OPERATING INSTRUCTIONS
1. Plug in the machine. Always check to ensure the plug has the ground prong
attached to prevent injury due to electric shock. Never remove the ground prong
from the plug.
2. We recommend the use of a liquid defoamer, to prevent the machine from
prematurely shutting off due to excess foam in the recovery tank. Turn on vacuum
and pour approximately ¼ cup of Esteam Liquid Defoamer into the end of the
vacuum hose.
NOTE: If the unit is equipped with a heater, two power cords are supplied. The
machine will need to be plugged into two different circuits to handle the combined
amperes. Your solution will be heated to approximately 2000F.
3. 150 PSI pump priming instructions: USING OPTIONAL PRIME HOSE
- Fill fresh water tank
- Attach prime hose to quick connect on machine
- Place the other end of prime hose into vacuum port and hold
- turn vacuum and pump switches on
- Once a continuous flow of water is being drain through the prime hose, this
indicates pump is primed
- Turn off vacuum and pump switches and disconnect prime hose
- Connect solution hose and vac hose to machine
- Turn vacuum and pump switches on
- Machine is ready to use.
TO USE YOUR E1715 OPTIONAL HEATER:
A) Hook the wand solution hose to the quick connect of your machine.
B) Plug the heater power cord into a wall outlet that is on a separate circuit from the
other cord.
C) Turn the heater switch on.
D) When the red light goes out, solution is heated and ready to use.
WARNING: If your heater does not work DO NOT attempt to repair it yourself, call
your distributor for repair procedures. Using solvents in heaters can be hazardous
and will void your warranty. Allowing heaters to freeze will crack the heater cartridge
and will also void your warranty.
DANGER: No solvents of any type may be used in this system at any time. The use
of solvents is extremely hazardous resulting in possible fire and/or explosion.
