Eurotherm 7000 Series Manuel utilisateur

Three phase

solid state

contactor

User Manual

73007300

ENG

•DATAMANAGEMENT • CONTROLS • PROCESS AUTOMATION•

7000 RANGE

7300S

SMART CONTROLLER

THREE-PHASE

SOLID STATE CONTACTOR

User Manual

©Copyright Eurotherm Limited 2003

(electronic or mechanical, including photocopying and recording) without written permission from

Eurotherm is strictly prohibited.

Ref.: HA176661 ENG - Issue 3 - 03/2009

7300S User Manual

Check characteristics

Wiring

Fan power supply

Apply control signal

Power on.

Check firing

Adjust DLF alarm

(if conditions met)

Normal operation

CHK/SET push button

Characteristics correspond

to product code

and specifications

Chapter 1

Supply protection,

protective earth (PE)Chapter 2

For fan-cooled

solid state contactors Chapter 2

Chapter 2

Chapter 4

Alarms signalled Chapter 3

Chapter 3

GRF, DLF LEDs

DC logic signal:

"LDC" terminal block

AC logic signal:

"HAC" terminal block

4-20 mA analogue signal:

"ATP" terminal block

Chapter 2

ON, HEAT LEDs

Power:

Supply side:

terminals 1/L1, 3/L2, 5/L3

Load side:

terminals 2/T1, 4/T2, 6/T3

Chapter 2

COMMISSIONING FLOWCHART

7300S User Manual iii

Contents

CONTENTS

Page

Commissioning flowchart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .ii

European directives and applicable standards . . . . . . . . . . . . . . . . .iv

Chapter 1 Identification of solid state contactor . . . . . . . . . . .1-1

Chapter 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-1

Chapter 3 Alarms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3-1

Chapter 4 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4-1

Eurotherm Limited ....................................5-1

PURPOSE OF MANUAL

This manual ( Issue 3)describes the Basic Version and all Options

for 7300S series solid state contactors with current ratings up to 160 A.

7300S User Manual

EUROPEAN DIRECTIVES AND APPLICABLE STANDARDS

COMPLIANCE WITH PRODUCT STANDARD

7300S products comply with the terms of product standard EN 60947-4-3 ‘Contactors and

motor-starters - AC semiconductor controllers and contactors for non-motor loads’.

CE LABELLING

7300S products, installed and operated in accordance with their user manual, bear

CE labelling on the basis of compliance with the essential requirements of :

•the European Low Voltage Directive 73/23 EEC dated 19 February 1973

modified by 93/68 EEC dated 22 July 1993

•the Electromagnetic Compatibility Directive 89/336/EEC dated 3 May 1989

modified by 92/31/EEC dated 28 April 1992 and 93/68/EEC dated 22 July 1993.

SAFETY

The units have IP20 protection rating as defined by standard IEC 60529.

External wiring must comply with standards IEC 60364-4-43 and IEC 60943.

Copper cables and conductors must be used, rated to a temperature of 75°C (167°F).

ELECTROMAGNETIC COMPATIBILITY (EMC) TEST STANDARDS

7300S products installed and used in accordance with the user manual, are designed for

an industrial environment and not a commercial or light industrial premises and must

not be used in the home.

IMMUNITY

The EMC immunity test standards required by product standard EN 60947-4-3 are given

in the table following :

European directives and applicable standards

Test type Minimum level EMC test standard

Electrostatic discharge 4 kV on contact; 8 kV in air EN 61000-4-2

Radiated, radio frequency 10 V/m 80 MHz ≤f≤1 GHz ;

electromagnetic field 80% modulation 1 kHz sinusoid EN 61000-4-3

Electrical fast transient / burst 2 kV / 5 kHz EN 61000-4-4

Electrical Surge 4 kV line to earth

2 kV line to line EN 61000-4-5

Conducted disturbances 140 dBµV;150 kHz ≤f≤80 MHz EN 61000-4-6

Voltage dips and 5 s interruptions EN 61000-4-11

short interruptions

Table 1 EMC immunity standards compliance

7300S User Manual v

EMC GUIDE

To help you deal with installation-dependent electromagnetic interference effects,

Eurotherm provides an ‘Electromagnetic compatibility’ installation guide (ref. HA 025464)

which sets out best current practice regarding EMC.

DECLARATION OF CONFORMITY

ACE declaration of conformity is available on request.

European directives and applicable standards

EMISSIONS

The EMC emissions test standards required by product standard EN 60947-4-3 are given

in the table following :

Table 2 EMC emissions standards compliance

Emission type Firing mode EMC test standard

Radiated at radio All firing modes CISPR 11 Class A

frequencies

Conducted at radio All firing modes CISPR 11 Class A

frequencies Group 2

7300S User Manual

7300S User Manual 1-1

Identification

Chapter 1

1. IDENTIFICATION OF SOLID STATE

CONTACTOR UNITS

Contents Page

1.1. General presentation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-2

1.2. Technical specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-5

1.2.1. Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5

1.2.2. Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5

1.2.3. Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5

1.2.4. Signalling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.5

1.2.5. Firing Modes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.6

1.2.6. Inputs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.6

1.2.7. Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.6

1.2.8. Alarms . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.7

1.2.9. Protection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.7

1.2.10. Environment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.8

1.2.11. Dimension . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.8

1.2.12. Mounting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.8

1.2.13. Digital Communication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.8

1.3. Coding . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-10

Identification

7300S User Manual

1-2

1. Chapter 1 IDENTIFICATION

1.1 GENERAL PRESENTATION

7300S series solid state contactors control the electrical power to three-phase industrial

loads such as low temperature coefficient and short wave infrared elements.

Standard ratings in the series range from 16 A to 160 A,at voltages from 200 V to 500 V.

7300S series solid state contactors comprise three channels, controlled by thyristors.

Depending on the type of control signal and the type of input specified, 2 operating modes

are available: logic (‘on/off ’) or modulation (‘Burst mode’).

Figure 1-1 General view of 7300S with digital communication control - ratings from 16 A to 40A

GRF

DLF CHK

HEAT

SET

7300S

EUROTHERM

3/L2

4/T2

2/T1

1/L1

5/L3

6/T3

Protective earth

terminal

Power terminals

(supply side)

Power terminals

(Load side)

Internal

wiring diagram

Control terminals

labelling

Serious Alarm

(if DLF option)

Supply present

Firing request

Diagnostic Alarm

(if DLF option)

40 A / 500 V

EN 60947-4-3

Digital communication

Transmission LEDs and

configuration microswitches

ON/

Dxch

12345678

Control

terminal block

CHK/SET

push-button

ALR

1a 1b

73 74

COM

B A

91 92

Aux1

230 N

16 17 18

Aux2

GND 24V 0VS

15 19 20

7300S User Manual 1-3

Identification

GRF

DLF CHK

HEAT

SET

7300S

EUROTHERM

3/L2

4/T2

2/T1

1/L1

5/L3

6/T3

63 A / 500 V

EN 60947-4-3

Aux1

230 N

16 17 18

Aux2

GND 24V 0VS

15 19 20

Protective earth

terminal

Power terminals

(supply)

Power terminals

(load)

Internal

power wiring

diagram

Control terminal

pinouts

Electronics supply

Zero crossing firing mode:

Firing request LED

Control connector

ATP

0VA R1

11 12

Serious Alarm

(if DLF option)

Diagnostic Alarm

(if DLF option)

Figure 1-2 General view of 7300S with analogue control - ratings from 63 A to 100 A

Autres manuels pour 7000 Series

Ce manuel convient aux modèles suivants

Table des matières

Autres manuels Eurotherm Contrôleurs

Eurotherm

Eurotherm 3508 Manuel utilisateur

Eurotherm

Eurotherm 3500 series Manuel utilisateur

Eurotherm

Eurotherm P304c Manuel utilisateur

Eurotherm

Eurotherm 2604 Manuel du propriétaire

Eurotherm

Eurotherm Invensys Mini8 Manuel d'installation et d'exploitation

Eurotherm

Eurotherm 7000 Series Manuel utilisateur

Eurotherm

Eurotherm T940X Manuel d'utilisation

Eurotherm

Eurotherm P304c Manuel utilisateur

Eurotherm

Eurotherm 2132 Manuel utilisateur

Eurotherm

Eurotherm epack Manuel utilisateur

Eurotherm

Eurotherm epack Manuel utilisateur

Eurotherm

Eurotherm Invensys Mini8 Manuel utilisateur

Eurotherm

Eurotherm 2704 Manuel utilisateur

Eurotherm

Eurotherm 2416 Manuel du propriétaire

Eurotherm

Eurotherm Invensys 2408 Manuel utilisateur

Eurotherm

Eurotherm 7000 Series Manuel utilisateur

Eurotherm

Eurotherm 2100 Manuel utilisateur

Eurotherm

Eurotherm 2500 Manuel utilisateur

Eurotherm

Eurotherm 3508 Manuel utilisateur

Eurotherm

Eurotherm 7000 Series Manuel utilisateur

Eurotherm

Eurotherm Invensys Mini8 Instructions de montage

Eurotherm

Eurotherm 902 Series Manuel utilisateur

Eurotherm

Eurotherm 808 Manuel utilisateur

Eurotherm

Eurotherm 2216e Manuel utilisateur

Manuels Contrôleurs populaires d'autres marques

Digiplex

Digiplex DGP-848 Mode d'emploi

YASKAWA

YASKAWA SGM series Manuel utilisateur

Sinope

Sinope Calypso RM3500ZB Manuel utilisateur

Isimet

Isimet DLA Series Style 2 Manuel d'installation

LSIS

LSIS sv-ip5a Manuel utilisateur

Rockwell Automation

Rockwell Automation 1769-L31 Manuel utilisateur

Airflow

Airflow Uno hab Manuel utilisateur

ABB

ABB ACS580-01 drives Manuel utilisateur

Panasonic

Panasonic GM1 Series Manuel utilisateur

Emerson

Emerson SW93 Manuel utilisateur

AutoAqua

AutoAqua Smart ATO micro SATO-120P Manuel utilisateur

Panasonic

Panasonic FP? Positioning Unit RTEX Manuel utilisateur

Samson

Samson Type 5824 Manuel de service

Alpha IP

Alpha IP MIOB 21001 Manuel utilisateur

Siemens

Siemens OpenAir GMA 1 Series Manuel utilisateur

Surecom

Surecom SR-629 Manuel utilisateur

Fishman

Fishman TriplePlay Manuel utilisateur

Regulus

Regulus SRS1 T Manuel utilisateur