Trim slot to appropriate position in the stabilizer .
2x10mm
Glue the elevator to the stabilizer by CA and epoxy.
Assemble the stabilizer to fuselage and take
care to keep it cleanly.
Set the U-style wire through the enlargd hole as below.
2
1
Steel wire (0.5x3000mm)
U-style wire (3mm) Make sure hinges are
mounted in the same line.
Rudder
1mm
Tailing
edge
Make sure they are in
the right position while
installing.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
6
Pin hinge(24x24mm)
Apply instant type CA glue to elevator and pin hinge.
Keep some space about 1mm width between
elevator and tailing edge.
1
Stab joiner(12x270mm)
3mm
3mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
28
29
30
31
27
6
32
The sketch map when tail wheel assemble completion.
Metal arms
1
1
Screw (2x10mm)
Nut (2mm )
1
Copper ball (2mm )
Nut (2mm )
Screw (2x10mm)
Copper ball (2mm )
2mm
Trim the shaded section
Assemble the ball joint to the metal arms.
Epoxy the wooden block to the frame in the fuselage which
below the rudder for fixing the wire of rudder.
Collar
Tail landing gear
Collar
Collar
The sketch map when assemble the tail landing
gear to the wheel steeling mount.
2
Plastical tube(3x50mm)
1
Nose arm(3mm)
Collar (3mm) 3
1
1
Tail landing gear(3mm)
1
Metal wire for rudder
Tail wheel (45mm)
1
Retainer
Rod (2X300mm) 1
TP Screw(3x20mm)
Washer (3x6mm)
4
4
2
Steel wire (0.5x3000mm)
3
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x65mm)
2
Copper joiner
3
Pin hinge(2.5x48mm)
8
TP Screw (2.3x8mm) Ply (15x15x3mm) 8
Triangle wood plate
(50x10x10mm) 1
40mm
1.8mm
TP Screw(3x20mm)
Washer (3x6mm)
4
4
1
Wooden Block (6mm Ply)
Triangle wood plate
(50x10x10mm) 1
Wooden Block (6mm Ply)
Triangle wood plate
(50x10x10mm)
1
Wooden Block (6mm Ply)
Assemble the tail gear mount to the frame steadily
with TP screws as illustration below.
36
34
35
33
37
7
Accessory list for the coming installation steps.
