The batteries are labeled accordingly inside the unit
Pushing Reset Button (Green) will take the units out of test mode.
(Please remember to wait a minimum of 60 seconds before a Test/Activation can be
run)
Full Activation (Red Button)
Pushing the main Activation Button (Red) will put the system into full alarm. Full
alarm will trigger both the Strobe light and Siren on the unit plus any other devices
on the same frequency that is in range.
The system can be silenced and reset from any unit by pushing the green reset
button. However the device that initiated the full alarm will continue to flash the
strobe until a further push of the reset button is made on the flashing device that
activated the system. This allows the user to identify the unit that triggered the
alarm.
Evacuator Site Alarms
Evacuator 3 Month Limited Warranty
This warranty is limited to the original purchaser and is not transferable. REPAIR OR
REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE
PURCHASER.
This warranty covers only these products purchased from an authorized Evacuator dealer.
Third party transactions are not covered by this warranty. Proof of purchase is required for
warranty claims. Further, Evacuator alarms reserves the right to change or modify this
warranty without notice.
Damage Units
EVACUATOR ALARMS SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT OR CONSEQUENTIAL
DAMAGES, LOSS OF PROFITS, DEATH OR PRODUCTION OR COMMERCIAL LOSS. IN ANY WAY
CONNECTED WITH THE PRODUCT WHETHER SUCH A CLAIM IS BASED IN CONTRACT,
WARRANTY, NEGLIGENCE OR STRICT LIABILITY. Further, in no event shall the liability of
Evacuator Alarms exceed the individual purchased price of the product which liability is
asserted. As Evacuator Alarms has no control over use, setup, final assembly, modification or
misuse, no liability shall be assumed nor accepted for any resulting damage or injury. By the
act of use, setup or assembly, the user accepts all resulting liability.
If you are the purchaser or user and are not prepared to accept the liability associated with
the use of this product, you are advised to return this product immediately in new and
unused conditioned to the place of purchase.
NOTE: WE RESERVE THE RIGHT TO CHANGE PRODUCT SPECIFICATION
WITHOUT PRIOR NOTICE.
Warranty Exclusions
Battery Packs, Damaged Cases, Control Buttons, Key Switches, LED’s and Strobe
lights. The operation of the PCB is not covered if it is evident that the unit has
been misused or suffered an impact to any part of the exterior casing.
