
Page 3
EVERSAN INC.
SYNERGY
TM
resources
EVERSAN, INC. • 34 Main Street, Whitesboro, NY 13492 • 1-800-383-6060 Fax: 315-736-4058
www.eversan.com
breaker box be used to turn off the system at the end of use each day. The scoreboard should
always be powered down when not in use.
Power up Sequence:
120VAC Operation (Cabled System)
1. Plug the control console into the scoreboard using the cable provided. Any of the 2-pin
connectors on the control console can be used. The connector for the scoreboard is located
on the back (see diagram).
2. Power up the scoreboard using 120VAC,connection on back of scoreboard (see diagram).
3. The scoreboard will now go through diagnostics. Each digit will show a dash and then
starting at the minutes each digit will show an 8 and then go blank. The scoreboard will
then stay blank until the control console is turned on.
4. Turn the control console on using the rocker switch located on the upper left side. The
control console will display “WIRELESS NETWORK SYSTEM ID = NO” for approx. 5
seconds. The display will then show, ”EVERSAN, INC. DISPLAY SYSTEMS”, and then
“TIME=00:00.0 9, H=00 PER.=0 G=00”. You are now ready to use the operating
instructions to test all the functions.
Note: If the control console will not power up or shows “BATTERY LOW” replace the
battery with a 9V alkaline battery or use the 9-volt adapter provided.
WIRELESS OPERATION
Eversan, Inc.’s 2.4GHZ frequency hopping wireless control system allows for multiple scoreboards to
be controlled separately or together within feet of each other.
Initializing the wireless system:
The following steps must be used to ensure proper communication from the 9384 wireless control
console and each scoreboard you want to control.
1. Turn the power on to each 9384 scoreboard that you want to control. The scoreboards will show a
dash in each digit location.
2. Connect the antenna, 9VDC adapter provided or optional 12-volt battery, to the 9384 wireless
control console (see diagram for proper placement).
Turn the control console on using the rocker switch located on the upper left side. The control console
will display “WIRELESS NETWORK SYSTEM ID = XX” for approx. 5 seconds. The display will then
show, ”EVERSAN, INC. DISPLAY SYSTEMS”, and then “TIME=00:00.0 9, H=00 PER.=0 G=00”.
You are now ready to use the operating instructions to test all the functions.
Operating instructions: