ETS SM1 Series Manuel utilisateur

ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





LINELevelMicrophoneshavebuiltinpreampsandrequirepowertooperateasshowninFigure1.In

somecasesit’seasiertouseaninterfacebox(SMEA‐1,SMA1‐LPEA,SM2,etc.)topoweraSM1

microphoneandconnecttoIPCameraorDVR.

Figure1ashowdifferenttypesof3.5mmjacksandaRCAjackthatareusedtoconnecttoIPCameras.

TheAvigilonConnectionsshowsthe3.5mmTRRSjackwhichmeansTip,Ring1,Ring2andSleeve.Ifjust

usingamicrophonethenTipisusedforAudioINandRing2isusedforground.With2wayAudiouse

samemicrophoneconnectionsanduseSleeveforAudioOutandRing2forground.Note:groundsare

sharedbetweenaudioinandaudiooutthroughRing2.



Figure2isanexampleofdifferenttypesoflabelsonterminalblockconnectionsonIPCamerasfor

microphoneLineINandMICINinputs.The“someexamples”aresomeofthetypesoflabelweseenon

IPCameraswithterminalblocks.



AMICLevelMicrophonehasnopreampandispoweredbytheIPCamera.Inmostcases,MICLevel

Microphoneshaveastereo3.5mmmaleconnectorwiththeaudiosignalonTIPandRINGwhicharetied

togetherandSLEEVEisground.SomeIPCamerashavemonojacksformonauralMICInputs.CheckIP

camerasspecificationsheetoruser’smanualtoverifyinputismonauralinput.

Figure3showshowtoconnectanETSML1seriesmicrophonetoanIPCamera.

ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





ETS Inc

211 Conchas SE Albuquerque, NM 87123

Phone 505-888-3923 Fax 505-888-3926 E-mail: [email protected]





Problem: No audio from microphone or speaker with ETS interface box and IP camera



Possible cause: If your camera utilizes a 3.5mm MONO audio input or audio output the

provided STEREO 3.3mm patch cords cause the audio signal to be shorted. To

correct it, you must cut a wire inside the SMEA-1 or SMA1-LP-XX interface box. The

photos below show how the 3.5MM jacks are wired inside the interface. Remove the

four screws and cover of the interface. Then, locate the jack(s) and cut wire as shown

on the 3.5mm jack(s) below and your system should work. If you have any further

issues or questions, please call technical support at 505-888-3923

M-F 9:50 Mountain time.



3.5mm jack wire uncut 3.5mm jack wire cut



Ce manuel convient aux modèles suivants

Table des matières

Manuels Microphone populaires d'autres marques

IK Multimedia

IK Multimedia iRig Stream MIC PRO Manuel utilisateur

DAPAudio

DAPAudio RM-101 Manuel utilisateur

AKG

AKG CHM 21 Manuel utilisateur

Sennheiser

Sennheiser evolution wireless series EM 100 Manuel utilisateur

Sony

Sony C-48 Manuel utilisateur

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Manuel utilisateur

Shure

Shure WH30TQG Manuel utilisateur

auna PRO

auna PRO MIC-900 Manuel utilisateur

AKG

AKG D 3800 Manuel utilisateur

Shure

Shure KSM141 Manuel utilisateur

MAIIN SOUND

MAIIN SOUND IIN style Manuel utilisateur

Earthworks

Earthworks TC25 Manuel utilisateur

Sennheiser

Sennheiser evolution D1 Manuel utilisateur

Alesis

Alesis MicLink Wireless Manuel utilisateur

DSPPA

DSPPA D6234 Manuel utilisateur

Monacor

Monacor IMG STAGELINE ECM-300B Manuel utilisateur

Ansr Audio

Ansr Audio Scan16 Manuel utilisateur

Shure

Shure MXA710 Series Manuel utilisateur