Page | 3 User manual for evplug charger 7.4 kW PN. EV32002 www.evplugchargers.com
or adapter.
oDO not insert any fingers into the charging
plug.
oThe unit contains no user serviceable parts.
DO not try to repair or service the device
yourself.
oIf the unit does not work properly in
accordance with the operating instructions,
do not use this unit. Contact your dealer for
a repair or replacement.
oUse the product under normal away from
high temperature erosive materials or
ignition source.
oDO not contact metal conductor to prevent
electric shock accident.
oProduct shell is made of thermoplastic,
please do not pound it to avoid reducing
performances.
Installation Steps
1. According to the installation illustration, drill
3pcs Ø6 * 35mm holes, and insert the expansion
pipe.
2. Insert 2pcs M4 * 32 self-tapping screws into
the expansion pipe, and leave 5mm distance.
3. Open the charger's front panel, hang the
charger's body to the self-tapping screws, and
lock the M4*32 self-tapping screw at the
bottom.
4. Through the waterproof joint, connect 3pcs
6mm² power cord to the corresponding input
terminals.
5. Close the charger's front panel according to
the installation illustration, and lock the M4*8
screw to prevent the charger from theft.
Power On Checking
Check before power on
1. The charger's location should be easy for
operation and maintenance.
2. Make sure the power cords are properly
connected and installed securely.
3. Ensure the AC input cable's current leakage
protection switch type is reasonable.
Check after power on
1. Turn on the leakage protection circuit breaker
for AC current input.
2. After the charger is power on, it will self-
check for about 30S. The LED indicator will
display colors of red, yellow and green in turns
for 1S separately.
3. Observe the color status of LED indicator
after the self-check. Standby status: Green LED
flash, 1S on, 3S off.
Fault status: Red LED always on.
Charging Operation
1. Plug in the charging gun to EV.
2. Start charging by swiping the provided card in
the card-swiping area.
3. Stop charging by swiping the card again.
4. Disconnect the charging gun.
Precautions
1. Install the power cords in accordance to the
input terminal of L (Live wire), N (Neutral wire),
PE (Earth wire) , and do not reverse L and N
wires.
2. PE (Earth wire) has to be grounded reliably.
3. After power on, make sure the emergency
stop button is in the pop-up status.
4. Make sure the charging gun is free of dirt and
water before the charging.
5. Do not put the charger into EV while
charging.
Warranty:
Damage caused for the following reasons is not
covered by the warranty:
1. Improper handling, installation, use and
maintenance by the user.
2. Product falls into the water.
This warranty is for the original purchaser only
and is NOT transferable.
PLEASE NOTE: This document includes the latest
information at the time of printing. EVplug
Chargers, S.L. reserves the right to make changes
to this product without further notice. Changes
or modifications to this product by other than an
authorized service facility could void the product
warranty
