Evoca Group Cafection Symbol Manuel utilisateur
CLEANING GUIDE
for Key Holder
Cafection Symbol
2
Need Assistance?
Contact your service provider.
3
TABLE OF CONTENT
Important Notices 5
Daily Routine 6
Filling Up Ingredients...............................................................7
Performing a Rinse ..................................................................8
Emptying the Waste Bin ..........................................................9
Changing the Filter Paper (if Empty) ....................................10
Cleaning the Unit....................................................................11
Weekly Routine 12
Cleaning the Waste Chute or Internal Waste Bin................13
Cleaning the Soluble Canisters’ Elbow(s)............................14
Weekly Visual Inspections.....................................................15
4
5
Important Notices
This guide is designed to help you keep your machine clean and in
good condition by suggesting simple and easy steps.
Do not perform advanced maintenance if you did
not receive an adequate technical training.
Parts are not dishwasher safe.
All parts in contact with food must be air dried completely before
reinstalling.*
RECOMMENDED TOOLS AND CLEANING MATERIAL:
• Small brush, suitable for food-contact surfaces and hot water
• Brush for coffee grounds, suitable for food-contact surfaces
• Scissors
• Water resistant and lint-free towel
• 100% cotton soft cloths
• Mild non-abrasive cleaner
• 16-ounce container (preferably reusable)
*Air drying is the only drying method approved by Cafection to prevent
contamination. In the event you use a towel, make sure to follow the
manufacturer cleaning instruction.
6
Daily Routine
BEGINNING OF THE DAY
FFill up the ingredient canisters and condiments
dispenser
DURING THE DAY, WHEN REQUIRED
FPerform a rinse
FEmpty the waste bin
FVerify the filter paper level and change the roll if empty
END OF THE DAY
FClean the unit
FEmpty and clean the drip tray and grill
FTidy up the coffee area
7
Filling Up Ingredients
Unlock and remove the top lid, then
fill up the bean hoppers*.
Make sure to avoid
cross-contamination.
Pull the soluble canisters* out of the
brewer and place them on a flat, clean
surface.
Open the lids one at a time and fill the
canisters up, then reinstall the canisters
in the machine.
Access Service mode:
1. Tap the 3corners of the screen.
2. Enter your PIN (default:5657).
Access the Products Levels screen and
adjust the levels using the bean icon.
Then, exit Service mode.
Make sure your cup and condiment dispenser is full with stirrers,
sugars, cups, etc.
*Product availability may vary depending on the model.
1
5
5432
D
C
B
A
A
B
C
D
1
2
345
678
8761
432
D
C
B
A
A
B
C
D
1
2
345
678
87651
2
3
4
8
Performing a Rinse
Place an empty container under the
spout. Make sure it can hold a minimum
capacity of 16oz.
Access Service mode:
1. Tap the 3corners of the screen.
2. Enter your PIN (default:5657).
Perform an auto rinse.
Verify if your container is well positioned
and tap the “Rinse” button on the
popup window.
Wait until water has completely finished
dripping. Be careful, the water is VERY HOT.
Once the rinse is completed, exit Service
mode.
Empty the container. Be careful, the water is
VERY HOT.
Do not drink this water.
1
16 oz
2
3
4
9
Emptying the Waste Bin
Open the brewer door and
remove the brew group
protective panel.
Cut the filter paper 6inches
below the yoke assembly with
scissors.
DO NOT YANK ON THE
PAPER.
MACHINE WITH COFFEE CHUTE
Change the bag of the waste bin under
the counter. Reinstall the protective
panel and close the brewer door.
MACHINE WITH INTERNAL WASTE BIN
Remove the internal waste bin from the
unit and empty it. Put the waste bin
back in the unit.
DO NOT USE A PLASTIC BAG.
Reinstall the protective panel and close
the brewer door.
Access Service mode:
1. Tap the 3corners of the screen.
2. Enter your PIN (default:5657).
Reset the waste bin counter, then exit Service
mode.
432
D
C
B
A
A
B
C
D
1
2
345
678
87651
1
2
3
4
765432
D
C
B
A
A
B
C
D
1
2
345
678
81
10
Changing the Filter Paper (if Empty)
Access Service mode:
1. Tap the 3corners of the screen.
2. Enter your PIN (default:5657).
Tap “Filter Paper Install”.
Open the brewer door, remove
the protection panel and remove
the empty filter paper roll.
Install the new roll. Feed the
paper under the left guide
bracket of the brew group,
under the brew chamber and
under the wheel guides by
gently lifting them using the
yoke.
Reinstall the protective panel
and close the brewer door.
Tap “OK” on the installation popup
window.
Choose “Yes” to the question “Did
you replace the filter paper roll with a
new full roll?”
Exit Service mode.
2
765432
D
C
B
A
A
B
C
D
1
2
345
678
81
432
D
C
B
A
A
B
C
D
1
2
345
678
87651
1
2
4
3
Table des matières
