Evoheat Solace Universal C-1200 Manuel utilisateur

Page | 1

Page | 2

Contents

1. Preface ...................................................................................................................................................... 3

2. How It Works ............................................................................................................................................. 4

3. Safety Instructions ..................................................................................................................................... 5

4. Installation................................................................................................................................................. 7

4.1 Installation Diagram ....................................................................................................................... 7

4.2 Installation Site............................................................................................................................... 8

4.3 Ducts Installation ........................................................................................................................... 9

4.4 Electrical Installation .....................................................................................................................10

4.5 Plumbing .......................................................................................................................................11

4.6 Air-Cooled Condenser Installation .................................................................................................12

4.7 Pipe Installation.............................................................................................................................13

5. Water Chemistry.......................................................................................................................................14

5.1 Pool Water Chemistry ...................................................................................................................14

6. Start-up Check List ....................................................................................................................................14

6.1 Pre-Start Checklist .........................................................................................................................14

6.2 Start-Up.........................................................................................................................................15

7. Operation .................................................................................................................................................16

7.1 How to Control..............................................................................................................................16

7.2 Run-Mode Menu...........................................................................................................................17

7.3 Alarms Menu ................................................................................................................................20

7.4 Sensors Off Set Menu....................................................................................................................20

7.5 Run-state Menu ............................................................................................................................21

7.6 Curves Menu.................................................................................................................................21

7.7 On/Off Menu ................................................................................................................................22

8. Alarm and Troubleshooting.......................................................................................................................23

9. Circuit Diagram .........................................................................................................................................25

10. Dimension and Parts ...............................................................................................................................26

10.1 Description of Parts and Dimensions .............................................................................................26

11. Maintenance...........................................................................................................................................28

11.1 Overview.......................................................................................................................................28

11.2 Daily Maintenance.........................................................................................................................28

11.3 Monthly Maintenance ...................................................................................................................28

11.4 Annual Maintenance .....................................................................................................................28

12. Technical Specification............................................................................................................................29

13. GUARANTEE CARD ..................................................................................................................................30

Page | 3

1. Preface

Thank you for choosing a Evo SOLACE UNIVERSAL Multi-functional Commercial Pool Dehumidifier &

Ventilation unit. This is the operation manual for models C-250 to C-1800.

Please read this manual carefully as it provides useful operation and maintenance information that

will maximise the benefits your dehumidifier can offer. Keep the manual in a safe place. You may

want to refer to it again.

The Solace Universal Multi-Functional Commercial Pool Dehumidifier & Ventilation unit is designed

to provide an environment that is both comfortable and cost effective. It controls unwanted

humidity in the pool enclosure and helps to prevent unsightly condensation from forming on

surfaces.

HUMIDITY CONTROL

If the space temperature is below the desired set point, the heat recovered during dehumidification is directed to the

air reheat coil for space heating. If the pool water temperature is also below the set point, some of the recovered heat

is directed to the pool water condenser (for pool heating mode only) for pool water heating. If neither air heating nor

pool water heating is required, the recovered heat can be directed to an auxiliary air conditioning condenser if the

system is so equipped. If the system does not include an auxiliary air conditioning condenser, the unit will direct the

recovered heat to the air reheat coil until the need for dehumidification is satisfied.

SPACE HEATING

When the compressor is running, space heating will continue until the space temperature reaches the set point. The

controller will activate the auxiliary space heating system if the unit is unable to satisfy the heating need with heat

recovered during dehumidification.

SPACE COOLING (OPTIONAL)

If space cooling is required and the unit is equipped with an auxiliary air conditioning condenser (air-cooled or water-

cooled), the controller will activate the space cooling mode of operation. In this mode, the heat removed from the

space air will be directed to the auxiliary air conditioning condenser. The air-cooling mode of operation is independent

of the need for dehumidification.

WATER HEATING (OPTIONAL)

If the pool water temperature is also below the set point, some of the recovered heat is directed to the pool water

condenser for pool water heating. Heating can only take place during the dehumidification when heat is captured in the

refrigeration circuit. This is only available on the mode pool heating, which is equipped with a pool water condenser.

FRESH AIR AND ENERGY RECOVERY

The unit includes energy conservation strategies such as heat recovery, airflow measurement and CO2 based control

help control costs while improving indoor air quality.

STANDARD ITEMS FACTORY SUPPLIED FOR FIELD INSTALLATION

•Microprocessor control interface device

•Outside air temperature sensor

•Humidity sensor

•Air quality sensor

SYSTEM OPTIONS

•Remote Air-cooled condenser for space air conditioning

•Water-cooled condenser

•Pool water heating

•Cooling/heating coils

Page | 4

2. How It Works

MULTI FUNCTIONAL DEHUMIDIFIER REFRIGERANT SYSTEM SCHEMATIC

The fan draws in warm, moist air from the pool enclosure. This air passes through the evaporator

(dehumidification) coil and gives up heat energy to the refrigerant which is in a cool, liquid state.

This exchange of energy causes the air temperature to fall below its dew point, resulting in

moisture condensation on the evaporator coil. The moisture formed falls into the unit’s condensate

drain pan.

The refrigerant enters the unit’s compressor, where it is compressed into a hot gas. While in the

compressor, the refrigerant absorbs the energy used to operate the compressor. This hot gas

refrigerant then travels either through an air reheat coil, the pool water condenser or to an

optional auxiliary air conditioning condenser, which may be either air or water cooled. If air heating

is called for, the air reheat coils is used. The hot refrigerant exchanges energy with the cooler,

dehumidified air coming from the evaporator coil. This causes the temperature of the air to rise for

heating.

If pool water heating is required, the hot gas flows into a pool water condenser, where it adds

energy to the incoming pool water. This heats the pool water while the refrigerant is condensed

into a warm liquid. If space cooling is called for, the refrigerant flows to the auxiliary air

conditioning condenser by passing the air reheat coil and pool water condenser and allowing cool

air from the evaporator coil to provide space cooling.

Page | 5

3. Safety Instructions

Read the Safety Instructions carefully before operation.

WARNING

Incorrect handling could cause a

serious hazard such as death,

serious injury etc. with a high

probability.

CAUTION

Incorrect handling could cause a

serios hazard depending on the

conditions.

Meaning of symbols used in this manual are shown as

below.

Prohibited – be sure not to do.

Important - Be sure to follow this

instruction

Be sure to ground

Be sure to disconnect the power

plug

Never step on the unit or place

anything on them

Danger of electrical shock

Do not insert fingers or objects

DO NOT disconnect/connect the power during operation.

This may cause a fire due to sparks, etc.

When an abnormality (smell of burning, etc.) occurs, stop

the unit and disconnect the power or turn off the breaker.

If the unit continues to be operated in an abnormal

condition, it may cause a fire or hazards.

Apply Grounding. Do not connect a grounding wire to a

gas pipe, water pipe, lightning rod or ground wire of a

telephone. If a grounding is incorrect, it may cause an

electronic shock.

WARNING

No connection in the middle of power cord or extend

the power cord. Multifunctional socket is forbidden to

be used.

Remove dirt from the power terminal. If dirt adheres

to the terminal or fixed is incomplete it may cause a

fire or electric shock.

Do not scratch or process the power cord. Do not put

heavy objects on the power cord, heat it or process it.

The cord may become damaged and cause a fire or

electric shock.

Consult your dealer for installation.

Do not insert fingers or objects into the air inlet and

air outlet. Since the fan rotates at high speed, this may

cause an injury.

Repair or relocation must not be done by the

customer. If done incorrectly, it may cause fire,

electric shock, water leakage and other hazards.

Consult your dealer if you are unsure of anything.

Page | 6

WARNING

Do not pull the power cord. Use the screwdriver to

disconnect it. The core wire of the power cord may be

disconnected, and it may cause a fire.

When the unit is to be cleaned, switch off and disconnect

the power or turn off the breaker.

Since the fan rotates at high speed during operation, it

may cause an injury.

Install an earth leakage breaker when the

unit is installed in a humid location. If the

earth leakage breaker is not installed, it

may cause an electrical shock.

The customer must not install this unit themselves. If

done incorrectly it may cause a fire, electric shock, water

leakage etc.

Ensure that you consult your dealer.

Do not apply an insecticide or flammable spray. It

may cause a fire or deformation of the cabinet.

Do not clean the unit with water. Water may enter the

unit and degrade the insulation which can cause

electric shock.

When the unit is not going to be used for a long time,

disconnect the power or turn off the breaker and

make sure there is no water inside the unit. If not dirt

may collect and cause a fire hazard.

Do not install the unit where there is flammable gas.

Do not operate switches with wet hands.

CAUTION

Do not operate for a long time in the rain. It will shorten

the lifespan of the unit.

Do not step on the unit and do not put anything on it.

Do not step onto an unstable bench when

attaching/detaching the panel

Page | 7

4. Installation

4.1 Installation Diagram

Page | 8

4.2 Installation Site

Select a suitable location for the unit, where the unit will not be subject to any damage.

a) The unit must be mounted on a flat and level foundation capable of supporting the entire operating

weight of the equipment.

b) The location must not contain corrosive-chemical storage or connect to any space that contains corrosive-

chemical storage.

c) The location must not include a natatorium or spa room, or any space where the exterior of the unit

would be exposed to chloramines outgassing from a pool.

d) Ensure that water cannot collect under the unit, it is recommended that units are installed on plinths

100mm above finished floor level. This also aids condensate drainage.

e) Please allow adequate clearance to service panels on the unit; recommended 800mm minimum.

f) Ensure loose debris such as leaves, grass cuttings, etc will not block air inlet grilles.

g) Consider protection from extreme weather conditions if installed externally.

h) Inadequate working spaces may compromise workplace safety. Inadequate working spaces may preclude

proper maintenance.

Page | 9

4.3 Ducts Installation

Page | 10

4.4 Electrical Installation

1.ELECTRICAL SAFETY

It is important to ensure that all aspects of the installation comply with the latest I.E.E. Regulations. It is also

important to ensure that any remote devices which terminate within the pool hall are of the type and

voltage as specified in the latest I.E.E. Regulations. The machine should be installed in accordance with

EMC2004/108/EC.

2.PROTECTED SUPPLY

Whilst not mandatory, we recommend that an R.C.C.B. is always fitted or that the supply is to local electricity

authority recommendations, and that all ducting is bonded in accordance with these regulations. The supply

to the machine should incorporate fuses or motor rated circuit breakers (type GU, FAZC) to specified rating

(see data sheet)

H.R.C. Fuses are recommended. An isolator must be fitted within clear view of the machine and not more

than 2 meters away. The isolator must have a minimum of 3mm air gap when in the off position.

3.POWER SUPPLY

Power supply of the dehumidifier must consistent with the power supply described in the circuit diagram. If

inconsistent power supply is connected, the dehumidifier will not be guaranteed either in performance or

warranty.

Note: The voltage must be measured at the dehumidifier mains terminals with all the fans/compressors

running at the rated condition.

4.CORRECT CABLE SIZING

The cable supplying electricity to a machine with a given load must increase in cross sectional area (CSA) as

the length increases in order that the voltage drop within the cable does not exceed recommended limits.

Cable sizing should be calculated by an approved electrician with due consideration to I.E.E. and local codes

of practice.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels evoheat Déshumidificateur

evoheat

evoheat Solace Domestic 3.0 Manuel utilisateur

evoheat

evoheat Solace Domestic Manuel utilisateur

evoheat

evoheat Solace 2.5 Manuel utilisateur

Manuels Déshumidificateur populaires d'autres marques

Daitsu

Daitsu CD031IU-DFA Manuel utilisateur

Fehom

Fehom PDGT701BE Manuel utilisateur

Hitachi

Hitachi RD-190GX Manuel utilisateur

Westpoint

Westpoint MDF1-30AE Manuel utilisateur

SOLIS

SOLIS easy dry compact Manuel utilisateur

ENVIROBOSS

ENVIROBOSS EB240 Manuel utilisateur

Sinclair

Sinclair R-9112 Manuel utilisateur

Kenmore

Kenmore 580.54701 Manuel utilisateur

Demargo

Demargo DM828NF Manuel utilisateur

Altrad Lescha

Altrad Lescha LDH 600 Manuel utilisateur

BOMANN

BOMANN LE 1150 CB Manuel utilisateur

SPT

SPT SD-46 Manuel utilisateur

REMKO

REMKO SLN 40 Manuel utilisateur

Haier

Haier HD458 Manuel utilisateur

Logik

Logik L20DHW12 Manuel utilisateur

Frigidaire

Frigidaire FDR30S1 - 30 Pint Capacity Dehumidifier Guide de démarrage rapide

Blitz

Blitz HHD Series Manuel utilisateur

Prem-I-Air

Prem-I-Air PD14DEN Manuel utilisateur

evoheat Solace Universal C-1200 Manuel utilisateur

Manuels Déshumidificateur populaires d'autres marques