EVOLVE
Page 6 • evolvefurnituregroup.com
Corner Connections - Corner Post Extension Two-Way, Three-Way and Four-Way
Inline Connections - Equal Height
Parts List
1 Aluminum corner extension post
1, 2, 3 or 4 non-slotted posts (attach to aluminum corner post)
1, 2, 3 or 4 variable-height clamps
Appropriate trim
Corner Post Extensions are used to connect Panel Extension Modules at
a corner. The combination of one 66” panel and three 12” Panel Extension
Modules has been tested and U.L. Approved. Special care should be taken
to ensure stability when exceeding 90” in height.
STEP 1: Remove the post top cap.
STEP 2: Remove the single clamp that attaches the panel to the corner
post.
STEP 3: Reconnect the top of the panels to the slotted corner posts by
engaging the variable-height clamps through the slotted post. Rotate the
variable-height clamps down onto the top horizontal tubes of the panels.
Secure the variable-height clamps by bolting each to a panel using two
1/2” flat head screws.
STEP 4: Insert the Corner Post Extension into the existing Corner Post,
making sure that it is fully seated.
STEP 5: Position the Panel Extension Module on top of the desired, cor-
responding panel and against the Corner Post Extension.
STEP 6: Connect the top of the Corner Post Extension to the Panel Exten-
sion Module by engaging the single clamp through the slotted post and
into the panel liner. Secure the single clamp by bolting it to the top of the
panel using two 1/2” flat head screws.
STEP 7: Repeat the above procedure to attach the second, third and
fourth panel to the Corner Post Extension.
STEP 8: Attach the Corner Post top cap.
STEP 9: Reattach the panel top caps.
Parts List
1 Slotted post with levelling glide
1 Double clamp
The Inline Connector is used to connect two panels of equal height in a
straight line.
STEP 1: Partially attach the slotted post to one end of the panel to be
installed by engaging the down-hook at the bottom of the panel (above
the raceway channel) over the up-hook on the slotted post.
STEP 2: Attach the opposite end of this panel to the slotted post of the
run of panels. Do this by engaging the down-hook at the bottom of the
panel (above the raceway channel) over the up-hook on the opposite side
slotted post.
STEP 3: Connect the two panels and Inline Connector by engaging the
double clamp through the slotted post and into the panel liner. Secure the
double clamp by bolting it to the top of the panel using four (4) 1/2” flat
head screws.
STEP 4: Reattach the panel top caps.
INSTALLATION GUIDELINES
