Evonicfires DOUBLE SIDED E810 DS Manuel utilisateur
1
EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
DOUBLE SIDEDDOUBLE SIDED
Evoflame & E-SmartEvoflame & E-Smart
INSTRUCTION MANUALINSTRUCTION MANUAL
E810 DSE810 DS
E1030 DSE1030 DS
Stora DSStora DS
Lindstrom DSLindstrom DS
EnglishEnglish
2EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
CONTENTS
EU Directives and UKCA Standards......................................................................3
Important Information and Health & Safety........................................................... 4
Components for Evoflame & E-Smart................................................................... 5
Installation........................................................................................................... 6
Model Dimensions...................................................................................... 7
Requirements and Checks.......................................................................... 8
Installation................................................................................................. 9
Log Layouts......................................................................................................... 11
Installing/Removing the Front Glass......................................................................13
Troubleshooting................................................................................................... 14
Warranty & Registration....................................................................................... 16
3
EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
All Evonic Fires products are in conformity with the relevant UK Statutory InstrumentsAll Evonic Fires products are in conformity with the relevant UK Statutory Instruments
(and their amendments).(and their amendments).
2016 No. 1101 The Electrical Equipment (Safety) Regulations 20162016 No. 1101 The Electrical Equipment (Safety) Regulations 2016
2016 No. 1091 The Electromagnetic Compatibility Regulations 20162016 No. 1091 The Electromagnetic Compatibility Regulations 2016
2012 No. 3032 The Restriction Of Use Of Certain Hazardous Substances In2012 No. 3032 The Restriction Of Use Of Certain Hazardous Substances In
Electrical And Electronic Equipment Regulations 2012Electrical And Electronic Equipment Regulations 2012
EU DIRECTIVES
All Evonic Fires products meet the requirements of the EC Directives.All Evonic Fires products meet the requirements of the EC Directives.
These directives have been met by compliance with the following standards:These directives have been met by compliance with the following standards:
EU 2011-65/EU 2015/863 Restriction of Hazardous Substances.EU 2011-65/EU 2015/863 Restriction of Hazardous Substances.
References to the relevant designated standards used:References to the relevant designated standards used:
EN 55014-1:2006 + A1:2009 + A2:2011 Electromagnetic Compatibility.EN 55014-1:2006 + A1:2009 + A2:2011 Electromagnetic Compatibility.
EN 55014-2:2015 Electromagnetic Compatibility.EN 55014-2:2015 Electromagnetic Compatibility.
EN 61000-3-2:2014 Electromagnetic Compatibility (EMC). Limits. Limits forEN 61000-3-2:2014 Electromagnetic Compatibility (EMC). Limits. Limits for
Harmonic Current Emissions.Harmonic Current Emissions.
EN 61000-3-3:2013 Electromagnetic Compatibility (EMC). Limits. Limitation ofEN 61000-3-3:2013 Electromagnetic Compatibility (EMC). Limits. Limitation of
Voltage Changes, Voltage Fluctuations and Flicker.Voltage Changes, Voltage Fluctuations and Flicker.
EN 60335-1:2012 + A11:2014 Household and similar electrical appliances - SafetyEN 60335-1:2012 + A11:2014 Household and similar electrical appliances - Safety
EN 60335-2-30:2009+A11:2012 Household and similar electrical appliances. Safety.EN 60335-2-30:2009+A11:2012 Household and similar electrical appliances. Safety.
Particular requirements for room heatersParticular requirements for room heaters
UKCA STANDARDS
4EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
IMPORTANT INFORMATION AND HEALTH & SAFETY
When using electrical appliances, basic precautions should always be followed to reduce
the risk of fire, electric shock, and injury to persons, including the following:
• Read all of the instructions carefully before using the appliance, only use this appliance
as described in this manual. Any other use not recommended by the manufacturer mayAny other use not recommended by the manufacturer may
cause injury to persons, or damage to the appliance.cause injury to persons, or damage to the appliance.
• Remove all packaging and dispose of it at an appropriate recycling facility.
•• When transporting or storing the appliance and power lead, keep in a dry place, awayWhen transporting or storing the appliance and power lead, keep in a dry place, away
from excessive vibration and store so as to avoid damage.from excessive vibration and store so as to avoid damage.
• This fireplace is hot when in use. To avoid burns, do not let bare skin touch hot
surfaces. The trim around the heater outlet becomes hot during heater operation.
DANGER: High temperatures may be generated under certain abnormal conditions.
• Do not install this appliance immediately in front of a fixed socket outlet.
• Do not install this appliance in the immediate surroundings of a bath, shower,
swimming pool or any other area where the appliance could come into contact with
water or humidity, e.g. a bathroom.
•• Do not use in areas where gasoline, paint, or any flammable liquids are used or stored.Do not use in areas where gasoline, paint, or any flammable liquids are used or stored.
• This appliance is only suitable for indoor use, do not use outdoors.
• Do not cover the appliance, or let the air inlet/outlet to be obstructed in any way as it
may overheat.
• Keep the power lead away from hot surfaces and the heater outlet. Do not route the
power lead in front of the appliance, or under any carpets or rugs. Do not allow the
power lead to be coiled up once installed, as this can cause overheating.
• A maintenance hatch must be installed into the surrounding installation to allow future
access.
• Always use a certified electrician should new circuits or outlets be required. And
always use properly grounded, fused and polarised outlets.
• Where the power lead passes through any masonry wall, stone surround etc. ensure
that suitable rubber bushes are fitted at any possible wear points.
• If the power lead is damaged do not use the appliance until it has been replaced.
• Do not use any external switching device, timers, or extension leads. Do not connect
the appliance to a circuit that is frequently switched on and off by the utility.
•• In the event of a malfunction, switch off the appliance, and disconnect it from theIn the event of a malfunction, switch off the appliance, and disconnect it from the
mains power supply. Have the appliance inspected by a certified electrician beforemains power supply. Have the appliance inspected by a certified electrician before
reusing.reusing.
• Do not use the appliance if it is damaged. In the event of any damage to the appliance,
please contact the retailer from whom the appliance was purchased.
• Any repairs must only be performed by a certified electrician.
• Extreme caution is necessary when any heater is used by, located near children or
people of reduced mobility, and whenever the unit is left operating and unattended.
• Young children should be supervised to ensure that they do not play with the appliance.
•• Disconnect from the power supply before performing any cleaning, maintenance orDisconnect from the power supply before performing any cleaning, maintenance or
relocation of the unit. Do not use steam cleaners, or aerosols near the appliance.relocation of the unit. Do not use steam cleaners, or aerosols near the appliance.
• Do not burn wood or anything else in this appliance.
• Do not strike the glass. The glass used is toughened safety glass, if broken it will
shatter into small chunks which are less likely to cause injury.
• Do not drill or screw any new holes into the appliance.
5
EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
COMPONENTS FOR EVOFLAME
ModelModel
Log Sets & QuantityLog Sets & Quantity
ChippingsChippings Black VermiculiteBlack Vermiculite Suction LifterSuction Lifter Electrical LeadElectrical Lead E-Series InstructionE-Series Instruction
ManualManual
Woodland or Silver BirchWoodland or Silver Birch
E810DSE810DS 4 x small4 x small 4 x4 x 4 x4 x 1 x1 x 1 x1 x 1 x1 x
E1030DSE1030DS 4 x large4 x large 4 x4 x 4 x4 x 1 x1 x 1 x1 x 1 x1 x
COMPONENTS FOR E-SMART
ModelModel
Log Sets & QuantityLog Sets & Quantity
Glass Stones Clear &Glass Stones Clear &
AmberAmber
BlackBlack
VermiculiteVermiculite
SuctionSuction
LifterLifter Electrical LeadElectrical Lead E-Series InstructionE-Series Instruction
ManualManual
WoodlandWoodland
or Silver Birchor Silver Birch
Lindstrom DSLindstrom DS 4 x large4 x large 4 x Clear4 x Clear
4 x Amber4 x Amber 5 x5 x 1 x1 x 1 x1 x 1 x1 x
Stora DSStora DS 4 x small4 x small 2 x Clear2 x Clear
2 x Amber2 x Amber 4 x4 x 1 x1 x 1 x1 x 1 x1 x
6EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
INSTALLATIONINSTALLATION
7
EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
MODEL DIMENSIONS
The model shown in these drawings is an E1030DS, however the same
processes apply to all DS appliances.
Scan the QR code for more detailed specification drawings.
Model Width Height Depth
Overall unit
(A)(A)
Overall unit
(B)(B)
Openings
(C)(C)
Overall unit
(D)(D)
E810 DS 864mm 1208mm 1002mm 535mm
E1030 DS 1056mm 558mm 355mm 530mm
Lindstrom DS 1056mm 558mm 355mm 530mm
Stora DS 864mm 1208mm 1002mm 535mm
8EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
Before installing the appliance please read
and take into account the following impor-
tant requirements;
• Consult a qualified professional to check
the structure of the installation site.
• The appliance must not be installed any-
where that it may come into contact with
water, i.e. a bathroom.
• Do not use silicones or adhesives to seal
in the appliance, and do not apply wet
plaster directly to the appliance.
INSTALLATION REQUIREMENTS
INSTALLATION
CHECKS BEFORE INSTALLATION
We recommend turning on the appliance
before installation, connect the appliance to
a power source using the provided electrical
lead, and depress the right side of the rocker
switch.
Remove the electrical lead from the wall and
continue with the installation.
9
EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
TOOLS REQUIRED
• Tape Measure
• Pencil
• Spirit Level
• Screwdriver
• PZ2 Screw Bit
INSTALLATION STEPS
1Remove the two bottom mounted transit brackets from both sides. You will not
need these for the installation.
2
Determine the finished height and position that you want the appliance to
be located. Build your base support taking into consideration the 50mm
ventilation gap under the appliance. Then place the appliance onto the support
and check that it is well supported.
10 EVONIC - 104 INSTRUCTION MANUAL ISS. 11EVONIC - 104 INSTRUCTION MANUAL ISS. 11
3Your plasterboard can now line up with the plaster kits on the edge of the
appliance.
4Your installation is now complete and you can set up your logs.
Ce manuel convient aux modèles suivants
3
Table des matières
Autres manuels Evonicfires Alarme incendie
