Eufficio Innera Molla Manuel utilisateur

Insert the

Innera Molla

into the hole.Remove the 4 locking Clips by pulling & Pushing

it down the rail before you are Inserting the

Innera

Molla

into the hole.

Install the 4 locking Clips on the rails

and push it up to the surface. Tight the screws on the locking Clips to the surface

and

verify the

Innera Molla

is ﬁrmed and cannot be

moved.

Components:

Critical safety information:

Installation:

Operation:

Cleaning:

Tools required:

Power DrillPower Saw Hole Cutter

4 x Locking

Clips

Prior of use, please examine and verify that the product is not defected. Please do not install or operate if there is a defect of any kind.

If in any case you are facing misunderstanding of installation procedure, the installation should be carried out by certiﬁed electrician

Make sure you are installing the product on smooth straight surface. Do not install in any case that the surface is not straight or if there are levels differences.

Make sure water will not penetrate into the unit. In any case please make sure you are installing the unit, where proper leakage protection device is connected.

Drill hole into the surface according to the

INSTALLATION TABLE on page 2. Please verify

your purchased item's model No and drill the hole

according to the model's cutout dimensions.

Connect the GST Male connector to power

and the

Innera Molla

is ready for use.

For use, press the cover.

REMARK: In case you need to connect the

Innera Classic to a standard socket, you should buy

a starter cable separately which not included in this

Kit and connect it according to illustration above.

The product can be cleaned by a soft and dry fabric. Please do not use moisture, abrasives materials,solvents or any detergents which can be conductive

The Innera Molla is ready for use.

Innera Molla

ISRAEL

Design & Electric

www.eufficio.com

Engineered in Germany

ATTENTION:

Read the instructions prior to installation.

INSTALLATION INSTRUCTIONS

1 x Innera

Molla