Placement
Start
The refrigerator is placed in a
well-ventilated indoor place;
the ground shall be flat, and
sturdy (rotate left or right to
adjust the wheel for leveling if
unstable).
The refrigerator shall stay
for half an hour before
connecting 220V/50Hz
power when it is firstly
started.
The refrigerator shall run
2 to 3 hours before loading
fresh or frozen foods; the
refrigerator shall run for
more than 4 hours in
summer in advance
considering that the
ambient temperature is
high.
Ice tray (optional)
Thermostat
Illuminating lamp and replacement
The ice tray is used for making ice. Boiled water
injected to four-fifths of the capacity shall be placed
in the refrigerating chamber for about a few hours
before forming solid ice, twist the ice tray to separate
it from ice.
Do not bend the ice tray to avoid breakage.
Users may adjust the refrigerator according to the actual needs. It is generally recommended
to adjust to the third gear.
Under the same ambient temperature, larger number stands for more robust refrigeration
and lower temperature inside the chamber and vice versa.
On condition that the compressor runs for relative long time or large ice cubes are found in the
refrigerating chamber, adjust the thermostat knob to the direction of smaller numbers.
Knob on the figure represents only gear instead of specific temperature. ＂OFF＂ position of
the thermostat means stop working.
Before using the
refrigerator, remove all
packaging materials
including bottom
cushions and foam pads
and tapes inside the
refrigerator, tear off the
protective film on the door
and the refrigerator body.
Please leave enough space to
ensure feasible opening and
drawer removal.
Dimensions shown are for
reference only.
Keep away from heat and
avoid direct sunlight. Do not
place the freezer in moist or
watery places to prevent rust
or reduction of insulating
effect.
The top space of the refrigerator
shall be greater than 30cm, and
the distances from both sides and
backside shall be more than 10
cm to facilitate the opening and
closing and heat dissipation.
Wipe the refrigerator inside and
outside with warm moist rag (add
a small amount of detergent in the
warm water and wipe clean finally
with clean water).
900mm
545mm
920mm
520mm
Proper use of refrigerators
Illuminating lamp parameter: AC -240 50Hz/10W
Lighting lamps replacement:
Before changing the light bulb,please unplug the refrigerator first,
then pull down the light cover and change the light bulb according
to the picture.
220 V/
5
Water line
