Evnex R Series Manuel utilisateur

Installation Manual

Intelligent EV Charging Station

R7 and R22 Series

V191002

Installers please provide end user with the accompanying User Manual

As well as standard installation tools the following is required:

•T20 TORX SECURITY BIT

•NO.2 SQUARE DRIVE BIT

•7MM MASONRY BIT (FOR SOLID WALLS)

Evnex R-Series Installation Manual | V191002

Please note

Read all instructions before installing or using this product.

This Installation Manual is current at the time of printing. Evnex Ltd.

reserves the right to make changes to this document or the products

described without notice.

For questions relating to this product, its use or installation, please refer

to contact details below:

239 Brougham St

Sydenham

Christchurch

8023

New Zealand

Phone: +64 3 925 9879

Email: support@evnex.com

Web: www.evnex.com

2 
 
Evnex R-Series Installation Manual | V191002 
Contents 
 
Please Note ...............................................................................................................................1 
Introduction ...............................................................................................................................3 
Product description ..............................................................................................................3 
General dimensions.............................................................................................................. 4 
About this document ............................................................................................................ 5 
Symbols................................................................................................................................. 6 
Safety Information.....................................................................................................................7 
General information.............................................................................................................. 7 
Risk of electric shock ...........................................................................................................7 
Disclaimer..................................................................................................................................7 
Installation................................................................................................................................. 8 
Site selection ........................................................................................................................ 9 
Mounting notes...................................................................................................................10 
Fasteners ............................................................................................................................11 
Opening the unit..................................................................................................................12 
Mounting unit......................................................................................................................13 
Timber framed wall mounting example.............................................................................14 
Solid wall mounting example .............................................................................................15 
Wiring connection ...................................................................................................................16 
Single phase wiring example..............................................................................................17 
Three phase wiring example ..............................................................................................18 
Upstream protection...........................................................................................................19 
Setting the maximum charge current ................................................................................20 
Closing the unit........................................................................................................................21 
Checklist..............................................................................................................................21 
Installing the front cover ....................................................................................................22 
Operation .................................................................................................................................23 
Status display .....................................................................................................................23 
Initialisation.........................................................................................................................23 
Charging process................................................................................................................24 
LED modes / fault conditions.............................................................................................25 
Technical information .............................................................................................................26 
Troubleshooting ......................................................................................................................28 
 
 

Evnex R-Series Installation Manual | V191002

Introduction

Product description

The Evnex R-Series charging stations are a cost effective smart charging

solution, available in both single phase 7kW, and three phase 22kW

configurations.

When connected to a compatible OCPP (Open Charge Point Protocol)

server, the Evnex R-Series charging stations become an excellent choice

for smart-grid managed charging or public charging, where energy

metering or access control is required.

Evnex R-Series Installation Manual | V191002

General dimensions

Evnex R-Series Installation Manual | V191002

About this document

The following document describes the functionality and installation

procedures for the Evnex R-Series of electric vehicle charging stations.

Scope of this document

This document only refers to the following R-Series charging stations,

please refer to the correct documentation if this does not apply.

Three phase

•R22-T2S-3G

•R22-T2S-LTE

•R22-T2T-3G

•R22-T2T-LTE

Single phase

•R7-T1T-3G

•R7-T1T-LTE

•R7-T2S-3G

•R7-T2S-LTE

•R7-T2T-3G

•R7-T2T-LTE

Evnex R-Series Installation Manual | V191002

Symbols

You will find the following symbols throughout this document. Please pay

attention to the recommendations.

CAUTION –Failure to follow these directions may cause

minor injury or damage to equipment.

WARNING –Failure to follow these directions may cause

serious injury or death.

Evnex R-Series Installation Manual | V191002

Safety information

General information

•This unit should only be installed by those who are appropriately

qualified and skilled to do so.

•This unit has been designed and tested in accordance with IEC

61851-1:2017 and IEC 61851-21-2:2018, however the installer is

responsible for ensuring that all local regulations and standards

are complied with.

•Modifications to this product by anyone other than an authorised

service technician may void the warranty.

•There are no user serviceable parts inside the charging station. Do

not attempt to repair the charging station yourself.

•It is the user’s responsibility to ensure that the cable is stored

safely, and not left where it could become a tripping hazard, or

subject to stress or damage.

•This charging station should only be used to charge a vehicle with

a compatible J1772 socket, or IEC 61851 type 1 or type 2 socket.

Risk of electric shock

•Read all instructions before installing or using this product

•Do not use this product if it appears to be damaged in any way,

this includes fraying or broken insulation on the power cable or any

signs of cracking or separation on the connector or charging unit

•Do not attempt to replace components

•Do not use extension cords or any kind of adapter with this

product

•This product should not be used by children

•Avoid installing this product in locations that are prone to flooding

Disclaimer

Evnex R-Series Installation Manual | V191002

Evnex Limited shall not be liable in any way for damage or injury that

occurs when using the product, and all warranties will be void where:

•The installation instructions have not been followed correctly

•The product has been installed by an unqualified person

•The product has been tampered with or modified

•The product has been used for a purpose other than it was

designed and intended for

Installation

Evnex R-Series Installation Manual | V191002

Site selection

•Consider pedestrians and other traffic, ensure that the charging

cable does not pose a tripping hazard.

•If possible, avoid installing the charging station in a place where it

can be damaged by falling objects, doors, vehicles or machinery

•Although this charger is designed for indoor and outdoor

installations, it is recommended that exposure to rain, snow, hail

and direct sunlight is minimized where reasonable to increase

lifespan

•Do not allow this charging station to be subject to water spray

such as water blasters or high-pressure hoses

•The attachment surface must be sufficiently strong to withstand

normal use, non-tethered versions are subject to extra forces when

plugging and unplugging

•Ensure that the attachment surface is flat - an uneven surface may

warp the enclosure and prevent installation of the front cover

•Consider signage locations for warnings such as “Trip Hazard” if

applicable

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Evnex Chargeur de batteries

Evnex

Evnex E Series Guide de l'administrateur

Manuels Chargeur de batteries populaires d'autres marques

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Manuel utilisateur

Enelion

Enelion Vertica Manuel utilisateur

RCA

RCA CHU6 Manuel utilisateur

ANSMANN

ANSMANN ALCT 6/24-10 Manuel utilisateur

Hitachi

Hitachi UC 18YRSL Guide de dépannage

Olympus

Olympus B-20 LPC Manuel utilisateur

Exibel

Exibel ZH1708143 Manuel utilisateur

Lenmar

Lenmar Mach 1 Manuel utilisateur

CTEK

CTEK MXS 5.0 Manuel utilisateur

ABB

ABB HT842379 Manuel utilisateur

Nitecore

Nitecore Superb Charger SC4 Manuel utilisateur

Renogy

Renogy RBC2125DS-21W Manuel utilisateur

Braun

Braun BWC02M Manuel utilisateur

CTEK

CTEK MXS 3.6 Manuel utilisateur

Black & Decker

Black & Decker BDV090 Manuel utilisateur

Trinity

Trinity DPD Manuel utilisateur

Hulkman

Hulkman Sigma 1 Manuel utilisateur

IKEA

IKEA koppla Manuel utilisateur