur

Fantech

Fantech VER150 Manuel utilisateur

Fantech

Fantech FADE Series Manuel utilisateur

Fantech

Fantech SHR series Manuel utilisateur

Fantech

Fantech FIT 120E Manuel utilisateur

Fantech

Fantech FQ80 Manuel utilisateur

Fantech

Fantech SHR 1504 Manuel utilisateur

Fantech

Fantech ERV-WI 500 Manuel utilisateur

Fantech

Fantech PBW Series Manuel

Fantech

Fantech SER150 Manuel utilisateur

Manuels Ventilateur populaires d'autres marques

ELTA FANS

ELTA FANS H03VV-F Manuel utilisateur

Hunter

Hunter 20714 Manuel d'instructions

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manuel utilisateur

Hunter

Hunter Caraway Manuel d'instructions

Panasonic

Panasonic FV-15NLFS1 Manuel utilisateur

Kompernass

Kompernass KH 1150 Manuel utilisateur

VES

VES FALA100/12V/TR Manuel utilisateur

Vertiv

Vertiv Liebert DCD Manuel utilisateur

Westinghouse

Westinghouse GFP Series Manuel utilisateur

Venmar

Venmar KUBIX HRV PLUS Series Manuel utilisateur

Maico

Maico ECR 31 Manuel utilisateur

Sonnenkonig

Sonnenkonig Dinky Manuel utilisateur

S&P

S&P ECOWATT HXBR Manuel utilisateur

Wider

Wider IMP03369BH Manuel utilisateur

Panasonic

Panasonic F-60DHN Manuel utilisateur

Hinkley

Hinkley HIGHLAND Manuel utilisateur

Broan

Broan 766BN Manuel utilisateur

Premium

Premium PFS16022 Instructions de montage