Eurolux EL-B3015 Manuel utilisateur

Owner’s Manual

COOL TOUCH ELECTRIC WATER KETTLE

pg 1

Model#: # EL-B3015 Supply Voltage: 120V, 60Hz

Rated Power: 1500 W Max Capacity: 1.5 L

SPECIFICATIONS

FEATURES

Spout

Handle

Kettle

Lid

Power

Cord

Base

Water

Level

Unlocking

Buttons Display

Panel Keep

Warm

Temp.

Control

On/O

pg 2

IMPORTANT SAFEGUARDS

This appliance is for HOUSEHOLD USE ONLY.

When using an electrical appliance, basic safety precautions should always

be taken, including the following:

1. READ ALL INSTRUCTIONS BEFORE USE.

2. Unplug from outlet when not in use and before cleaning. Allow to cool

before putting on or taking o parts, and before cleaning appliance.

3. Do not touch hot surfaces. Use handle.

4. To protect against re, electric shock and injury to persons, DO NOT

IMMERSE CORD, PLUG OR BASE UNIT in water or other liquids.

5. Close supervision is necessary when any appliance is used by or near

children.

6. Do not operate any appliance with a damaged cord or plug, or aer the

appliance has malfunctioned or has been damaged in any way. Return

appliance to the nearest authorized service facility for examination, repair

or adjustment.

7. The use of accessory attachments not recommended by the

manufacturer may result in re, electric shock or injury to persons.

8. Do not use outdoors.

9. Do not let power cord hang over edge of table or counter, or touch hot

surfaces.

10. Do not place on or near a hot gas or electric burner, or in a heated oven.

11. To disconnect, press the ON/OFF button, then remove plug from wall

outlet.

12. Do not use appliance for anything other than intended use.

13. Scalding may occur if the lid is opened during the heating cycle.

14. Ensure lid is securely closed before serving any beverages.

15. The kettle must never be used on a range top.

16. Do not set a hot container on a wet or cold surface.

17. Do not use a cracked container or a container having a loose or weakened

handle.

18. Do not clean container with cleansers, steel wool pads, or other abrasive

material. This appliance has a polarized plug (one blade is wider than

the other). To reduce the risk of electric shock, this plug is intended to

t into a polarized outlet only one way. If the plug does not t fully into

the outlet, reverse the plug. If it still does not t, contact a qualied

electrician. Do not attempt to modify the plug in any way.

SAVE THESE INSTRUCTIONS

pg 3

BEFORE YOUR FIRST USE

1. Clean the kettle by lling with water up the MAX mark and boiling it (see

Section below).

2. Pour the water away for hygiene reasons.

3. Repeat the procedure 2x.

4. Remove the kettle from the packaging and carefully remove all packaging

material.

5. Check the kettle and base for possible transport damage.

6. Unwind the power cable from the cable winder. This is on the underside

of the base.

7. Lead the cable through one of the cable recesses.

8. Place the base on an even and stable surface. This surface should be easy

to clean, brightly lit and easily accessible.

9. Place the kettle on the base.

10. Insert the power plug into a socket with protective contacts.

USE OF THE KETTLE

PRIOR TO BOILING WATER

1. Press the KEEP WARM button.

2. Press the SET TEMP button repeatedly until the appropriate temperature

digits on DISPLAY PANEL illuminates in the operating panel.

3. Press the ON/OFF button in order to start the boiling and subsequent

keep-warm process. The digits on the DISPLAY PANEL of the relevant

temperature, and the KEEP WARM button will illuminate. The water is

heated and then the keep warm function will activate.

During boiling:

1. Proceed as described in the “Boiling water” section on the following page.

2. Press the KEEP WARM button during boiling. After the water has boiled,

the digits on DISPLAY PANEL of the relevant temperature will illuminate,

and the KEEP WARM button will illuminate.

pg 4

The water will continue to be kept warm after heating.

BOILING WATER:

CAUTION: The kettle becomes hot during use. Burn hazard! Only hold the

handle. Hot water vapor escapes during heating and boiling. Scalding risk

if touched! Close the lid prior to switching the appliance on. Otherwise, the

appliance cannot switch off automatically and the hot water can over boil.

1. Remove the kettle from the base for filling.

2. Press the locking button for the lid (covered) in order to open the lid. Flip

the lid up. If you push the lid back slightly, it will lock in lightly and will not

shut again unintentionally.

3. Fill the required quantity of fresh, cold water. Pay attention to the fill level

display: The water level must be between MIN and MAX.

4. Close the lid again. Ensure that the lid audibly locks in.

5. Place the kettle on the base.

6. Press the ON/OFF button. Note: if you only intend to boil the water (212°

F ) there is no need to set the temperature, the water will automatically

be programmed to boil.

TO SET TEMPERATURE:

- Press the SET TEMP button repeatedly until the appropriate temperature

digits on DISPLAY PANEL illuminates in the operating panel. The

following 6 temperates can be selected: 212°, 200°, 190°, 185°, 175°, 160° F

- Press the ON/OFF button within 10 seconds. The selected temperature

digits on DISPLAY PANEL will flash. If the boiling procedure is not started

within 10 seconds, the set temperature will be lost and the procedure

must be repeated.

ONCE THE SELECTED TEMPERATURE IS REACHED:

- a signal tone sounds,

- the relevant temperature digits on DISPLAY PANEL illuminates for

another approx. 2 minutes,

7. Remove the kettle from the base. Only hold the kettle by the handle and

wait a moment, until the water is no longer bubbling.

8. Pour the water out slowly. Do not open the lid for this. Note: If you

have set the temperature to e.g. 212° as the required temperature, the

temperature digits on DISPLAY PANEL for 160°, 175°, 185°, 190°, 200°, 212° will

illuminate consecutively during the boiling procedure until the relevant water

pg 5

temperature has been reached. You can stop the boiling procedure at any time

by pressing the ON/OFF button.

KEEP WARM FUNCTION

• With a temperature of 212°, 200°, 190°, 185°, 175° ,160° you can keep the

water warm for kettle switches off automatically; three signal tones will

sound and LED, DISPLAY PANEL will extinguish.

• If you have set a keep-warm temperature of 212 , the water will be

kept warm within a range of 194-212° , in order to avoid excess steam

generation.

• If you have set a keep-warm temperature of 212°, 200°, 190°, 185°, 175°

,160° the water kettle will keep the temperature within a range of approx.

46.4° below/above the set temperature. Note: Only use the keep-warm

function if a minimum of 0.5 liters of water is in the kettle. Otherwise, the small

amount of water could boil away during the next 30 minutes and the dry-run

protection will switch the appliance off.

• If you cannot set a temperature, it is probably because the water

temperature in the kettle is still higher than the desired temperature.

• The keep-warm function can be activated before, during and directly after

boiling water.

• Memory function allows the kettle to be removed from the base without

Losing Its Preset Temp Settings at least 90s

AFTER BOILING

1. Press the KEEP WARM button as soon as the signal tone sounds at the

end of the boiling process. The appliance will automatically select the

temperature to which you have heated the water as the keep-warm

temperature.

2. The digits on the DISPLAY PANEL of the relevant temperature will

illuminate, the KEEP WARM button will illuminate. The water will be kept

warm.

DRYRUN PROTECTION

A dry-run protection safeguards the appliance from damage. The protection

switches on automatically if no more liquid is in the kettle. Note: The dry-run

protection should only be used as a safety device. It is not intended to be part of

the normal operating procedure for the appliance.

IF THE DRYRUN PROTECTION HAS BEEN ACTIVATED

1. Disconnect the power plug from the socket.

2. Allow the kettle to cool o. You can then ll the kettle with water again

and use as usual

pg 6

CLEANING & MAINTENANCE

Always make sure the kettle is unplugged and powered o before storing away

or cleaning. Make sure the unit has cooled down completely before cleaning.

The base, kettle and power cable must not be immersed in water or other liquids.

Electrical shock hazard!

1. Always allow the entire unit to cool completely before cleaning.

2. Wipe the outside of the kettle with a damp cloth. Wipe the base, and cord

with a damp cloth.

3. Open the lid and remove the sieve that is fastened in front of the spout.

For this, press the sieve down slightly and then fold it o. The sieve pre-

vents lime scale deposits and dirt particles from being poured out.

4. Rinse the sieve under running water or clean it using a damp cloth.

5. Reinsert the sieve into its holder in front of the spout. Ensure that it locks

in securely. If the sieve is already very calcied, place it into a mixture of

water and vinegar (6:1 ratio) for a few hours. Aerwards, rinse the sieve

with plenty of clear water.

DESCALING

You should descale the kettle on a regular basis, as a much calcied kettle

requires more electricity. How oen the appliance needs descaling will

depend on the hardness of the water used and frequency of use.

• With normal use, you should descale the kettle every 3 months with so

water and 1x per month with hard water.

• You should descale the appliance regularly to avoid thick calcication

forming on the heating element in the kettle. You can obtain information

about the water hardness in your area from the local water authority. For

descaling, you can use commercially available descaler (pay attention to

manufacturer instructions) or mix household vinegar with water in a 1:1

ratio.

1. Fill the kettle with descaling liquid and boil it.

2. Aerwards, leave the liquid to take eect, for approx. half an hour.

3. Where thick calcication is present: Boil the descaling liquid a second

time. Then, pour it away.

4. Rell the kettle with fresh water, boil the water and also pour it away.

Aerwards, you can use the kettle as usual.

105 Pleasant Avenue  Upper Saddle River  NJ 07458

201.785.8840 | sales@royaluxusa.com

V8.16

Table des matières

Manuels Bouilloire populaires d'autres marques

IKEA

IKEA UPPHETTA Manuel utilisateur

Krups

Krups BW500B55 Manuel utilisateur

Clas Ohlson

Clas Ohlson KE7086-BH Manuel utilisateur

Brock

Brock WK 0902 GR Manuel utilisateur

inventum

inventum CBW010 Manuel utilisateur

Westfalia

Westfalia Retro 81 48 86 Manuel utilisateur

Ovente

Ovente KS88 Series Dimensions

HUSLOG

HUSLOG AK-0832 Manuel utilisateur

Saturn

Saturn ST-EK840 Manuel utilisateur

Wilfa

Wilfa TK-1200B Manuel utilisateur

HOME ELEMENT

HOME ELEMENT HE-KT150 Manuel utilisateur

Breville

Breville Crystal Clear BKE290 Manuel utilisateur

ECG

ECG RK 1745 Manuel utilisateur

cecotec

cecotec THERMOSENSE 600 TOUCH BLACK Manuel utilisateur

Kalorik

Kalorik JK 39825 Manuel utilisateur

tomado

tomado TM-1971 Manuel utilisateur

Cosori

Cosori CS108-NK Manuel utilisateur

Electrolux

Electrolux E7K1-6BP Manuel utilisateur