4
Complete JETIBOX menu structure:
SAFETY INFORMATION
•Operate the SE4 always in dry environment and within the device limits stated in this guide. Never expose the
device to excessive heat or cold.
•Do not remove the heat shrink tube from the device and do not try to implement any changes or
modifications. This can lead to a total destruction and to the denial of any warranty claims.
•Always check the polarity of the connection. Never inverse the polarity –this could lead to total destruction.
•Always use a sufficient power source according to the consumption of the attached servos. Never exceed the
maximum allowed operating voltage of the attached servos.
•If you use analog servos please make sure that the servo output period is not below 15ms. Otherwise the
servos may behave unexpectedly.
FIRMWARE UPDATE
Firmware updates for the SE4 are transferred from a PC via the USB interface. The required programs and files are
available at www.espritmodel.com.
Install the MAV Manager software and the USB drivers on your computer. Check the system requirements.
1) Disconnect all servos from SE4.
2) Connect the USB interface to your PC, run MAV Manager and select the correct COM Port.
3) Connect the SE4 according to the picture below.
4) Select the correct *.BIN file and press the Update button.
WARRANTY
We grant a warranty of 24 months from the day of purchase under the assumption that they have been operated in
conformity with these instructions at recommended voltages and that they were not damaged mechanically.
Warranty and post warranty service is provided by the manufacturer.
