EverFocus 410M Manuel utilisateur

INSTRUCTION MANUAL

Digital Eight Channels/Four Channels Video Recorder

About this manual

Before installing and using this unit, please read this Manual carefully.

Be sure to keep it handy for later reference.

V 1.21

EDR810H/810M/

410H/410M

Updated on: Nov. 17th 2005

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one of the following

measures :

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

•Consult the dealer or an experienced radio/TV technician for help.

FCC Caution : Any changes or modifications not expressly approved by the party responsible

for compliance could void the users’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions : (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

This device and its antennas(s) must not be co-located or operating in conjunction with any

other antenna or transmitter.

This advice complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may cause

undesired operation.

WARNING

TO REDUCE RISK OF FIRE OR ELECTRIC SHOCK,

DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

Note:

This equipment has been tested and found to comply with the limits for a Class A digital device,

The changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

Notice:

The information in this manual was current when published. The manufacturer

reserves the right to revise and improve its products. All specifications are

therefore subject to change without notice.

Safety Warning

Note:

This is a class A product. In a domestic environment this product may cause radio interference

In which case the user may be required to take adequate measures.

?Refer all work related to the installation of this product to qualified service

personnel or system installers.

?Do not block the ventilation opening or slots on the cover.

?Do not drop metallic parts through slots.This could permanentlydamage

the appliance. Turn the power off immediately and contact qualified service

personnel for service.

?Do not attempt to disassemble the appliance.To prevent electric shock,

do not remove screws or covers. There are no user-serviceable parts

inside. Contact qualified service personnel for maintenance. Handle the

appliance with care. Do not strike or shake, as this may damage the

appliance.

?Do not expose the appliance to water or moisture, nor try to operate it in

wet areas. Do take immediate action if the appliance becomes wet.

Turn the power off and refer servicing to qualified servicepersonnel.

Moisture may damage the appliance and also cause electric shock.

?Do not use strong or abrasive detergents when cleaning the appliance

body.Use a dry cloth to clean the appliance when it is dirty. When the

dirt is hard to remove, use a mild detergent and wipe gently.

?Do not overload outlets and extension cords as this may result in a risk of

fire or electric shock.

?Do not operate the appliance beyond its specified temperature, humidity

or power source ratings. Do not use the appliance in an extreme

environment where high temperature or high humidity exists.Use the

appliance at temperature within indoor type DVR for 0oC ~ +40oC and a

humidity below 90%.

The input power source for this appliance is AC100~240V.

Safety Precautions

The exclamation point within an equilateral triangle is

intended to alert the user to presence of important operating

and maintenance(servicing)instructions in the literature

accompanying the appliance.

Warning :

To prevent fire or shock hazard, do not expose units not

specifically designed for outdoor use to rain or moisture.

Safety Precautions

The lightning flash with an arrowhead symbol, within an

equilateral triangle, is intended to alert the user to the presence

of uninsulated ”dangerous voltage”within the product’s enclosure

that may be of sufficient magnitude to constitute a risk of electric

shock to persons.

Attention:

Installation should be performed by qualified service personnel only

in accordance with the National Electrical Code or applicable local codes.

Power Disconnect:

Units with or without ON-OFF switches have power supplied to the unit

whenever the power code is inserted into the power source; however, the

unit is operational only when the ON-OFF switch is in the ON position.

The power cord is the main power disconnect for all units.

External Power Supplies

Use only the recommended power supplies.

Power supplies must comply with the requirement of

the latest version of IEC 60065/CNS 13439. Substitutions

may damage the unit or cause a fire or shock hazard.

AC100~240V Power Cords

AC100~240V power cords

Warning:

Electrostatic-sensitive device. Use proper

CMOS/MOSFET handing precautions to avoid

electrostatic discharge.

Safety Precautions

Do not place on uneven or unstable work surfaces.

Seek servicing if the casing.

Important Safeguards

Read Instruction---All the safety and operating instructions should be read before the unit is operated.

Retain Instructions---The safety and operating instructions should be retained for future reference.

Heed Warnings—All warnings on the unit and in the operating instructions should be adhered to.

Follow Instructions—All operating and use instructions should be followed.

Cleaning—Unplug the unit from the outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.

Use a damp cloth for cleaning

Attachments—Do not use attachment not recommended by the product manufacturer as they may cause hazards.

Water and Moisture—Do not use this unit near water-for example, near a bath tub, wash bowl, kitchen sink,

or laundry tub, in a wet basement, near a swimming pool, in an unprotected outdoor installation, or any area which is

classified as a wet location.

Servicing— Do not attempt to service this unit by yourself as opening or removing covers may expose you to dangerous

voltage or other hazards. Refer all servicing to qualified service personnel.

Power Cord Protection—Power supply cords should be routed so that they are not likelyto be walked on or pinched by

items placed upon or against them, playing particular attention to cords and plugs, convenience receptacles, and the point

where they exit from the appliance.

Object and Liquid Entry—Never push objects of any kind into this unit through openings as they may touch dangerous

voltage points or short-out parts that could result in a fire or electric shock.Never spill liquid of any kind on the unit.

Important Safeguards

Table of Contents

1. PRODUCT INTRODUCTION …………………………………………………………….…………

1.1 FEATURES …………………………………………………………………..…………..………….

1.2 SPECIFICATIONS…………………………………………………………………………….………

1.3 FRONT PANEL KEYPADS …………………………………………………………..…….………

1.4 BACK PANEL CONNECTORS …………………………………………………………….………

1.5 MONITOR DISPLAY ……………………………………………………………………….………

2. INSTALLATION …………………………………………………………………………….…………

2.1 PACKING LIST ………………………………………………………………………...…….………

2.2 SYSTEM FLOORPLAN ………………………………………………………..…………….………

2.3 BASIC CONNECTIONS ………………………………………..…………………….…….………

2.4 BOOT UP EDR810/410……………………………………………………..……………….………

2.5 QUICK INSTALLATION GUIDE FOR EDR810M & EDR410M ONLY……….…………………

3. MENU SETUP…………………………………………………………………………………………

3.1 TIME/DATE SETUP MENU …………………………………….……………………………….…

3.2 CAMERA SETUP MENU ……………………………………………………………………….….

3.3 RECORD SETUP MENU ………………………………………..…………………………….……

3.4 ALARM SETUP MENU ……………………………………………………………………….……

3.5 MOTION SETUP MENU ………………………………………..……………………………………

3.6 VLOSS SETUP MENU ………………………………………….…………………………….……

3.7 NETWORK SETUP MENU ……………………………………..…………………………….……

3.8 SCHEDULE SETUP MENU …………………………………………………………………………

3.9 DISK SETUP MENU ……………………………………………………………………….………

3.10 CONTROL SETUP MENU ……………………………………………………………………….

3.11 WARNING SETUP MENU…………………………………………………………………………

3.12 SYSTEM SETUP MENU …………………………………………………………………….……

4. RECORDING …………………………………………………………………………………………

4.1 INSTANT RECORDING ………………………………………………………………………..……

4.2 SCHEDULE RECORDING …………………………………………………………………………

4.3 EVENT RECORDING ………………………………………………………….……………….……

4.4 ALARM INPUT RECORDING ……………………………………………..………………………

Table of Contents

5. PLAYING BACK……………………………..……………………………………………..………...

5.1 NORMAL PLAYBACK……………….………………………………………………………………

5.2 SEARCH PLAYBACK …………………………………………………….…………………………

6. COPY TO A VIDEO FILE ………………………………………………….…………………………

7. CALL ………………………………………………………………………..……….…………………

8. SCREEN DISPLAY SETTING …………………………..………………..…………………………

9. SCREEN DISPLAY MODE ………………………………….…………….…………………………

10. REMOTE VIEWER ……………………………………..………………..…………………………

APPENDIX A: RS232 specifications …………………………………………….……………………

APPENDIX B: RS485 specifications ……………………………………………….…………………

APPENDIX C: Alarm I/O Assignment ………………………………………….…………….………

APPENDIX D: Troubleshooting ……………………………………….……….…………….………

?Duplex Operation for Recording & Playback

?Built-in MPEG4 Codec with Configurable Quality

?Variable Recording Speeds up to 60/50 Images per second for NTSC/PAL

?Audio Recording Capabilities

?Motion Detection Capabilities

?One 3.5”Hard Disk with Hot-Swap Tray for Internal Storage

?Ethernet Interface for Remote Network Viewing

?Optional Wireless LAN Interface for Data Transmission (Reserved)

?RS232 and RS485 for Remote Control

?Shuttle/Jog Dial for Picture-by-Picture or Fast/Slow Viewing

?Easy-to-use Control Panel with Common VCR and Multiplexer Functions

?On-Screen Menus Operations with Multi-Language Support

?Real-Time Live Display for all Cameras

?Easy archiving of video and Remote Viewer through USB port

1. PRODUCT INTRODUCTION

1.1 FEATURES

The Digital Video Recorder is the industry’s first full-featured digital video recorder

designed specifically for use in security industry. The DigitalVideo Recorder

incorporates all the benefits of digital video recording, is simple to install, and operates

just like a VCR. Highly efficient compression technology and superior resolution of

recorded images make the Digital Video Recorder stand out from the competition as the

best choice for security surveillance.

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels EverFocus DVR

EverFocus

EverFocus 920 Manuel utilisateur

EverFocus

EverFocus VANGUARD 16x8H Plus Manuel utilisateur

EverFocus

EverFocus ENDEAVOR 264X4 Manuel utilisateur

EverFocus

EverFocus EMV400 FHD Manuel utilisateur

EverFocus

EverFocus ENR 400 Manuel utilisateur

EverFocus

EverFocus ECOR960 4F2 Manuel utilisateur

EverFocus

EverFocus DVR-100H Manuel utilisateur

EverFocus

EverFocus ECOR Series Manuel utilisateur

EverFocus

EverFocus VANGUARD II 16x8H Manuel utilisateur

EverFocus

EverFocus ECOR4D Mode d’emploi

EverFocus

EverFocus PowerPlex EDR1600 Manuel de service

EverFocus

EverFocus EDSR-400 Manuel utilisateur

EverFocus

EverFocus PARAGON 264x1 Manuel utilisateur

EverFocus

EverFocus EDSR400H Manuel utilisateur

EverFocus

EverFocus PARAGON FHD 16x4 Manuel utilisateur

EverFocus

EverFocus EDR810H Manuel utilisateur

EverFocus

EverFocus eNVP-JNN-IV-V0008 Manuel utilisateur

EverFocus

EverFocus Paragon 264 Series Manuel utilisateur

EverFocus

EverFocus H.265 VANGUARD II Series Manuel utilisateur

EverFocus

EverFocus EDSR 400F Manuel utilisateur

EverFocus

EverFocus EPHD08 Manuel utilisateur

EverFocus

EverFocus EPHD04 Manuel du propriétaire

EverFocus

EverFocus EDSR 900F Manuel

EverFocus

EverFocus NVR8008X Manuel utilisateur

Manuels DVR populaires d'autres marques

FLIR

FLIR M3100E Series Manuel utilisateur

VTRACKPRO

VTRACKPRO FPRO300 Manuel utilisateur

Swann

Swann NVR-7085 models Manuel utilisateur

XtendLan

XtendLan DVR-1670C Manuel utilisateur

urmet domus

urmet domus 1093/004AHD Manuel utilisateur

Holux

Holux M1 Manuel utilisateur

CMOS DOTCOM

CMOS DOTCOM ANX-1670 Manuel utilisateur

Whistler

Whistler D16VRS Manuel utilisateur

Defender Security

Defender Security 82-20235 Manuel utilisateur

MISUMI

MISUMI MP-WF100M Manuel utilisateur

Speco

Speco D8HU Manuel utilisateur

UST

UST DDR-E04AA Instructions d'utilisation

Consolidated

Consolidated Digital Video Recorder Manuel utilisateur

Mace

Mace DVR0404RW Guide de démarrage rapide

RCA

RCA RTD315W Manuel utilisateur

FSM

FSM Colibri Grande PRO Manuel utilisateur

Hauppauge

Hauppauge HD PVR 2 Manuel utilisateur

Identivision

Identivision ICR-PH161i PIONEER Manuel utilisateur