Evolveo RoboTrex H9 Manuel utilisateur
RoboTrex H9
www.evolveo.com
WARNING SYMBOLS USED
This is the safety alert symbol. This symbol alerts you to
potential hazards that could result in property damage and/or
serious bodily harm or death.
• This device can be used by children aged from 8 years and above and persons
with reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given supervision or instruction concerning use of this
device in a safe way and understand the hazards involved.
• Children should be supervised to ensure they do not play with this device.
• Cleaning and maintenance shall not be performed by children without adult
supervision.
• This device is only to be used with the power supply unit provided.
• For the purposes of recharging the battery, only use the detachable power supply
unit provided with this device.
• The battery must be removed from this device before this device is disposed of. To
remove the battery from this device, first remove the screws on the bottom, then
remove the battery by disconnecting the quick connector.
• The used battery should be placed in a sealed plastic bag and disposed of safely
according to local environmental regulations.
• The external flexible cable or cord of the power supply unit cannot be replaced; if the
cord is damaged, the power supply unit shall be disposed of.
• This device is for indoor use only.
• This device is not a toy. Do not sit or stand on this device. Small children and pets
should be supervised when this device is operating.
• Store and operate this device in room temperature environments only.
• Clean with a cloth dampened with water only.
• Do not use this device to pick up anything that is burning or smoking.
• Do not use this device to pick up spills of bleach, paint, chemicals, or anything wet.
• Before using this device, pick up objects like clothing and loose paper. Lift up cords
for blinds or curtains, and move power cords and fragile objects out of the way. If
this device passes over a power cord and drags it, an object could be pulled off a
table or shelf.
• If the room to be cleaned has a balcony, a physical barrier should be used to prevent
access to the balcony and to ensure safe operation.
• Do not place anything on top of this device.
• Be aware that this device moves around on its own. Take care when walking in the
area where this device is operating to avoid stepping on it.
• Do not operate this device in areas with exposed electrical outlets on the floor.
• Do not expose the electronics of this device, its battery, or the integrated Charging
Base. There are no user-serviceable parts inside.
• Do not use this device on an unfinished, unsealed, waxed or rough floor. It may
result in damage to the floor and this device. Use only on hard floor surfaces or low-
pile carpet.
• This device has been designed to be used on floors without scratching them. We
still recommend that you test this device on a small area of the room to be cleaned
to ensure no scratches are made before cleaning the whole room.
1
Dear customer,
thank you for choosing the EVOLVEO RoboTrex H9. We believe you will enjoy a lot of fun and happiness.
Please, read the safety rules carefully and follow all common safety rules before using a robotic vacuum cleaner.
3
4
6
7
8
8
9
11
11
12
17
Contents
Product Composition / Package Contents
Product Composition / Part Name
Product Usage / Preparation
Product Use/ Charge Robot
Product Use / Turn On / Turn Off
Product Use / Start Pause, Wake up
Product Usage / Select a Cleaning Mode
Component Use the Boundary Strip
Component Time Scheduling Setting
Component Cleaning and Maintenance
Troubleshooting
Product Parameter
16
Product Composition / Package Contents
3
Charging Base Dust Box
Side Brush x4
Remote Control (with battery x2)
Robot
Cleaning Brush
Instruction Manual
Power Adapter
HEPA Filter x2 Water Box MoppingCloth x2
Product Composition / Part Name
Front Robot Back Robot
4
Power ON/OFF Button
Bumper
Rolling Brush
Side Brush
Drop Sensor
Auto Cleaning Start/Stop Button
Surface Cover
Infrared sensor
Battery Compartment
Dust Collector
Brush Guard
Charging Contact Pins
Hall Sensor
Swivel Wheel
Dust Box
Charging Base
Remote Control
Remote Control Display
5
Vent
Charging Base Pins
Schedule Auto Cleaning start time
Mode Switching:
Control cleaning direction manually
Start Auto Cleaning
Start Auto Cleaning
Stop Cleaning
Adjust suction power level in Auto Cleaning Mode
Adjust the hour and minute
Adjust time
Return to Charging Base
Spot Cleaning Mode
Single Room Cleaning Mode
Edge Cleaning Mode
1
1
44
5
5
6
6
7
7
2
2
3
1
2
3
Schedule cleaning time
Strong suction power
Standard suction power
Auto Cleaning Mode
Time Setting
Returning to Charging Base
Clock
Single Room cleaning Mode
Edge Cleaning Mode
Spot Cleaning Mode
1
4
5
6
8
7
9
10
2
3
7
9
3
10 8
65
4
Install 2 AAA batteries before using the remote control for the first time. Make sure
The positive and negative ends are facing the correct polarity direction as marked in
The battery compartment.
T
DC Socket
Product Usage / Preparation
Remove Protection
Before using the Robot, remove the protective strip
on the Robot.
Important Tips Before Use
Remove power cords and small objects from the floor that may entangle Robot. You
can use the supplied cable ties to organize your wires and power cords.
Fold tasseled edges of area rugs underneath to prevent tangling Robot. Avoid
cleaning very dark-colored high-pile rugs or rugs thicker than 1.02 in/26 mm as they
may cause Robot to malfunction.
Keep Robot away from spaces lower than 2.87 in/73 mm to prevent Robot from
getting stuck. If necessary, place a physical barrier to block off the problem areas.
Keep Robot away from wet areas.
Robot may climb on top of objects less than 0.63 in/16 mm in height. Remove these
objects if possible.
Anti-drop sensors prevent Robot from tumbling down stairs and steep drops. They
may work less effectively if dirty or used on reflective/very dark-colored floors.
Place physical barriers in front of fireplaces and areas that may cause
damage to Robot if entered.
Install the side brushes before use.
1
2
a
d
b
e
c
f
f
e
d
c
b
a
T
6
4
3Place the Charging Base on a hard, level surface and
against a wall.
Remove objects within 3 ft/1 m on both sides and
within 6 ft/2 m in front of the charging base.
5Plug the adapter into the a wall outlet and pulg the DC jack
into the DC socket of the Charging Base.
6ft/2m
3ft/1m 3ft/1m
When the Charging Base connects to AC power, the LED
indicator on the Charging Base is SOLID GREEN
Install the Charging Base in a location that Robot
can easily access. It is recommended to place the
Charging Base against a wall, and on a hard-level
surface rather than on rugs or carpets.
- Always keep the Charging Base plugged in,
otherwise Robot will not automatically return to it.
Charge Your Robot
Robot has a pre-installed rechargeable battery that has to
be fully charged before use.
Robot returns to the Charging Base at the end of a cleaning
cycle or when its battery is running low
Attach Robot to the Charging Base by aligning its charging
pins with the charging pins on the base.
Method 1
T
7
Turn On and Turn Off
Start / Stop / Wake up
Method 2
Press on the remote control to return Robot to the
Charging Base
Turn off the Robot if it will not be used for a long period of time. To preserve
the battery’s lifespan,recharge at least once every 6 months.
Make sure the Robot is turned on before use.
Press on the Robot until the indicator light on
the Robot turns on and the “welcome to use sweeping
robot” Prompt Tone
Turn On:
Press on the Robot until the indicator light on
the Robot turns off.
Turn Off:
1. Press on the Robot or / on the remote control to
start cleaning in Auto Mode
2. Press on the Robot or on the remote control to stop
cleaning
T
T
8
If the Robot stops working for more than ten minutes, it will
automatically enters the sleep mode ( all the lights on the robot
will turn off)
Press on the Robot or / on the remote control to
start cleaning in Auto Mode
3. Press on the Robot or any key on the remote control to
wake up
Select a Cleaning Mode
1. Auto Cleaning
Robot optimizes its cleaning path by selecting different
cleaning modes automatically until cleaning is complete.
This is the most commonly used cleaning mode.
- Robot will return to the Charging Base automatically
when the battery level becomes low or when Robot finishes
cleaning.
- By default, Robot starts in Auto Cleaning mode when it is
turned on.
Adjust the suction power to ensure the best clean.
It is ideal for cleaning thicker carpets and hard-to-sweep messes,
which will reduce the total cleaning time, but increase the noise
level.
Press on the remote control repeatedly to adjust the
suction power level.
-This feature only works in Auto cleaning modes.
T
T
T
9
Table des matières
Autres manuels Evolveo Aspirateur
