Extron electronics Extron P/2 DA2xi Manuel utilisateur

Setup Guide — P/2 DA2xi

This guide provides basic instructions for an experienced

installer to set up and operate the Extron P/2 DA2xi.

Installation

The P/2 DA2xi is a high performance one input, two

output distribution ampliﬁer that accepts video input from

a VGA-QXGA compatible PC and distributes that signal to separately buffered outputs. See

the following application diagram.

Extron

P/2 DA2xi

VGA Distribution Amplier

Projector

INPUT

Extron

VGA Cable

Up to 250 feet (76 m)

CInstallation and service must be performed by authorized personnel only.

Step 1 — Power down

Power off the display device, the PC, and the PC’s local monitor.

Step 2 — Connect input

Connect the PC’s VGA output to the 15-pin HD Input on the front panel of the P/2 DA2xi

distribution ampliﬁer.

Step 3 — Connect outputs

• Connect the PC’s monitor to the Local Monitor 15-pin HD output connector of the

P/2 DA2xi.

• Connect the display device to the Output 15-pin HD connector of the P/2 DA2xi.

Step 4 — Set DIP switches

Set DIP switches 1 and 2 for input and output impedance and set DIP switch 3 for

gain/peaking:

Switch1(syncinputimpedance) – Default setting is down

(510 ohms). If the image from a laptop computer becomes unstable, slide the switch

up (10k ohms).

Switch2(syncoutputimpedance) – Default setting is up (50 ohms). If the front LED

is green and all the input and output cables are properly connected, but there is no

image at the projector, slide the switch down (75 ohms).

Switch3(videogain/peaking) – Slide the switch down (off) if the output cable

length is under 100 feet (30 m). Slide the switch up (on) if the output cable length is

over 100 feet (30 m).

NThe gain/peaking switch does not affect the local monitor output.

(Continued on reverse side)

OFF

1 2 3

Setup Guide — P/2 DA2xi

Extron USA - West

Headquarters

+800.633.9876

Inside USA / Canada Only

+1.714.491.1500

+1.714.491.1517 FAX

Extron USA - East

+800.633.9876

Inside USA / Canada Only

+1.919.863.1794

+1.919.863.1797 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+400.883.1568

Inside China Only

+86.21.3760.1568

+86.21.3760.1566 FAX

Extron Middle East

+971.4.2991800

+971.4.2991880 FAX

68-1239-50

Rev. A

01 10

Step 5 — Power up

Connect the power supply cord of the P/2 DA2 Plus to a 100 to 240 VAC power source and

power up the local monitor, PC, and display device.

CAlways use a power supply speciﬁed by Extron for the

P/2 DA2xi. Use of an unauthorized power supply voids all

regulatory compliance certiﬁcation and may cause damage to the

power supply and the P/2 DA2xi.

Power Supply

Output Cord

Captive Screw

Connector

SECTION A–A

Ridges

Smooth

A A

Tie Wrap

CPower supply voltage polarity is critical. Incorrect voltage polarity can

damage the power supply and the P/2 DA2xi. Identify the power cord

negative lead by the ridges on the side of the cord.

Operation

After the P/2 DA2xi and its connected devices are powered up, the system is fully operational.

If any problems are encountered, verify that the cables are routed and connected properly.

Autres manuels pour Extron P/2 DA2xi

Table des matières

Autres manuels Extron electronics Amplificateur

Extron electronics

Extron electronics DA2 RGBHV Manuel utilisateur

Extron electronics

Extron electronics XPA Ultra Series Manuel utilisateur

Extron electronics

Extron electronics P/2 DA2xi MT Manuel utilisateur

Extron electronics

Extron electronics NetPA Ultra Series Manuel utilisateur

Extron electronics

Extron electronics HDMI DA2 Manuel utilisateur

Extron electronics

Extron electronics DP DA2 Manuel utilisateur

Extron electronics

Extron electronics FOX 500 DA6 Manuel utilisateur

Extron electronics

Extron electronics IN3254 Manuel utilisateur

Extron electronics

Extron electronics HDMI DA4 Manuel utilisateur

Extron electronics

Extron electronics MPA 152 Plus Manuel utilisateur

Extron electronics

Extron electronics XPA Ultra Series Manuel utilisateur

Extron electronics

Extron electronics MPA 152 Manuel utilisateur

Extron electronics

Extron electronics Fiber Optics Fox 4G DA8 Manuel utilisateur

Extron electronics

Extron electronics VGA Distribution Amplifiers P/2 DA4xi s Manuel utilisateur

Extron electronics

Extron electronics MPA 152 MD Manuel utilisateur

Extron electronics

Extron electronics NetPA Ultra Series Manuel utilisateur

Extron electronics

Extron electronics ADA 2/GLI 350 HV Manuel utilisateur

Extron electronics

Extron electronics XPA 1002 Manuel utilisateur

Extron electronics

Extron electronics MPA 401-70V Manuel utilisateur

Extron electronics

Extron electronics APP Manuel utilisateur

Extron electronics

Extron electronics P/2 DA2xi MT Manuel utilisateur

Extron electronics

Extron electronics NetPA Ultra Series Manuel utilisateur

Extron electronics

Extron electronics DA Series Manuel utilisateur

Extron electronics

Extron electronics PA 300 Manuel utilisateur

Manuels Amplificateur populaires d'autres marques

ASTRO

ASTRO HVO V40 P Manuel utilisateur

Marantz

Marantz SUPERSCOPE BLA-545 Instructions de montage

NAD

NAD CI980 Manuel utilisateur

Technics

Technics SE-CH770 Manuel utilisateur

Harman Kardon

Harman Kardon HK6300 Manuel utilisateur

NAD

NAD T975 Manuel utilisateur

McIntosh

McIntosh MA6850 Manuel utilisateur

Electro-Harmonix

Electro-Harmonix ENGLISH MUFF’N Manuel utilisateur

Viatron

Viatron Autrix Manuel utilisateur

GME

GME GA9800 Manuel utilisateur

Atlas

Atlas CP700 Manuel utilisateur

Roland

Roland KC-1000 Manuel utilisateur

Pyle

Pyle PFMRA350BW Manuel utilisateur

Advantage

Advantage S-250 Manuel utilisateur

IRT Electronics

IRT Electronics DVA-3007 Manuel utilisateur

Dimavery

Dimavery BA-100 Series Manuel utilisateur

Sony

Sony XM-S400D Manuel utilisateur

Schertler

Schertler ROY X Manuel utilisateur