The freezer is an advanced fridge,combing the latest compressor and
computerized digital control system technology.The high efficiency of the
compressor will freeze as -18°C at 30°C ambient temperature.(The
computerized digital control system will indicate direct readout display
inbox actual cooling temperature).It is in energy saving mode when the
actual cool temperature is below “set-temperature”(setting with press
down/up button) 1°C,and the compressor ceases operation.After the
inbox temperature is higher than “set-temperature” 2°C,the compressor
run again, but interal time will be two minutes at least.
Please pay an attention,when turn the freezer on,the compressor will
be run at once.
Once the desired temperature is setted,wait with 5 seconds(”di,di”
5 noise)to confirm the setting.
Please make sure that no parts are missing after unpacing the cooler.
Installation
Operating Instr uctions
Place the cooler on a dry surface where it is protected from water.
The cooler should not be used where it may be exposed to rain.
The cooler should be installed in a position that allows adequate ventilation.
Do not locate the cooler anywhere the room temperature is below 0℃ .
The cooler can be operated with 12 V/24V DC. Prior to connection, check
whether the voltage indicated on the manufacturers label is in accordance with
the battery voltage. Connect your cooler to cigarette lighter socket of your
vehicle with the 12V/24V DC .
NOTE:The cooler can be operated between 10.3V and 17V DC or 22V and
30V DC.If the voltage is out of range,the cooler will be not work.Over
voltage could cause damage to the electronic components of the cooler.
When using the cooler indoors from mains,please use the AC/DC adapter
supplied with your unit.
Uing an AC/DC adapter,otherwise, it may cause damage to the cooler use
others.
