4. Assembling the Power Sweeper
• Assemble the handle by inserting the three
sections into each other and turn to secure.
• Screw the handle into the device mounting.
5. Battery Charging
The Power Sweeper is supplied with
an empty Ni- H rechargeable battery. ake
sure the battery is charged for 16 hours before
initial use, this will give optimum battery
performance. Charging processes thereafter
takes 12-16 hours.
To charge the battery
• switch off the device with the switch,
insert the plug of the charger in the charging
jack of the device
• then insert the mains plug in a 230 V~50Hz
socket.
The red charging lamp is illuminated during
the charging process. If this is not the case,
check the plug connections.
With fully charged battery the device provides
an operating time of 25-30 minutes.
Rechargeable Power Sweeper
7. Cleaning & Emptying
To maintain the efficiency of the Power
Sweeper, empty the dirt container after every
use.
• Press the unlocking button of the dirt
container to detach it from the device.
With a slight upward movement, pull the dirt
container horizontally from the device.
• Empty the dirt container and re-insert.
(see page 1)
How to clean the brush
If the brush roller cannot be turned any
longer because of dirt, threads or hair:
• Turn over the sweeper and hold it so that the
flat side with the brush roller faces you.
• Remove the cover on the right hand side of
the brush.
• Loosen the drive belt by pushing it to
the right.
• Lift the brush roller on the right hand side
and remove the guide attachment.
• Now pull the brush roller from the device to
the right hand side.
• Remove the dirt (on both sides of the bristle)
and clean the brush.
After cleaning, proceed as follows to
re-install the brush roller.
• Ensure the drive belt is around the motor
drive pulley.
• Insert the brush roller in the left hand slot
• Fit the guide attachment on the right hand
side of the brush.
• Pull the belt around the guide attachment.
• Insert the brush in the right hand side and
continue to pull the belt over the drive wheel.
• Fit the brush cover by first introducing the
lower lugs in the recesses and press the
cover in at the top.
Caution:
• Only use the enclosed charger
(9V d.c. 200 mA).
• Only operate the device with the enclosed
rechargeable battery. It could otherwise get
damaged.
• Do not attempt to remove the rechargeable
battery for charging.
• Do not attempt to open the rechargeable
battery jacket or dismantle the battery.
Caution:
• Never use the device with the dirt container
removed.
• Keep end of rotating brush, poles and other
openings away from your face and body.
3
6. Working with the Power Sweeper
• Press the switch to start or stop the Power
Sweeper.
• Guide the Power Sweeper over the floor.
Note: With some types of carpet the power
sweeper could rattle or bounce. In this case
work slowly and in the opposite direction.
