MF 700
FOG MACHINE
User manual
Thanks for choosing our MF-700. You now own a rugged and powerful fog machine. Prior to use, we suggest that you
carefully read all of the instructions. BY following the suggestions found in this user manual, you can look forward to
exceptional performance from your EXPELEC fog machine for upcoming years.
Please follow these operations, safety and maintenance instructions to ensure a long and safe life for your fog machine.
CAUTIONS : Pay attention to all warning labels and instructions printed on the exterior of your fog machine.
1. Safety instructions
Danger of electric shock
- Keep the device dry
- For inside use only. Not designed for outside use.
- Prior to use, please take care if the unit is installed at the rated voltage.
- Always unplug the fog machine before filling the tank.
- Keep the fog machine upright.
- Turn off or unplug when it is not use.
- This machine is not water or splash proof. If moisture, water or liquids get inside the housing, immediately unplug the
unit and contact a service technician or your dealer before using it again.
- No user serviceable parts inside. Refer to your dealer or other qualified service personnel.
Danger of burns
- For adult use only. Fog machine must be installed out of the reach of children. Never leave the unit running
unattended.
- Keep nozzle at least 50cm away from contact with anything while in operation.
- The fog vapour at point of release is under pressure and is extremely hot.
- Never aim the output nozzle directly at people.
- Fog machine output is very hot. Avoid coming within 50 cm of the output nozzle during operation.
- Locate the fog machine in a well-ventilated area. Never cover the unit’s vents. In order to guarantee adequate
ventilation, allow free air space or at least 20 cm around the sides and top of the unit.
- Never aim the output nozzle at open flames.
- The output nozzle becomes very hot during operation (300°C), keep flammable materials at least 50 cm away from
the nozzle.
- Always allow your fog machine to cool down before attempting to clean or service it.
Danger of explosion
- Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
- Use only the high quality water based fog liquid that your dealer recommends. Other fog liquids may cause poor
effects and damage the unit.
- Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit without liquid will cause damage to
the pump and the heater.
- If your fog machine fails to work properly, please stop using it at once. Drain all fog liquid from the tank, pack the unit
and return it to your dealer.
- Always drain tanks before transport.
- Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skins or eyes, rinse
thoroughly with water.
2. Unpacking and inspection
- Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. In addition
to MF-700, you should have 1 x wire remote, 1 x hanging bracket and 1 x tank.
- Before beginning initial set up of the fog machine, make sure that there is no evident damage caused by
transportation.
- In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it until after
contacting your dealer.
3. Set up
- Remove all packing materials from the fog machine. Check that all foam and plastic padding are removed, especially
in the nozzle area.
- Fill in your fog liquid or other high-quality water based liquid recommended by your dealer. Any other types can
damage the unit. When filled, place cap back on liquid tank.
